SPECIAL REPAIRS REPLACEMENT MandO FOR CONVERSION OF OVERHEAD LINE INTO LT UG CABLE FOR FARM AREA MD ACCN UNDER GE WELLINGTON

Amount

Excavation in trenches not exceeding 1.5M wide and not exceeding 1.5M in depth and getting out in soft/ loose soil for laying of under ground cable and foundation of poles.etc complete all as specified and directed.

Returning filling in including spreading, leveling, watering and well ramming in layers not exceeding 25 Cm thick, etc complete all as specified and directed.

Removal of excavated surplus soil not exceeding 50 m and depositing where directed at al level not exceeding 1.5 m above the starting point and all as specified and directed.

Supply and spreading clean dry riddled sand in trenches for cushioning all as specified for cable protection in trenches / ducts complete all as specified and directed. Note: The punned down thickness shall only be measured

Bricks sub class 'B' to be laid over dry sand cushinoing in trenches as protection to cable all as specified and directed.

Cutting PCC/ Road 200 mm thick for laying of cable all as specified and directed.

Cement concrete (1:3:6) type C2 with 40 mm graded aggegate for foundation / road crossing including form work and finishing to all exposed surfaces by using extra cement all as specified and directed.

Supply, lay and testing in trenches, duct or floor or along the surface of wall, cable XLPE insulated, screened, PVC bedded, galvanised steel strip or wire armoured, electric power cables (heavy duty) 1100 Volts grade with stranded aluminium conductor of size 185 Sqmm x 3.5 Core all as specified and directed.

Supply, lay and testing in trenches,, duct or floor or along the surface of wall, cable XLPE insulated, screened, PVC bedded, galvanised steel strip or wire armoured, electric power cables (heavy duty) 1100 Volts grade with stranded aluminium conductor of size 150 Sqmm x 3.5 Core all as specified and directed.

Supply, lay and testing in trenches,, duct or floor or along the surface of wall, cable XLPE insulated, screened, PVC bedded, galvanised steel strip or wire armoured, electric power cables (heavy duty) 1100 Volts grade with stranded aluminium conductor of size 120 Sqmm x 3.5 Core all as specified and directed.

Supply, lay and testing in trenches,, duct or floor or along the surface of wall, cable XLPE insulated, screened, PVC bedded, galvanised steel strip or wire armoured, electric power cables (heavy duty) 1100 Volts grade with stranded aluminium conductor of size 35 Sqmm x 3.5 Core all as specified and directed.

Supply, lay and testing in trenches,, duct or floor or along the surface of wall, cable XLPE insulated, screened, PVC bedded, galvanised steel strip or wire armoured, electric power cables (heavy duty) 1100 Volts grade with stranded aluminium conductor of size 25 Sqmm x 3.5 Core all as specified and directed.

Supply, install, testing and commissioning of factory made CPRI approved LT panel board 415 Volts, 50 Hz, 250 Amps capacity outdoor cubical type LT disribution switch gear and control gear, leg mounted, totally enclosed, cubical type modular compartment , dust and vermin proof IP-54 with neoprene gasket, fabricated out of CRCA sheet of thick ness not less than 3.15 mm complete with 2 mm thick for internal compartment duly powder coated fixed on angle iron pedestal made out of 50x50x6mm with cable chamber for incoming outgoing connections comprising for the following including necessary PCC foundation of minimum 0.20 Mtr height positioned and fixed with suitable nut, bolts, washers etc to the pedestal and connecting all incoming and outgoing cables all as specified and directed. (a) Aluminium Bus bar four wire system 415 volts mounted on procelain heat shrinkable insulator & sleeve suitable for 400 A for phases and 200 Amps for neutral. b) LED type Indicating lamps for all the three phase with different colour lamp red,yellow and green.- 1 set c) Digital multi function panel meter measuring voltage, Amps and frequency with suitabe CTs and backup protection - 1 No d) Danger notice board of size 200mm x 150mm x 1.6 mm thick of mild steel sheet vitreous enamelled white and letters, figures and convention skull and bones of signal red colour and fixed/revited with panel- 02 Nos e) Incoming MCCB 4 pole 400 Amp 25 KA - 01 no f) Outgoing MCCB 4 pole 250 Amp 25 KA - 01 no MCCB 4 pole 200 Amp 25 KA - 01 no MCCB 4 pole 40 Amp 16 KA - 04 nos

