Construction of 5.00 LL Sump. Motor Room and Erection of 15 HP Open well Submersible Motor, panel board and Electrical Items and Laying of 110mm dia HDPE pipe line works for Water Supply at Ward No. 44 Karnnor in Hosur City Municipal Corporation

Amount

Earth work excavation for foundation in Hard stiff clay, stiff black cotton, hard red earth, shales murram, gravel,stoney earth and earth mixed with small size boulders SS.20B and Sand, silt or other loose soil, wet sand,or silt not under water, light black cotton soil, sandy loam ordinary soil and to full depth as may be directed except in hardrock requiring blasting inclusive of shoring shuttering and baling out water and cleaning and levelling the site etc.,Earth Work for Footing 1st Depth

Plain Cement Concrete 1:5:10 (one cement, five fine aggregates and ten coarse aggregates) using 40mm size ISS HBG metal including cost and conveyance of all materials to site and including for the mixing, laying and labour charges etc., complete as per standard specification

Centering for soffits of RCC slabs of plane surface like lintels, beams ,etc.,including strutting 3m high using mild steel sheets of size 90cm X 60cm X and B.G 10 stiffened with M.S angles of size 25mm X 25mm X 3mm laid over silver Oak (C.W) joists of size 10cm X 6.5cm (spaced at about 90cm c/c )and supported dy casurina props of 10cm to 13cm dia (spaced of 75cm C/C) complying with standard specification and directed Centering for sump wall

Centering for soffits of Column Box

Centering for soffits of Roof Beam

Centering for soffits of Roof Slab

Providing and laying in position Standardised Concrete Mix M-25 Grade in accordance with IS 456 - 2000 using 20mm and down graded hard broken granite stone jelly for all RCC items of works with minimum cement contenet of 350Kg/ cum and maximum water cement ratio of 0.50 including admixture (Plasticiser / super plasticiser) in recommended proportions as per IS 9103 to accelerate, related setting of concrete, improve workability without imparing strength and durability with about (5.0cum), 7730Kg of 20mm machine crushed stone jelly and with about (3.3 cum), 5156kg of 10 - 12mm machine crushed stone jelly and with about (4.79cum) 7670 kg of sand, but excluding cost of reinforcement grill and fabricating charges centering and shuttering but including laying, vibrating with mechanical vibrators, finishing, curing, etc and providing fixtures like fan clamps in the RCC floor / roof slabs wherever necessary without claiming extra cost etc., complete complying with standard specification and as directed by the departmental officers - The Coarse and Fine aggregates to be used should comply with the requiremnents of IS staandards. (No separate payment will be made by the Department for the excess usage of materials) for Basement

Providing and laying in position Standardised Concrete Mix M-25 Grade in accordance with IS 456 - 2000 using 20mm and down graded hard broken granite stone jelly for all RCC items of works with minimum cement contenet of 350Kg/ cum and maximum water cement ratio of 0.50 including admixture for Ground Floor

Suppling and fabricating and placing in position MS (or) R.T.S. bar for reinforcement to all RCC works as per the design given including cost of steel and binding wire also in all floors

Brick work in CM 1:5 (one cement & five M sand) using II class ground moulded bricks of size 9"X43/8"X 2 3/4" including finishing, curing, etc., complete complying with standard specification for Ground Floor

Plastering with cement mortar (1:5) 12mm ,thick in all floors including cost and conveyance of all materilas to site and labour charges etc,complete as per standard specifications (S.I.306)

Plastering with cement mortar (1:3) 10mm ,thick in all floors including cost and conveyance of all materilas to site and labour charges etc,complete as per standard specifications (S.I.306)

Supply and fixing of M.S Grills for Doors and Windows with one coat of Red oxide with Primer including all costs such as welding,grinding and fabrication charges, cost and conveyance of all materials to site etc,complete as per standard specification.

Painting two coats with ready mixed Plastic Emulsion Paint approved quality and colour over a priming coat, including thorough scrapping, clean removal of dirt, etc complete and including necessary plaster of paris, putty, wherever required etc, complete as per standard specification.

Painting two coats with Ready Mixed Enamel Paint over the new iron works of approved quality and colour without priming coat including the cost all materials etc,complete as per standard specification., in all floors.

Supplying and fixing in position C.I.Manhole covers (light or heavy duty) of 1.00 X 1.00cm in size in Cement Mortar 1:3 (One part of Cement and Three part of Plastering Sand (P- Sand)), of best approved quality and as per standard specifications etc.,complete.

