AMRUT 2.0 Park

Amount

Earth work excavation for foundation in Hard stiff clay, stiff black cotton, hard red earth, shales murram,gravel,stoney earth and earth mixed with small size boulders SS.20B in ordinary soil and to full depth as may be directed except in hardrock requiring blasting inclusive of shoring and baling out water wherever necessary refilling the sides of foundation with excavated soil other than sand in layers of 15cm thick well rammed and completed depositing the surplus excavated soil with in the compound in places shown by the departmental officers with intial lead and lifts and cleaning and levelling the site etc.,complete with standard specification

Plain Cement concrete 1:4:8 (one cement, four sand, eight aggregate) using 40mm gauge hand broken granite stone jelly for foundation including dewatering if found necessary and laid in layers of not more than 15 cm thick and compacted,etc., complete complying with standard specfication.

Centering for soffits of RCC slabs of plane surface like lintels, beams ,etc.,including strutting 3m high using mild steel sheets of size 90cm X 60cm X 10cm and B.G 10 stiffened with M.S angles of size 25mm X 25mm X 3mm laid over silver Oak (C.W) joists of size 10cm X 6.5cm (spaced at about 90cm c/c )and supported dy casurina props of 10cm to 13cm dia (spaced of 75cm C/C) complying with standard specification and directed (SI 154-A)

Footing,Grade & Plinth Beam

Columns

Reinforced Cement Concrete 1:1½:3 Mix (One part cement, one and half part M.Sand and three part of aggregate)using 20mm size ISS HBG metal machine crushed from approved quarry including cost and conveyance of all materials to site, loading and unloading charges and labour charges for mixing, laying and curing but excluding cost of reinforcement etc. Complete with std. Specifications.(Using Vibrator) TNDSS NO: 30 V, VI (S3), VII-3.

Suppling and fabricating and placing in position MS (or) R.T.S. bar for reinforcement to all RCC works as per the design given including cost of steel and binding wire also in all floors.

Brick work in following Cement Mortar using best quality of Country Bricks of size 8-3/4" x 4-1/4" x 2-3/4" for foundation and basement including curing, etc., complete complying with standard specifiction.

Plastering with cement mortar 1:5 (One cement and five sand) ,12 mm ,thick in all floors including cost and conveyance of all materials to site etc,complete as per standard specifications

Painting two coats of newly plastered wall surface with ready mixed plastic emulsion paint of first class quality and of approved colour over a priming coat including thorough scrapping, clean removal of dirt, and including necessary plaster of paris putty, wherever required etc., complete complying with standard specification.

Supplying and fixing of M.S grill of approved design for doors, windows and ventilators using necessary mild steel flats for inner and outer memebers which should be fixed to window frames inclusive of priming coat of best approved quality red oxide primer etc., complete complying with standard specifications.

Painting Two Coats on new Iron works with best synthetic enamel paint of approved colour and quality – 10m2.

Earth work excavation for foundation in Hard stiff clay, stiff black cotton, hard red earth, shales murram,gravel,stoney earth and earth mixed with small size boulders SS.20B in ordinary soil and to full depth as may be directed except in hardrock requiring blasting inclusive of shoring and baling out water wherever necessary refilling the sides of foundation with excavated soil other than sand in layers of 15cm thick well rammed and completed depositing the surplus excavated soil with in the compound in places shown by the departmental officers with intial lead and lifts and cleaning and levelling the site etc.,complete with standard specification

kerb wall

Centering for soffits of RCC slabs of plane surface like lintels, beams ,etc.,including strutting 3m high using mild steel sheets of size 90cm X 60cm X 10cm and B.G 10 stiffened with M.S angles of size 25mm X 25mm X 3mm laid over silver Oak (C.W) joists of size 10cm X 6.5cm (spaced at about 90cm c/c )and supported dy casurina props of 10cm to 13cm dia (spaced of 75cm C/C) complying with standard specification and directed (SI 154-A)

Plain Cement Concrete 1:2:4 (one cement, two fine aggregates and four coarse aggregates) using 20mm size ISS HBG metal including cost and conveyance of all materials to site and including for the mixing, laying and labour charges etc., complete as per standard specification

Providing and laying, spreading and compacting graded stone aggregate to Wet mix macadam (WMM) specification including premixing the material with water at OMC in mechanical mix plant carriage to mixed material by tipper to site laying in uniform layers with paver in sub base / base course on well prepared surface and compacting with vibratory roller to achive the desired density complete as per clasue 406 of MORTH specifications.

