KMC/DG(C)/I/003/57/2025-2026

BUILDING WORKS (A) EARTH WORK,ANTITERMITE TREATMENT 2. Earth work in excavation of foundation trenches or drains, in all sorts of soil (including mixed soil but excluding laterite or sandstone) including removing, spreading or stacking the spoils within a lead of 75 m. as directed. The item includes necessary trimming the sides of trenches levelling, dressing and ramming the bottom, bailing out water as required complete. (a) Depth of excavation not exceeding 1,500 mm.

BUILDING WORKS (B) DISMANTLING, CUTTING CHASE, HOLES ETC 10. Stripping off worn out plaster and raking out joints of walls, celings etc. upto any height and in any floor including removing rubbish within a lead of 75m as directed.

SECTION 1. ------------BUILDING WORKS (I) PLASTERING, POINTING ETC. A. ORIGINAL WORKS 1.Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (Ground floor).[Excluding cost of chipping over concrete surface](ii) With 1:4 cement mortar (a) 20 mm thick plaster

SECTION 1. ------------BUILDING WORKS (J)WHITE WASH, COLOUR WASH, DISTEMPER A. ORIGINAL WORKS 8 Applying Exterior grade Acrylic primer of approved quality and brand on plastered or cencrete surface old or new surface to receive decorative textured (matt finish) or smooth finish acrylic exterior emulsion paint including scraping and preparing the surface throughly, complete as per manufacturer's specification and as per direction of the EIC. In Ground Floor: (b) Two Coats [This item to be done under specific instruction of the Superintending Engineer]N.B.:-Extra for each additional floor in external walls refer item 1 of subhead C

SECTION 1. ------------BUILDING WORKS (K) PAINTING, VERNISHING ETC A. ORIGINAL WORKS 2 (A) Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary :(a) On timber or plastered surface :With super gloss (hi-gloss) -(iv) Two coats (with any shade except white)

SECTION 1. ------------BUILDING WORKS (K) PAINTING, VERNISHING ETC A. ORIGINAL WORKS 2 (A) Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary : (a) On timber or plastered surface :With super gloss (hi-gloss) -(ii) Two coats (white in shade)

Supplying, spreading and compacting Sand to required thickness, in layers not exceeding 150 mm to proper gradient and camber, inundating each layer by water and packing and ramming layer by layer to achieve desired compaction, including lighting, guarding, barricading and making adequate earthen bundh where necessary, curing with water as per direction, mending cracks and depressions by ramming wherever necessary. (c) For Silver Sand ( Ref :PWD (Rds & Brdgs)-2018, It. No. 4.05 Page No.245 & page-222 sl. No-4)

ORDINARY CEMENT CONCRETE ( MIX 1:2:4 ) WITH GRADED STONE CHIPS ( 20 MM NOMINAL SIZE) EXCLUDING SHUTTERING AND REINFORCEMENT, IF ANY, IN GROUND FLOOR AS PER RELEVANT IS CODES (BASED ON PWD SCHEDULE OF RATES, W.E.F. 01.11.2017 WITH CORRIGENDA DT.04.06.2018)

SUPPLYING AND LAYING IN THE SPECIFIED PATTERN OF CONCRETE BLOCKS MANUFACTURED FROM BIS LICENSEE MANUFACTURER, WITH SPACER NIB (SMALL PROTRUDING 50 MM THICK :(II) COLOURED DECORATIVE

BRICK WORK WITH 1ST CLASS BRICKS IN CEMENT MORTAR (1:4) (A) IN FOUNDATION AND PLINTH

BUILDING WORKS ( C ) Brickworks,Concrete Works etc A. BRICK WORKS 16. 125 mm. thick brick work with 1st class bricks in cement mortar (1:4) in ground floor.

