running Works Contract for effecting various works for a period of six months in Kallamanaickenpatty section of Rajapalayam Division

Amount

Running Works Contract for effecting various works for a period of six months in Kallamanaickenpatty section of Rajapalayam Division

Loading&Unloading of 8m, PSC poles

Loading&Unloading of 9m, 9.14m RCC poles

Loading&Unloading of RS Joists, tubular & rail poles (above 9.14m)

Transporting of poles from road side to Work spot7.32m, 7.5m, 8m, 8.23m RCC poles/km

Transporting of poles from road side to Work spot9m, 9.14m RCC poles, RS Joists, tubular & rail pole/km

Excavation of pole pit (1.25m * 0.5m*1.5m)in Normal Ground

Erection

Excavation of pole pit (1.25m * 0.6m*1.83m) in Normal Ground

Erection

Excavation of pole pit (1.25m * 0.6m*2.19m) in Normal Ground

Erection

Concreting of poles as per Board Standards (2'*2'*5'). The material such as sand, jelly, etc., have to be supplied by the contractor except Cement supplied by contractor (Cement concrete mix 1:4:8 using 40mm hard broken stone including cost of labour charges.for placing Transporting of sant,jally,from box and water curing for 14 days etc,.complete.

Coping of poles

Coil earthing per pole & pole earthing

Excavation of stay pit (1.00m * 0.5m*1.5m)

Erection

V cross arm, Channel cross Arm3 1/2'

LT Three phase cross arm

LT single phase cross arm

HT / LT TI fitting

Tapping channel cross arm

Erection of LT Side arm with stud

g.Guarding Cross Arm

For 7/3.35 ACSR or 7/3.15 AAAC

For 7/2.59 ACSR or 7/2.50 AAAC

Below 250 KVA

LT pin point to cut point

Single Phase service connection

Three Phase service connection

7.5Mtr /8Mtr PSC & Pole

9.14Mtr RCC Pole and above

Dismantling of stay with guy shackle complete

Dismantling of TI Fitting

Dismantling of Single phase/ 3 phase cross arm

Pole (Colour washing with emulsion on Labour only) (Double coat)

Transformer structure (Double coat)

For transformer only (Double coat)

Numbering of poles With Paint

Set right of leaning of HT pole / LT pole including X arms, TI fittings

9 mtr long RCC Pole (Square Section) complete

Maintenance of A/B switch

Maintenance of Single Pole Distribution Transformer and Structure complete

Replacement of GI wire in LT cut points replaced with Lt metal parts

Replacement of worn out AB Switch knife, checking of alignment and lubrication

a)Attending H.T jumper cut

b)Attending L.T jumper cut

a)Replacement of H.T Disc

b)Replacement of HT Pin insulator

a) Replacement of L.T shackle with metal parts

b) Replacement of L.T pin insulator

Maintenance of DP Structure complete

ப jumper provision ( including of service wire disconnection & reconnection)

Set right of Tilted X arm