Wiring with 2 x 1.5 sq.mm. (22 / 0.3) PVC insulated SC unsheathed copper conductor of 1100V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessories in flush with wall with 3mm thick hylum sheet cover with TW switch box and 5A FT switch with continuous earth wire connection of 14 SWG TC wire for making good of the concealed portion with suitable colour for PVC concealed light point / fan point (for electronic regulator) SD 23

Wiring with 2 x 1.5 sq.mm. (22 / 0.3) PVC insulated SC unsheathed copper conductor of 1100V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessories in flush with wall with 150mm x 100mm x 113mm TW switch box with 3mm thick hylem sheet cover for 5A 3 pin non inter locking wall socket with 5A flush type switch with continuous earth wire connection of 14 SWG TC wire and making good of the concealed portion with suitable colour for concealed PVC plug point plug point. SD 38

Wiring with 2 x 4 sq.mm. (56 / 0.3) PVC insulated SC unsheathed copper conductor cable of 1100V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessories in flush with wall with 150mm x 100mm x 113mm TW switch box with 3mm thick hylem sheet for 15A 3 pin non inter locking wall socket with 15A flush type switch with continuous earth wire connection of 14 SWG TC wire and making good of the concealed portion with suitable colour for concealed power plug point SD 40

Supply and Fixing of 20 W LED Tubelight for T8 Fitting Single side (15- e)

Supplying and fixing 15W LED Light including cost of all materials,labour, lead, lift, etc complete

Supply and fixing of 1200mm (48") AC ceiling fan complete with stepped electronic 300W regulator with 300mm down rod on the existing clamp

Towards Charges for Writing and lettering for Name Board with Enamel Paint Works including all Charges etc.., Complete as per Standard Specifications

supply and fixing of 30W LED street light fitting with LED (Higher end) with 25 mm dia. GI pipe (class B) with 1 no. 25 mm GI bend complete on the existing post/ on wall with PVC unsheathed copper leads with MS clamps and with painting .SD 532

Providing & fixing PVC RAIN WATER DOWNFALL PIPE of the following dia with necessary T.W.Clamps Plugs, Shoes,Bemds, other clamps, screws nails etc.,complete complying with standard specification. The rate is inclusive of cost of removable iron gratings of appropriate size. The size of Teak Wood plugs used is 150X25mm in front & 200x75mm in rear (wall side) with a depth of 110mm. The pipe is to be fixed by means of "U" clamps at the centre of pipes to be fixed.110mm dia PVC Pipe [4 Kg/SqCm]

Supply and delivery of Open well Submersible pump set conforming to IS 14220 /2002 and as amended thereafter and BEE 3 Star Rated capable of discharging the following duties due to all causes. The pump shall be with stainless steel shaft and dynamically balanced bronze mixed type impeller, CI FG 200 grade casing and brass screws and rotor shall be of copper rod as per IS 613/1984 with ISI mark. The pump suitable for installation in sump with 1.1KVgrade 3 core suitable copper flat submersible cable to a length of 15m with necessary cable joints. The non return valve located at the top of the pump in the discharge outlet connection is to be designed with minimum friction. The pump should be directly coupled to 2880 RPM, three phase, 50 Hz (±5), 415V+6% & 415V-15% squirrel cage induction motor suitable for DOL upto 5 HP, Fully Automatic Air break Star Delta up to 20 HP and Auto Transformer starter for above 20 HP starting and for continuous operation. (For 15 Hp Openwell motor 1000 x 40 lpm x m)

Supply of 63 Amps Porcelain fuse unit (500 V)of best quality make including cost of handling charges and all other incidental charges.

Supply of 63 A TPN switch disconnnector fuse units in sheet steel enclosure with HRC fuses Double break with ISI make including cost of handling charges and all other incidental charges.

Supply of 40 Amps 30MA RCCB/ELCB (Four Pole) switch with ISI make including cost of handling charges and all other incidental charges.

Supply of 10 sqmm Pvc Insulated Single Core Multi Strand Fire Reterdant Flexible Copper Cable. with ISI Mark Conforming to IS 6 Sqmm Copper wire of best quality make including cost of handling charges and all other incidental charges.

Supply of 3 core 6 sqmm Jointing of XLPE Insulated and Sheated 3 Core Flat Type Copper Cable Conforming to IS 694/1990 and as amended Thereafter with ISI make including cost of handling charges and all other incidental charges.

Supply of 4 core 16sqmm JOINTING OF L.T. CABLES- 3,3.5,4 CORE 1.1 KV GRADE ARMOURED ALUMINIUM CONDUCTOR CABLE CONFORMING TO IS 1554 PART I AND AS AMENDED THEREAFTER WITH ISI MARKING with ISI make including cost of handling charges and all other incidental charges.