M.S.OR W.I. ORNAMENTAL GRILL OF APPROVED DESIGN JOINTS CONTINUOUSLY WELDED WITH M.S, W.I. FLATS AND BARS OF WINDOWS,RAILING ETC. FITTED AND FIXED WITH NECESSARY SCREWS AND LUGS IN GROUND FLOOR. (ADD EXTRA @ 1% FOR EACH ADDL. FLOOR UPTO 4TH FLOOR AND @ 1.25% FOR EACH ADDL. FLOOR ABOVE 4TH FLOOR) ((II) GRILL WEIGHING ABOVE 16 KG./SQ.MTR AND ABOVE

SECTION 1. ------------BUILDING WORKS (K) PAINTING, VERNISHING ETC A. ORIGINAL WORKS 1 (a) Priming one coat on steel or other metal surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand papering etc (This item is applicable to new work or old work when the original surface has been exposed by removal of old paint.)

BUILDING WORKS (K) PAINTING, VERNISHING ETC?(A) ORIGINAL WORKS.(2)(A) Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary :(b) On steel or other metal surface :With super gloss (hi-gloss) -(iv) Two coats (with any shade except white)

Single Brick Flat Soling of picked jhama bricks including ramming and dressing bed to proper level and filling joints with local sand. ( Ref :PWD (Bldg.)-2017, It. No. 1, Page No.14 & 3rd Corrigenda Addenda dtd-04.06.18,P-1)

SECTION(B) - SANITARY AND DRAINAGE WORKS.(B)-(II) SOIL PIPE AND FITTINGS.(a) Original Works.(16.)Supplying, fitting and fixing with cement jointing (3:1) salt glazed stoneware pipe including excavation of earth upto 1.50 metre depth in all sorts of soil both mixed or unmixed and refilling (but excluding concreting at bottom and sides).(iii) 150 mm

Cement concrete with graded jhama khoa (30 mm size) excluding shuttering In ground floor and foundation. (b) 1:4:8 proportion ( Ref :PWD (Bldg.)-2017, It. No. 1, Page No.23 & 3rd Corrigenda Addenda dtd-04.06.18, P-9 & 10)

23.Construction of Catch pit 600mmX525mm. (inside measurement) and depth of invert 1000mm. below G.L. with 250mm. thick cement brick work (1:4) over 100mm. thick jhama cement concrete (1:4:8) bed over a layer of brick flat soling including providing 100mm. thick R.C.C. slab with ordinary cement concrete (mix 1:1.5:3) with reinforcement as per standard drawing, brickon- edge flooring with 20 mm. thick cement plaster (1:4) finished fine with 1.5 mm. thick neat cement in the inside walls and invert including supplying and fixing R.C.P.C. gully grid (5 M.T.load bearing capacity) and 150 mm. dia. C.I. Syphone including cutting hard crust, excavation, dewatering, back filling and removal of spoils as per standard drawing

BUILDING WORKS (A) EARTH WORK,ANTITERMITE TREATMENT 5. Earth work in filling in compound, tank, low land, ditches etc. with good earth, in layers not exceeding 150 mm. including breaking clods and consolidating the same by ramming and dressing complete. (Payment will be made on profile measurement before and after the work) (b) (iii) With carried earth arranged by the contractor within a radius exceeding 5 km. but not exceeding 10 km. including cost of carried earth.

BUILDING WORKS. (T)MISCELLANEOUS WORKS: A. SPECIAL WORKS. I. HORTICULTURE: 3.Spreading of sludge, dump manure,/farm yard manure/animel dung manure and good earth in required thickness. This includes supply of labour, tools & plants excluding materials.