Supply, install, testing and commissioning of factory made CPRI approved LT panel board 415 Volts, 50 Hz, 250 Amps capacity outdoor cubical type LT disribution switch gear and control gear, leg mounted, totally enclosed, cubical type modular compartment , dust and vermin proof IP-54 with neoprene gasket, fabricated out of CRCA sheet of thick ness not less than 3.15 mm complete with 2 mm thick for internal compartment duly powder coated fixed on angle iron pedestal made out of 50x50x6mm with cable chamber for incoming outgoing connections comprising for the following including necessary PCC foundation of minimum 0.20 Mtr height positioned and fixed with suitable nuts, bolts, washers, etc to the pedestal and connecting all incoming and outgoing cables all as specified and directed. a) Aluminium Bus bar four wire system 415 volts mounted on procelain heat shrinkable insulator & sleeve suitable for 400 A for phases and 200 Amps for neutral . b) LED type Indicating lamps for all the three phase with different colour lamp red,yellow and green.- 1 set c) Digital multi function panel meter measuring voltage, Amps and frequency with suitabe CTs and backup protection - 1 No d) Danger notice board of size 200mm x 150mm x 1.6 mm thick of mild steel sheet vitreous enamelled white and letters, figures and convention skull and bones of signal red colour and fixed/ revited with panel- 02 Nos e) Incoming MCCB 4 pole 200 Amp 25 KA - 01 no f) Outgoing MCCB 4 pole 125 Amp 25 KA -01 no MCCB 4 pole 40 Amp 16 KA -05 nos

Supply, install, testing and commissioning of factory made CPRI approved LT panel board 415 Volts, 50 Hz, 250 Amps capacity outdoor cubical type LT disribution switch gear and control gear, leg mounted, totally enclosed, cubical type modular compartment , dust and vermin proof IP-54 with neoprene gasket, fabricated out of CRCA sheet of thick ness not less than 3.15 mm complete with 2 mm thick for internal compartment duly powder coated fixed on angle iron pedestal made out of 50x50x6mm with cable chamber for incoming outgoing connections comprising for the following including necessary PCC foundation of minimum 0.20 Mtr height positioned and fixed with suitable nut, bolts, washers etc to the pedestal and connecting all incoming and outgoing cables all as specified and directed. (a) Aluminium Bus bar four wire system 415 volts mounted on procelain heat shrinkable insulator & sleeve suitable for 400 A for phases and 200 Amps for neutral. b) LED type Indicating lamps for all the three phase with different colour lamp red,yellow and green.- 1 set c) Digital multi function panel meter measuring voltage, Amps and frequency with suitabe CTs and backup protection - 1 No d) Danger notice board of size 200mm x 150mm x 1.6 mm thick of mild steel sheet vitreous enamelled white and letters, figures and convention skull and bones of signal red colour and fixed/revited with panel- 02 Nos e) Incoming MCCB 4 pole 125 Amp 25 KA -01 no f) Outgoing MCCB 4 pole 100 Amp 25 KA-01 no MCCB 4 pole 40 Amp 16 KA - 03 nos

Supply, install, testing and commissioning of factory made CPRI approved LT panel board 415 Volts, 50 Hz, 250 Amps capacity outdoor cubical type LT disribution switch gear and control gear, leg mounted, totally enclosed, cubical type modular compartment , dust and vermin proof IP-54 with neoprene gasket, fabricated out of CRCA sheet of thick ness not less than 3.15 mm complete with 2 mm thick for internal compartment duly powder coated fixed on angle iron pedestal made out of 50x50x6mm with cable chamber for incoming outgoing connections comprising for the following including necessary PCC foundation of minimum 0.20 Mtr height positioned and fixed with suitable nut, bolts, washers etc to the pedestal and connecting all incoming and outgoing cables all as specified and directed. (a) Aluminium Bus bar four wire system 415 volts mounted on procelain heat shrinkable insulator & sleeve suitable for 400 A for phases and 200 Amps for neutral. b) LED type Indicating lamps for all the three phase with different colour lamp red,yellow and green.- 1 set c) Digital multi function panel meter measuring voltage, Amps and frequency with suitabe CTs and backup protection - 1 No d) Danger notice board of size 200mm x 150mm x 1.6 mm thick of mild steel sheet vitreous enamelled white and letters, figures and convention skull and bones of signal red colour and fixed/revited with panel- 02 Nos e) Incoming MCCB 4 pole 250 Amp 25 KA - 01 no f) Outgoing MCCB 4 pole 200 Amp 25 KA - 01 no MCCB 4 pole 40 Amp 16 KA - 03 nos