Supply of 65mm UPVC Column pipe Supreme Heavy with ISI make including cost of handling charges and all other incidental charges.

Supply of 2" GI Bend with ISI make including cost of handling charges and all other incidental charges.

Supply of 2" X 36" pipe nipple with ISI make including cost of handling charges and all other incidental charges.

Supply of 2" GI Flange Set with ISI make including cost of handling charges and all other incidental charges.

Supply of 2"GM Non return valve with ISI make including cost of handling charges and all other incidental charges.

Supply of 2"G I Ordinary Coller with ISI make including cost of handling charges and all other incidental charges.

Supplying and Delivery of the following sizes of HDPE Pipes PE-100 - PN8 conforming to IS-4984/1995, as specified to technical specifications in standard length including labour charges for loading, un-loading and staging at stock yard etc.., complete as per standard specification as directed by the Department Officers. 110mm HDPE Pipe

Earth work excavation and deposition on the bank with an initial lead and lift of 10 meters and initial lift of 2 meters in hard stiffy clay stiff black cotton hard red earth murram, gravelly soils(SS20B) etc., complete as per std., specification. 110mm HDPE Pipe

Lowering the following HDPE pipes and specials into trench and laying to proper grade and alignment complete as per standard specification by deparment officers etc.., HDPE Pipe 110mm

Jointing the HDPE pipes and specials and testing the required pressure with water etc.., Complete as per standard specification HDPE Pipe 110mm

Testing of pipes for water supply with hudralic testing equipments by filling with water including cost of water @ 60/KL and testing to recommended Pressure in convenient stretches and attending the brusts if any occurred during the test excluding the cost of pipes but including other incidential and operational charges ETC... complete for the following diameteres of pipes HDPE Pipe 110mm

Labour charges for the erection of submersible pumpset in borewell/openwell including fixing and jointing submersible cable with proper clamps upto the starter to required depth and also fixing of riser pipes to the required depth valves erection clamps, pressure gauges upto the exterior wall of pump room and erection of panel board consisting of TPICN switches starter, Voltmeter, Ammeter, three pilot (indicating) lamps capacitor single phasing preventor, water level guard and laying and jointing the cables and twin earthing as per IE rules etc., complete and testing the pumpset and trail run for 10 days.

Refilling the excavated earth in to the trenches after laying the P.V.C. pipe in to the trench including cost of all labour charges and all other incidental charges etc., complete. HDPE Pipe 110mm

Supply and Fixing of wooden board including cost of material labour charges and all other incidental charges etc., complete as per standard specification

Supply of 6 sqmm Pvc Insulated Single Core Multi StrandFire Reterdant Flexible Copper Cable. with ISI Mark Conforming to IS 6 Sqmm Copper wire of best quality make including cost of handling charges and all other incidental charges.

Supply of 2" dia Bore clamp, cover and water proof compound etc., complete including cost of handling charges and all other incidental charges etc, complete as per standard specification

Supply of 2" dia , SS Adapter complete including cost of handling charges and all other incidental charges etc, complete as per standard specification

Supply of 2" x 6" dia , pipe nipple complete including cost of handling charges and all other incidental charges etc, complete as per standard specification

Supply of 2" x 12" dia , pipe nipple complete including cost of handling charges and all other incidental charges etc, complete as per standard specification

Supplying and Delivery of the following sizes of HDPE Pipes specials PE-100 - PN10 conforming to IS standard technical specifications in standard size including labour charges for loading, un-loading and staging at stock yard etc.., complete as per standard specification as directed by the Department Officers. 90 mm HDPE stup bend

90 mm HDPE Elbow

90 mm HDPE Flange set

110 mm HDPE stup bend

110 mm HDPE Flange set

110 mm HDPE Elbow

110 mm HDPE Tee

110 x 90 mm HDPE Reducer

90 mm PVC Ball Valve

90 mm HDPE Tee

90 x 75 mm HDPE Reducer

2" x 3" HDPE Reducer

Supply delivery and fixing od CI D/F Reflux Valve (Sluice valve) as per I.S 5312/2004/ Part 1/ 84 PN 1.0 with Byepass arrangements with ISI ,marking and with 5 Years Warrenty 100 mm Dia Valve

Supply delivery and fixing of 100 mm dia CI Double Air valve as per I.S.I 14845/2000 and with 5 Years Warrenty

SEENAPPA BASKAR (BID ID -1507391)