SUPPLYING FITTING & FIXING OF DOTBLE SWING: AREA REQUIRED: APPROX 10FT X 14FT: LEGS:2" N.B(M) G.I. TUBE,TOP 2" N.B.(M) G..TUBE CHAIN: 4 NOS 6MM LONG LINL WITH PVC SLEEVE PER SEAT, SEAT 2 NOS. FRP MOULDED FLAT SEAT,SIZE: L- 96", W- 96 &H-84", PAINT: ETCH & ROZC PRIMER ON G.I. SURFACE AND RED OXIDE METAL PRIMER ON WELDED JIONTS WITH 2 COATS OF BERGER LUXOL PAINT

SUPPLY, FITTING 8 FIXING OF DOUBLE SEE SAW : AREA REQUIRED : APPROX 5FT X 9FT; TOP BAR:1.5" N.B.(M) G.I. TUBE X 3.5 FT LONG WITH C.I.HOUSING ;LEGS: 1.5" N.B.(M) C.I. TUBE HANDLE BAR: 22MM M.S. TUBE WITH HANDLE GRIP; SEAT: FRP MOULDED SEAL WITH RUBBER BALL FENDER UNDER THE SEAT FOR CUSHIONING & SHOCK PREVENTION;SIZE: L FT, W- 42", H- 20"; PAINT: ETCH & ROZCR PRIMER ON C1. SURFACE AND RED OXIDE METAL PRIMER ON WELDED JIONTS WITH 2 COATS OF BERGER LUXOL PAINT.

SUPPLYING, FITTING AND FIXING OF FRP ROLLER SLIDE 6 FT HEIGHT :AREA REQUIRED: 4 FX19 T; LADDER: FABRICATED FROM 1" N B.(M) G.I. TUBE WITH 3/4" N.B.(M) G.I. TUBE HANDRA, 70MMX20MM M.S. ROUNDED RECTANGULAR TUBE STEPS X20.75" LONG; SLIDE: H.).P.E. ROLLERS FITTED WITH BALL BEANNGS &NYLON BUSH ALTERNATELY HAVING 16" INSIDE W DTH; SIZE: L- 15 FT, W- 25", ? - 7.5 FT: PAINT: ETCH & ROZCR PRIMER ON G.I. SURFACE ID RED OXIDE METAL PRIMER ON RECTANGULAR TUBE STEPS & WELDED JIONTS WITH 2 OATS OF BERGER LUXO PAINT.

SUPPLY, FITTING & FIXING OF GARDEN BENCH WITH SHADE: SHADE: FRP WITL TUBE STRUCTURE; LEGS: 1.5" G.L 18 TUBE,SIZE: L -61", W- 51",H - 13"; BENCH: LEGS: 1 G.I. TUBE; SIZE: L- 60", W- 30" H-34", SEAT & BACK REST: FRP RECTANGULAR SECTIN WITH M.S.REINFORCEMENT; PAINT: PED OXIDE METAL PRIMER ON CAST IRON LEGS & OR M.S.REINFORCEMENT AND FINISHED BRGER LUXOL PALNT

BUILDING WORKS. (T)MISCELLANEOUS WORKS: A. SPECIAL WORKS. I. HORTICULTURE: 9) Supplying and Planting of different plant / trees ( Supplying well grown plants bushy and healthy, minimum height as specified i.e. exposed height including all leads & lift, carriage, handling, manuring, applying presticide and fertilizer etc. xiii) Ficus regnold well branched (bushy) of height 120cm- 135cm in cement pots of size 35cm.

BUILDING WORKS. (T)MISCELLANEOUS WORKS: A. SPECIAL WORKS. I. HORTICULTURE: 9) Supplying and Planting of different plant / trees ( Supplying well grown plants bushy and healthy, minimum height as specified i.e. exposed height including all leads & lift, carriage, handling, manuring, applying presticide and fertilizer etc. xxi) Croton different varieties of height 30 cm to 90 cm in earthen pots of size 25cm.

BUILDING WORKS(P) SOLING, EDGING AND METALLING??(3)Brick edging 75 mm wide with picked jhama bricks, laid true to line and level including cutting necessary trench in soil or in hard metalled surface, laying the bricks and repacking the trench (on both side of the edging) with spoils and ramming the same thoroughly complete as per direction.(b) Brick-on-end edging (250 mm) depth.

Estimated amount

Add: 9%SGST

Add: 9%CGST