Providing Reverse Osmosis Unit and Distribution System at Puthupatti

Earth work excavation for foundation and depositing on bank with in the initial lead of 10m and a lift of 2m in hard stiff clay, stiff block cotton, hard red earth, shales, murram, gravel, stoney earth and earth mixed with small size boulders etc.,as per SS 20 A. TNDSS NO: 23 & 24 VI (S2) VI,VII 9,10 with standard specifications.

Filling the Basement with Excavated Earth other than sand from Foundation work including all labour charges for Filling, levelling, watering and ramming etc., complete

Supplying and filling with filling stone dust in layers not more than 15 cm thick including labour charges for Filling, Levelling, watering, well rammed and compacted etc., complete For Flooring Filling material etc..complete

Plain Cement Concrete 1:4:8 Mix (one Part of cement, four Part of M- Sand and Eight Part of aggrigate) using 40 mm size ISS HBG metal from approved quarry including cost and conveyance of all materials to site. Loading and unloading charges and labour charges for mixing. Laying and curing etc., complete as per TNDSS NO : 28 & VI (S2) VI (S5A) VII standard specifications as directed by Engineer incharge.

Random Rubble masonary in Cement Mortor 1:5 Mix (one cement, five M- Sand) using new best rough and bond stones from approved quarry including cost and conveyance of all materials to site. Loading and unloading charges and labour charges for mixing. laying and curing etc. complete. complying with std. specifications.

Brick Work in Cement Mortor 1:5 Mix (one cement, five M- Sand ) using new best country Bricks of size 8 ¾” x 4 ¼” x 2 ¾” from approved quarry including cost and conveyance of all materials to site. loading and unloading charges and labour charges for mixing, laying and curing etc. complete. complying with std. specifications.

Supplying and fabrication of steel and placing in position of TMT steel rods for RCC works as per design given including cost of steel and GI binding wire in all floors etc., complete complying with standard specification in TNDSS NO:97 V,VI (S6) VII (S6), VII-3.

Reinforced Cement Concrete 1:1½:3 Mix (One Part of cement, one and half Part of M- Sand and three Part of aggregate)using 20mm size ISS HBG metal machine crushed from approved quarry including cost and conveyance of all materials to site, loading and unloading charges and labour charges for mixing, laying and curing but excluding cost of reinforcement etc. Complete with std. Specifications. TNDSS NO: 30 V, VI (S3), VII-3.

Plain Cement Concrete 1:2:4 Mix (one Part of cement, two Part of M- Sand and four Part of aggrigate) using 20mm size ISS HBG metal machine crushed from approved quarry including cost and conveyance of all materials to site, loading and unloading charges and labour charges for mixing, laying and curing etc., complete as per TNDSS NO: 28 & VI (S2) VI (S5A) VII standard specifications as directed by Engineer incharge.

Plastering in Cement Mortor 1:4 Mix (one cement, five M- Sand) 12mm thick including cost and conveyance of all materials to site, loading and unloading charges and labour charges for mixing, laying and curing etc. complete. Complying with std. specifications.

Exterior Emulsion paint Two coats with good quality of approved Emulsion paint including cost of all materials to site and all labour charges for mixing applying and proper curring etc., Complete as per Standard Specifications for 10 sqm

Painting two coat of new iron works such as Steel Doors, Windows, Ventilators, etc., with best approved first quality of Synthetic Enamel paint of approved colour over the existing priming coat of red oxide including all labour and other incidental charges etc., complete. (For Doors and Windows)

Supplying and fixing of M.S grill of approved design for doors, windows and ventilators using necessary mild steel flats for inner and outer memebers which should be fixed to window frames inclusive of priming coat of best approved quality red oxide primer etc., complete complying with standard specifications.

Labour charges for fixing of Steel Door at position to Plumb and right way including all Door fixtures and Tools required, all labour and other incidental charges etc. complete.

