Construction of CC Road from Binod Gurung house towards Gurung Gumpa

Dressing and chilchalling Road flanks including cutting and filling with earth up to 150 mm average thickness finished with outward cross-grade of 1 in 30.

Earth work in excavation of foundation of structures as per drawing and technical specification,including setting out, removing, spreading orstacking of spoils within a lead of 150 m. as directed and including trimming the sides of the trenches,leveling, dressing and ramming the bottom, and backfilling with approved material complete as per direction of the Engineer-in-Charge (iv) Without pumping out water and shoring

Hand Packed rough dressed stone walls by masons with hard stones from approved quarries including all carriage of materials to site

(A) Labour for laying 150 mm to 200 mm boulder soling including rough dressing hand packing and ramming down small pieces in the interstics without rolling but including ramming and preparing the bed to proper level and filling up all joints with sandy clay or earth.

(A)Labour for laying stone edging with departmental stone materials laid to correct line and level including carriage of departmental stone aterials within a lead of 150 metres cutting necessary trench in soil or in hard metalled surface, laying the stones and repacking the trench on both sides of the edging with spoils and ramming the same thoroughly (b) 100 mm wide and 250 mm deep edging with stone sets laid-on-edge.

(B) Cost of Boulders

Providing and laying Design Mix concrete for plain / reinforced concrete work in any part of bridge (excluding bottom plugging) with coarse aggregates of appropriate nominal size and grading, fine aggregate (sand) conforming to proper grading zone, both of approved quality and cement, as necessary, including labour, cost and carriage of all materials and including preparation design mix, approval of the same by the Engineer-in-Charge and cost for quality control, sampling, testing etc. all complete but excluding cost of labour and materials for formwork & reinforcement works and staging complete as per drawing and technical specifications. (D) M-20 Grade Using concrete mixer

Plain / Reinforced Cement Concrete in Sub structure with coarse aggregates of appropriate nominal size and grading, fine aggregate (sand) conforming to proper grading zone, both of approved quality, cement and water reducing admixtures, as necessary, including labour, cost and carriage of all materials and including preparation of design mix, approval of the same by the Engineer-in-Charge and cost for quality control, sampling, testing etc. all complete as per drawing and technical specification including the cost of necessary form work and staging complete as per drawing and technical specifications. (D) M-20 Grade Using concrete mixer.

Hire and labour charges for Shuttering with or without staging upto 4.0 m height using approved stout props with wooden planks/ply wood/steel sheet plate with required bracing for any kind of plain or reinforced concrete works in all sorts of minor structure including culvert, box culvert, cross drain etc. The rate is inclusive of fitting, fixing and striking out after completion of work as per specification and direction.

Plaster to (wall floor ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and racking out joints including throating, nosing and drip course scaffolding /staging, where necessary (Ground floor). Excluding cost of chipping over concrete surface. (ii) With 1:6 Cement Mortar (a) 20 mm thick plaster

Neat cement punning about 1.50mm thick in wall ,dado,window sill,floor etc.

Supplying fitting fixing Name Plate of white marbel stone of size 300mmx450mm including photograph of the work(pre,during and post)execution each 2 copies,etc all complete as per the direction of Engineer in Charge.

Add 18% GST

Add 1% Cess