REPAIR MAINTENANCE OF SEWAGE UNDER GE EAST AGRA

Amount

M&L for in replacement of TWIN LOBE BLOWER UNIT of capacity 180 Cum at 0.6 kg /square cm Minimum working pressure complete with electric motor of cap 12.5 HP, 415 volt AC electric supply complete all as specified and directed Make Everest/Akash/AIRVAC

M & L for replacement of MBBR for STP capacity 350 KLD/day Make - NITASA or equavalant complete all as specified and directed

M & L for replacement for tube settler media Make -NITASA or equavalant complete all as specified and directed

Supply and fixing in replacement Air flow meter /Air Rota meter make- Eureka or equivalent make complete all as specified and directed

Supply and installation of dozing pump for chlorination of suitable capacity 0.25 HP , 1440 RPM, Single Phase 10 ltrs/hr at 3.5/4.0 Kg pressure complete with Solution preparation cum setling tank -170 and service tank 100 Ltrs capacity 3 layer including all plumbing work with all fitting/valve etc complete all as specified and directed

All as per item No 5 above but capacity 6 ltrs/hr for tube setlar complete all as specified and directed

Supply and fixing in replacent Air grid Stainless steel for Feb Reactor A and B complete with testing including taking down of existing pipes complete all as specified and directed.

M&L for Hypochlorine solution strength 10% in plastic barrels of capacity 200/210 ltrs for chlorination at STP installations all as specified and directed

Taking out Sluice/non return valves 100 mm bore complete all as specified and directed

S & F in replacement of non return valve of size 100 mm flanged type confirming to IS 5312 duly ISI marked complete with jointing material all as specified and directed Make-RMCO/ Leader/BIR/Upadhyay

S & F in replacement of sluice valve of 100 mm bore cast iron body class PN-1.6 with flanged with high tensile brass spindle ISI marked confirming to IS-780 complete with jointing material all as specified and directed Make- RMCO/Leader/BIR/Upadhyay

M & L for rewinding VT pump non clogging sumersible/centrifugal pump motor 3 phase, 415 volts with supper enamelled copper winding wire of suitable guage & quantity including insulating materials etc including replacement of suitable size bearings and dismentling and refixing,testing complete of capacity 12.5 HP to 15 HP

S & F 100 mm bore GI pipe flanged type Medium grade complete with all jointing nterial including taking down old U/S pipe complete as specified and directed make- TATA/Jindal

Supply & laying MS ERW pipe 50 mm bore complete with MS fittings and welding work if required Make- TATA/Jindal/PRAKSH/Surya

Description all as per item No 14 above but 65 mm bore

Description all as per item No 14 above but 80 mm bore

Description all as per item No 14 above but 100 mm bore

S & F MCCB 4 Pole, 415 V, Adjustable thermal and fixed magnetic setting, 200 Amps with breaking capacity 36 KA complete as specified and directed make- Cat Pt No -IHLLSEBF0200 # of Havells or equavalant in L&T / Schineider /C&S

All as per item No 18 above but 160 Amps make- Cat Pt No - IHA13EBF0160# of Havells or equavalant in L&T / Schineider /C&S

Supply & Replacement to Air grid HDPE pipe of existing size (80 mm bore) approx 30 mtrs for equalization tank complete with testing complete all as specified and directed Make: Supreme/Reliance/Finolex

Supply & fixing butter fly valve( flanged ) of 50 mm bore pipe line including taking down of existing valves complete all as specified and directed Make-RMCO/ Leader/BIR/Upadhyay

Ditto- all as per item No 21.00 above but 65 mm bore

Ditto- all as per item No 21.00 above but 80 mm bore

Ditto- all as per item No 21.00 above but 100 mm bore

M & L for cleaning throughly to the inner side of slot of wornout motort & rewinding of wornout winding wire of motor of cap 3 HP, 3 phase, 415 volts of mono block pump set with PVC coated insulating copper winding wire of same guage as original complete including other insulating material and replacement of bearings,bush and shaft seal, impeller etc and re assembling, connecting and testing at full load complete all as specified and directed Note: Defective/wornout part which are need tobe replaced shall be measured and paid separately as supply only in their respective item. Labour for fixing of defective part shall be deemed to be included in quoted rate of this item

