Providing and placing bunker beds for CISF Personnel and erecting Gypsum partitions including execution of other civil works in hall no.6 mezzanine floor and ATM Area near hall no 14, Bharat Mandapam

Providing and fixing partition upto ceiling height consisting of G.I. frame and required board, including providing and fixing of frame work made of special section power pressed/ roll form G.I. sheet with zinc coating of 120 gms/sqm(both side inclusive), consisting of floor and ceiling channel 50 mm wide having equal flanges of 32 mm and 0.50 mm thick, fixed to the floor and ceiling at the spacing of 610 mm centre to centre with dash fastener of 12.5 mm dia meter 50 mm length or suitable anchor fastener or metal screws with nylon plugs and the studs 48 mm wide having one flange of 34 mm and other flange 36 mm and 0.50 mm thick fixed vertically within flanges of floor and ceiling channel and placed at a spacing of 610 mm centre to centre by 6 mm dia bolts and nuts, including fixing of studs along both ends of partition fixed flush to wall with suitable anchor fastener or metal screws with nylon plugs at spacing of 450 mm centre to centre, and fixing of boards to both side of frame work by 25 mm long dry wall screws on studs, floor and ceiling channels at the spacing of 300 mm centre to centre. The boards are to be fixed to the frame work with joints staggered to avoid through cracks, M.S. fixing channel of 99 mm width (0.9 mm thick having two flanges of 9.5 mm each) to be provided at the horizontal joints of two boards, fixed to the studs using metal to metal flat head screws, including jointing and finishing to a flush finish with recommended jointing compound, jointing tape, angle beads at corners (25 mm x 25 mm x 0.5 mm), joint finisher and two coats of primer suitable for board as per manufacture’s specification and direction of engineer in charge all complete. 75 mm overall thickness partition with 12.5 mm thick double skin fire rated Glass Reinforced Gypsum (GRG) plaster board conforming to IS: 2095: part 3 (Board with BIS certification marks)

Providing and applying white cement based putty of average thickness 1 mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete.

Distempering with 1st quality acrylic distemper (ready mixed) having VOC content less than 50 gram/litre, of approved manufacturer and of required shade and colour all complete to achieve even shade and colour : New work (two or more coats) over and including water thinnable priming coat with cement primer having VOC content less than 50 gram/litre

Khanger Filling i/c compaction and transportation all complete

Providing and fixing 12 mm thick frameless toughened glass door shutter of approved brand and manufacture , including providing and fixing top & bottom pivot double acting hydraulic floor spring type fixing arrangement and making necessary holes etc, for fixing required door fiiting , all complete as per direction of Engineer-in-charge (Door handle , lock and stopper etc. to be paid separately)

Providing and placing double-storey bunk bed fabricated from MS rectangular tube of size 50×25 mm (minimum 18-gauge thickness) for all frame members, having overall dimensions 2130 mm × 915 mm, with 460 mm clear height of lower bed from finished floor level and minimum 1065 mm clear vertical space between top of lower bed and bottom of upper bed, fitted with MS 5 mm dia Saria Jali (mesh base) for both tiers, including all welding, grinding, surface preparation and powder-coating in approved shade, complete with ladder, guard rails and all necessary accessories, as per direction of Engineer-in-Charge.

Providing and fixing brass bib cock of approved quality : 15 mm nominal bore