Supplying and erecting in position of following liters capacity Industrial Model Reverse Osmosis Water-cum-Purifier to deliver Potable Water with World Health Organisation (WHO) Standards with following accessories. (a) MS Skid - 1 No. (b) Media 11054 No. Vessel with 20 nb Multiport Valve (with Media Pubble and Fine Sand and Activated Carbon Filling) set (c) Feed Pump 0.50 HP – 1 No. (d) Vertical Pump 2-9, 2.00 HP / Single Phase – 1 No. (e) Membrane 40 x 40 filmtech (or) equilaents / Osmonic (USA) - 1 No. and Membrane Pressure Vessel 40 x 40 -1 No. & Pressure Gauge - 2 Nos. (f) Flow Meter - 1 No. 20” Filter with Housing - 1 No., Low Pressure Switch - 1 No., Level Switch - 1 No. & Necessary CPVC Pipes and Fittings. The system shall be provide with Two Panel Control System with necessary Stainless Valves and Fittings and Float Control etc. The rate should be inclusive of all civil works, wherever necessary to install the System in position and intact.

HDPE Tank 2000 Litres

Wiring with 2 x 1.5 sq.mm. (22 / 0.3 ) PVC insulated single core unsheathed copper conductor cable of 1100V grade in suitable heavy gauge MS conduit pipe on wall and ceiling with MS accessories with MS switch Box and 5A FT switch with painting of suitable colour continuous earth wire connection of 14 SWG TC wire for light point / fan point (for electronic regulator) SD 1

Wiring with 2 x 1.5 sq.mm. (22 / 0.3 ) PVC insulated single core unsheathed copper conductor cable of 1100V grade in suitable heavy gauge MS conduit pipe on wall and ceiling with MS accessories with 150mm x 100mm x 75mm MS switch box for 5A 3 pin non interlocking flush type CS plug with painting of suitable colour with continuous earth wire connection of 14 SWG TC wire for open plug point SD10

Supply and fixing of WT bulk head fitting with guard suitable for incandescent lamp with 60W bulb SD83

Roofing with Galvalium Sheets of 0.47mm thick over cum rafters fitted with “J” Bolts with Tar washers excluding cost of rafters etc. complete 10m2.

Drilling of Borewell in hard rock areas anywhere in the state including transportation to site of work in Hard rock areas including labour charges for inserion of MS Casing pipe and Flushing of Borewell, all other labour and other incidental charges etc., complete

Supply, Delivery and fixing of 180mm dia OD 6 Kgsc Casing Pipe to prevent Top soil sliding including labour charges and all other incidental charges etc., complete (150mm CS Casing pipe as per IS 12818/2010 standard specifications

Three Phase Submersible pump set suitable for 150mm dia Borewell with Duty of 50lpm x 175m head of 5HP power without Panel Board for Water suction as per IS 8034/2002 Standard specifications etc., complete

Supply, delivery and fixing of Three Phase Panel board - D.O.L with Two level Guard and Auto Start Confirming to ISI3947 and IEC 947 suitable KW rating for operation including all accessories and other incidental charges etc., complete

Supply and delivery of Un Plasticized Non Pressure Polyvinyl Chloride (PVC -U) PIPES - UPVC Column Pipes as per IS 15328/2003 specifications 40mm dia inside the borewell along with Sub motor for Water suction including conveyance charges etc., complete

Supplying and delivery of PVC Insulated and sheathed 2.5 Sq mm 3 core Flat type copper cable confirming to IS 694 /1990 including cost of materials etc., complete

Towards labour charges for the erection of 1.5HP submersible pumpset in borewell/open well including fixing and jointing submersible cable with proper clamps upto the starter to required depth and also fixing of riser pipes to the required depth valves erection clamps pressure gauges upto the exterior wall of pump room and erection of panel board consiting of TPICN switches starter, volmeter, ammeter, three pilot (indicating) lamps capacitor single phasing preventor, water level guard and laying and jointing the cables and twin earthing as per IE rules etc, complete and testing the pumpset and trail run for 10 days

Supply and run of 2 of 1.50 sq.mm (22/0.30) PVC insulated SC unsheathed copper Conductor of 1100 V grade on 7/20GI bearer wire for Service Connection Mains SD 64

Supply and run of 2x1.50 sq.mm (22/0.30) PVC insulated SC unsheathed Copper Conductor of 1100 V grade in 25mm dia GI Pipe (Class B) suitably bent at both ends with necessary angle iron upright and end supports for Mains SD 69

Supply and fixing of TNEB meter Board suitable for 32A Single Phase service connection with 32A Fuse unit (500V) 32A neutral link and earth link (1" x 1/8" Copper flat) on TW plank of size 375mm x 300mm x 19mm with supporting TW reepers of 1" thick an either side with painting with suitable bolt and nuts for fixing the TW plank on wall with earth connection and inter connection with 7/20 PVC insulated copper wire from EB meter to fuse unit - SD 125.