Supply only stainless steel bearing

Supply only stainless steel bearing sleeves

Supply only stainless steel half cooupling

Supply only Cerclip

Supply only gun metal impellers

Supply only Coupling Key

M & L for lifting and rewinding of wornout submersible motor of cap 7.5 HP, 3 phase, 415 volts with insulating copper winding wire of same guage as original complete including other insulating material and replacement of bearings etc and lowering the same, connecting and testing at full load complete all as specified and directed

M & L Earthing complete with galvanised earth plate electrode 60cm x 60cm x 6 mm burried directly in ground vertically to a depth of not less than 2.25 mtr below ground level with top edge of earth plate not less than 1.5 mtr below ground level connected to earth lead GI 4.00 mm dia by means of nut, bolts and washers made out of galvanised iron or steel, earth lead protected by galvanised iron pipe 15 mm bore "light grade" and connected to main switch board of main control panel as directed and as specified including concrete pit in PCC (1:3:6) type C1 pre-cast cover PCC cover slab 5 cm thick of size as shoawn reinforced with 8 mm dia TMT/deformed bar 100 mm c/c both ways including one handle made of 12 mm MS bar, funnel wire mesh 20 mm bore galvanised iron pipe medium grade to watering charcoal and salt in alternative layers including necessary earth work complete all as shown in elect plate No 3 of SSR Part I complete all as specified and directed

All as per item No 27.00 above but with earth lead GI Strip 32x6mm by means of nut, bolts and washers made out of galvanised iron or steel, earth lead protected by galvanised iron pipe 40 mm dia "light grade" complete all as specified and directed

M & L of dewatering, desludging and cleaning of wet and dry sewage from sumps (outer and inner) of well upto bottom of sump by any method (manually or mechanically) closing of all inlets of sumps and pumping out from near by manholes water and opening all intel after necessary cleaning work of sump well including flushing out the inlet pipes (suction) of the pumping sets installed there sludge be disposed off out of defence land at the following location complete all as specified and directed :-

Sewage well Gwalior Road near 509 ABW sinking dia 11.5 mtr and depth 7.50 mtr approx below ground level

Sewage Collection Chamber of size 5.0x5.0x 11.5 mtr depth approx below ground level at ODF and KV Line STP plant

M & L for taking out unserviceable VT/Submersible pump set from collection chamber and rewinding VT pump non clogging sumersible/centrifugal pump motor 3 phase, 415 volts with supper enamelled copper winding wire of suitable guage & quantity including insulating materials etc including replacement of suitable size bearings and dismentling and refixing,testing complete of capacity 3 HP to 5 HP

M& L for Motor starters in replacement Heavy duty autometic star delta starter in SS enclosure 4 pole contractor type TC1-DX with wide band operating coil overload relay type LR1D protection & electronic Star Delta Timer suitable for 15.0HP/11.0 kw Cat Part No BE3-DXP204-316X relay 9-14 Amps, Make C&S or equivalent in Havells/L&T

M& L for Motor starters in replacement Heavy duty autometic star delta starter in SS enclosure 4 pole contractor type TC1-DX with wide band operating coil overload relay type LR1D protection & electronic Star Delta Timer suitable for 5.0/7.5/12.00 HP, 9.0KW Cat Part No BE3-DXP204-314 relay 7-10 Amps, Make C&S or equivalent in Havells/L&T

M& L for Motor starters in replacement Heavy duty autometic star delta starter in SS enclosure 4 pole contractor type TC1-DX with wide band operating coil overload relay type LR1D protection & electronic Star Delta Timer suitable for 15/120/25HP, 18KW Cat Part No BE3-DXP254-322 relay 18-25 Amps, Make C&S or equivalent in Havells/L&T

M& L for Motor starters in replacement Heavy duty DOL starter type DX-P with robust 4 pole contractor & type LR1D OLR in SS enclosure suitable for 3.0 -7.5 HP, 5.5KW Cat Part No BE1-DXP204-316X relay upto 9-14 Amps, Make C&S or equivalent in Havells/L&T

Clear ion Experts Pvt Ltd

m/s het singh sharma const co.

M/S SUMESH FURNITURE