Supplying and laying Precast Designer Paver Block confirming to IS 1568-2006 specification manufacturing and laying standard of M50 grade 80mm thick (table clauses 5 and 9.14) suitable for bus terminals industrial complexes road on expensive soils etc., including the cost of paver block of size 225mm x 12.50 mm x 80mm and conveyance of materials to work site mentioned in the tender schedule cost of loading and unloading handling during over Stone dust of 100mm thick (excluding the cost of M- Sand) conveyance paver block cutter to site and hire charges of vibrators and block cutter operator and labour for leveling the M- Sand to paver block etc., complete ISI 15658-2006.

Supplying and Planting of Neem tree sapling, Punjai, Naval trees planting, including loading and unloading charges, transportation, stacking of saplings at site, earth work excavation of required size, planting of sapling, refilling of excavated earth etc as directed by the site in-charge.(PD-1166)

Investigation charges for Geophysical survey for locating the bore well including cost of all labour charges etc., complete as per standard specification.

Drilling 150mm deep vertical bore well in all clause of soils /hard rock area including all transportation charges of rigid and labour charges etc complete

Supply and delivery of 180m PVC casing pipe including cost and conveyance of all meterials to site etc complete

Wiring with 2x1.50 Sqmm (22/0.3) PVC insulated SC unsheathed Cu. Conductor of 1100 V Grade in suitable PV C rigid pipe on wall and ceiling with PVC accessories and with TW switch box and 5A F.T. Switch with painting of suitable colourful Open PV C light

Wiring with 2x1.50 Sqmm (22/0.3) PVC insulated unsheathed Cu. Conductor of 1100 V Grade in suitable PV C rigid pipe on wall and ceiling with PVC accessories with 150 x 100 x 113mm TW switch box for 5A 3 pin non inter locking CS Plug with painting of suita

Supply and fixing of 16 Amps DP Switch metal clad of 500 V with fuse and neutral (Side Handle) on suitable TW Box PWD Earthing SD-141

Supply and Delivery of 1.00HP wet type submersible pump set 50lpmX40m head, confirming to IS 8034/89 with ISI marking along with 2.5 sq mm. cable (to 5m lengh) suitable for installation in 150 mm dia bore including Transportation charges etc., complete

Supply and delivery of 1.00 HP panel board suitable for above pump set with all accessories as per IE rules with Is specifation ect., complete

Supply anddelivery of 50mm HDPE hose including cost and conveyance of all materials to site and all labour charges etc.,

Supply and delivery of 2.50 sqmm Copper Cable including cost and conveyance of all materials to site and all labour charges etc.,

Supplying and fixing of 1'' Dia G.I. Service pipe including cost and conveyance of all materials to site and all labour charges etc.,

Supply and fixing of 32 Amps fuse carrier including cost and conveyance of all materials to site and all labour charges etc.,

Supply and fixing of 18Watts Power saver light fitting including cost and conveyance of all materials to site and all labour charges etc.,

Supply and delivery of 1000 litres HDPE Tank including cost and conveyance of all labour charges etc, complete

Supply and run of 3 of 4 Sqmm (56/0.3) PVC insulated SC unsheathed Cu. Conductor of 1100V and grade in suitable heavy gauge M.S. Conduit pipe on wall and ceiling with continued earth wire connection of 14 SWG TC wirewith painting of suitable colour.SD-47

Labour charges for erection of 1.0 HP Submersible motor including cost of all charges etc, complete