Supply, install, testing and commissioning of factory made CPRI approved LT panel board 415 Volts, 50 Hz, 250 Amps capacity outdoor cubical type LT disribution switch gear and control gear, leg mounted, totally enclosed, cubical type modular compartment , dust and vermin proof IP-54 with neoprene gasket, fabricated out of CRCA sheet of thick ness not less than 3.15 mm complete with 2 mm thick for internal compartment duly powder coated fixed on angle iron pedestal made out of 50x50x6mm with cable chamber for incoming outgoing connections comprising for the following including necessary PCC foundation of minimum 0.20 Mtr height positioned and fixed with suitable nut, bolts, washers etc to the pedestal and connecting all incoming and outgoing cables all as specified and directed. (a) Aluminium Bus bar four wire system 415 volts mounted on procelain heat shrinkable insulator & sleeve suitable for 400 A for phases and 200 Amps for neutral . b) LED type Indicating lamps for all the three phase with different colour lamp red,yellow and green.- 1 set c) Digital multi function panel meter measuring voltage, Amps and frequency with suitabe CTs and backup protection - 1 No d) Danger notice board of size 200mm x 150mm x 1.6 mm thick of mild steel sheet vitreous enamelled white and letters, figures, and convention skull and bones of signal red colour and fixed/revited with panel- 02 Nos e) Incoming MCCB 4 pole 200 Amp 25 KA - 01 no f) Outgoing MCCB 4 pole 160 Amp 25 KA - 01 no MCCB 4 pole 40 Amp 16 KA - 03 nos

Supply, install, testing and commissioning of factory made CPRI approved LT panel board 415 Volts, 50 Hz, 250 Amps capacity outdoor cubical type LT disribution switch gear and control gear, leg mounted, totally enclosed, cubical type modular compartment , dust and vermin proof IP-54 with neoprene gasket, fabricated out of CRCA sheet of thick ness not less than 3.15 mm complete with 2 mm thick for internal compartment duly powder coated fixed on angle iron pedestal made out of 50x50x6mm with cable chamber for incoming outgoing connections comprising for the following including necessary PCC foundation of minimum 0.20 Mtr height positioned and fixed with suitable nut, bolts, washers etc to the pedestal and connecting all incoming and outgoing cables all as specified and directed. (a) Aluminium Bus bar four wire system 415 volts mounted on procelain heat shrinkable insulator & sleeve suitable for 400 A for phases and 200 Amps for neutral. b) LED type Indicating lamps for all the three phase with different colour lamp red,yellow and green.- 1 set c) Digital multi function panel meter measuring voltage, Amps and frequency with suitabe CTs and backup protection - 1 Nos d) Danger notice board of size 200mm x 150mm x 1.6 mm thick of mild steel sheet vitreous enamelled white and letters, figures and convention skull and bones of signal red colour and fixed/revited with panel- 02 Nos e) Incoming MCCB 4 Pole 160 Amp 16 KA - 01 no f) Outgoing MCCB 4 pole 40 Amp 16 KA - 03 nos

Earthing complete with galvanised steel plate electrode 600x 600x 6mm thick buried directly in ground (earth pit not less than 2.25 mtrs deep below ground level) with top edge of plate not less than 1.5 mtrs below normal ground level connected to galvanised iron strip of size 32x6mm from earth plate to body of the equiment by means of bolts, nuts, check nuts and washers of galvanised iron or steel all as shown in electrical plate No 3 connected to earth in test point on completion with and including 15mm bore light grade GI protection pipe ( 7.5 mtr long) for earth including PCC (1:2:4) type B1 chamber pit with pre cast RCC (1:2:4) type B1, 40mm thick reinforced with 6mm dia MS bars @ 100 c/c bothway, lifting hooks made out of 6mm MS bars, watering aggangement with funnel, wire, common salt, charcoal filling, necessary excavation and earth work in any type of soil complete all as specified and as directed

Saket Enterprises

Rajapriyaconstruction

rvelectricals

sree devi construction

M.V.K.ENTERPRISES

AR Traders