Supply and fixng of TNEB meter board suitable for 3 phase 100A service connection made up of suitable angle iron frame work of size 2 feet x 1-1/2 feet using angle iron of size 1-1/2" x 1-1/2" x 1/4" rigidly fixed on wall covered with hylem sheet of size 2 feet x 1-1/2 feet of 12mm thickness with necessary bolts and nuts supports and supply and fixing of 3 Nos. 100A fuse units (500V), 1 No. neutral link, copper earth flat of size 1" x 1/4" with inter connection of EB meter to fuse units by 16 Sq.mm PVC insulated copper wire with earth connection complete (SD-130)

Earthing as per the ISI specification with an earth electrode of 2.10 metre Class 'B' GI pipe of dia not less than 40mm with copper earth plate of size 125mm x 50mm x 6mm with necessary funneling arrangements with necessary masonry work and with 38mm RCC cover slab for the brick masonry (SD-233)

Supplying and fixing of 6 Metre Length Single Bracket Pole with Base Plate (250 x 250 x 6mm) 76.10mm OD x 3.65mm Thick x 6000mm Length (PWD SOR PAGE. 148)

Supplying and fixing of SINGLE PHASE DISTRIBUTION BOARD 4 ways single phase DB No. of ways incomer MCB / Isolator - 2 No. of ways incomer ELCB / RCD - 2 No. of outgoings ways - 2 (PWD SOR PAGE. 139)

Supply and laying of 2 x 6 sq.mm PVC LTUG aluminium armoured cable in a trench to be excavated at a depth of 0.75 metre putting 0.15 metre layer of sand and covering the cable completely with bricks and sand and refilling the earth to make good (SD-197)

Supply and delivery of MS Kiosk of size 0.75m x 0.45m x 0.75m made up of MS angle of size 50mm x 50mmx 4mm alround covered with 16 gauge MS sheet and kiosk door made up of MS plates of size 25 mm x 3 mm including cutting, welding, grinding, locking arrangements and labour charges etc., TWAD SOR P.NO. 85

Supplying and fixing of 30W LED Street light fitting with LED outdoor fittings Higher end philips/havells/Equivalent etc complete. Pwd sor page 115

Plain Cement Concrete 1:3:6 Mix (one part cement, three part sand and six part of aggrigate) using 20 mm size ISS HBG metal from approved quarry including cost and conveyance of all materials to site. Loading and unloading charges and labour charges fo

Ceiling platering with cement mortar 1:3 (One cement three sand) mix, 10mm thick and including cost and conveyance of all materials to site and all labour charges etc., complete as per standard specification

Plastering with cement mortar 1:5 (one cement five sand) mix, 20 mm thick and including cost and conveyance of all materials to site and all labour charges etc., complete as per standard specification

Supplying and fixing of new ceramic tiles for flooring with good quality and colour with cement mortar 1:3 mix and pointing with white cement with same color pigments including all cost of materials to site and all labour charges etc., complete

Supplying and fixing of Indian type water closet of 50mm size including all cost of WC foot restdrop including brick jelly concrete and sand filling etc., complete

Supplying and fabrication and fixing in position of anodised natural colour matt fininsh sliding Door in TWO track in all floors with following sizes. All the two shutters with slinging entering and made with UPVC (ultra Polyvinyl Chloride ) section for outer frames as shown below with necessary accessories such rubber beading.clips, handle and fixing 5 mm thick clear sheet glass including all required for fabrication etc., complete. Necessary dismantling making holes in RCC columns, beams, mansory wherever necessary with power drill to the extent required and made good to the original conditions after fixing as directed by the departmental officers. (All materials should be got approved by the Executive Engineer before fixing in position)

Weathering course with concrete broken brick jelly 20mm size in pure slaked lime (no sand to be used ) RCC roofing slab the proportion of broken brick jelly to lime being 32:12.5 well beaten with wodeen beaters giving required slops and the thickness etc., complete

Roof top finishing with one course of pressed tiles 20cmx20cmx2cm 1:3 mix and pointed with source marter including all cost of matorer to site and all labour charges

Dadooring walls with Gllazed tiles 30x30cm size in cm 1;2 mix including cost and conveyance of all materials all labour charges and all other incidental charges etc.,complete.

E.MANI (BID ID -1072342)