PROVN OF PAVED AREA, TILING AND ELECTRIC LIGHT NEAR TECH AREA OF LIKABALI MIL STN UNDER GE 872 EWS

Amount

B/R SERVICES/WORKS

Demolition Cement Concrete (Un-reinforced) of any description in Ground Floors, Pavings, etc. not exc. 150mm thickness (above or below Ground Level) and Removing debris, etc. to a distance not exc. 100.00 Metre, complete all as specified and as directed.

Dismantling Floor, Hearth or Wall Tiling including Cement Mortar Bedding (but not backing) and removing debris, etc. to a distance not exc. 100.00 Metre, complete all as specified and as directed.

Taking down Cement Plaster including Raking out Joints, Hacking for Key, Scrubbing down with Water and Removing Debris, etc. etc. to a distance not exc. 100.00 Metre, complete all as specified and as directed.

Surface Excavation not exc. 30 Cm Deep and ave. 15 Cm Deep and getting out in Soft/ Loose soil, complete all as specified and as directed.

Excavation in Trenches not exc. 1.50 Metre wide and not exc. 1.50 Metre in depth for Foundation etc. or for Shafts, Wells, Cess Pits, Manholes, Pier Holes, etc. not exc. 10 Sqm on Plan and not exc. 1.50 Metre in depth and getting out as in Soft/ Loose Soil, complete all as specified and as directed.

Returning, Filling in including Spreading, Levelling, Watering and Well Ramming in layers not exc. 25 Cm, in Soft/Loose Soil, complete all as specified and as directed.

Removing Excavated Materials (Soils), exc. 250.00 Metre but not exc. 500.00 Metre distance and depositing where directed at a level not exc 1.50 Metre above the Starting Point, complete all as specified and as directed.

M&L Cement Concrete 1:4:8 (40mm graded aggregate) in Foundations, Filling and Mass Concrete, etc. including necessary Formwork, complete all as specified and as directed. NOTE : Cost of Formwork will deemed to included in the Quoted Unit Rate.

M&L Reinforced Cement Concrete 1:2:4 (20mm graded stone aggregate) in Foundation including Raft, Footing, Foundation Beam for Column Basement Slab, under reamed Piles, complete all as specified and as directed. NOTE : Reinforcement & Formwork will be Measured and Paid for separately under appropriate Items.

M&L Reinforced Cement Concrete 1:2:4 (20mm graded stone aggregate) Columns, Pillars, Piers, Posts and Struts, etc., complete all as specified and as directed. NOTE : Reinforcement & Formwork will be Measured and Paid for separately under appropriate Items.

M&L Reinforced Cement Concrete 1:2:4 (20mm graded stone aggregate) in Beams, Cantilevers, Bressummers, Lintels Over 1.50 Metre Span and the like, complete all as specified and as directed. NOTE : Reinforcement & Formwork will be Measured and Paid for separately under appropriate Items.

M&L Formwork to Sides of Concrete Foundations, Footings, Bases of Columns, Raft and Raft Beams, Sides and Soffits (if any) of Foundation and Plinth Beams; and Similar Work; Vertical or to Batter, Flat, Rough Finished surfaces of Concrete, complete all as specified and as directed.

M&L Formwork to Sides Pillars, Posts, Struts, Piers, Columns and Stanchions and Similar Work; Rough Finished surfaces of Concrete, complete all as specified and as directed.

M&L Formwork to Sides and Soffits of Floor or Roof Beams, Girders, Beam Haunchings, Bress-summers, Lintels, Cantilevers, Shelves including Supports, Overhangs, etc. also splays between Floors and Beams, etc., Flat, Rough Finished surfaces of Concrete, complete all as specified and as directed.

M&L TMT Bars 10mm dia and Over, Cut to length, Bent to Shape required including Cranking, Bending Spirally for Hooping for Columns, hooking Ends and Binding with and including Mild Steel Wire (annealed) not less than 0.9mm dia, complete all as specified and as directed.

M&L TMT Bars 8.0mm dia in Stirrups, Spacers and Binders, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including Mild Steel Wire (annealed) not less than 0.9mm dia, complete all as specified and as directed.

M&L Cement Concrete 1:4:8 (40mm graded stone aggregate) 50mm thick in Sub-base to Flooring, etc., complete all as specified and as directed.

M&L Cement Concrete 1:2:4 (12.5mm graded stone aggregate) 25mm thick in Sub-base for laying of Tiles, etc., Maintaining Level Uniformly, finished Concrete Surfaces Fair and Even, complete all as specified and as directed.

M&L Non-skid Ceramic Coloured/ Designer Tiles, 7.0mm to 8.0mm thick, Joint Free (Square/ Rectangular), Area of Each Tile exc. 0.18 Sqm but not exc. 0.38 Sqm in Floors, Jointed in Neat Cement Slurry and Pointed in Coloured Cement to match the Tile, laid over and including Cement Screed Bed 15mm thick in Cement Mortar 1:6, complete all as specified and as directed. NOTE : Cost of Cement Screed Bed will deem to include in Quoted Unit Rate.

M&L Glazed/ Texture Ceramic Coloured Tiles 350x250x7.0/ 450x350x7.0mm thick in Vertical Surfaces i.e. Dado, Skirting, etc., Set in Neat Cement Slurry and Pointed in Coloured Cement to match the Tile, fixing over and including Cement Screed Bed 10mm thick in Cement Mortar 1:4, complete all as specified and as directed. NOTE : Cost of Cement Screed Bed will deem to include in Quoted Unit Rate.

M&L Machine Cut Granite (of any type) Work 20mm thick (Table Rubbed and Polished) in Floor Steps, Walls, Pillars, Platforms and like in Cement Mortar 1:4 including Pointing in White Cement 1:2, using Marble Dust with Admixture of Pigment to match with Shade of Granite, fixing over and including Cement Screed Bed 15mm thick in Cement Mortar 1:4, complete all as specified and as directed. NOTE : Cost of Cement Screed Bed will deem to include in Quoted Unit Rate.

M&L Machine Pressed Pre-cast Concrete Interlocking Paver Block 60mm thick of M-35 Grade, with Grey Cement and Pigment of any shape and size (as ordered), conforming IS-15658-2006, ISI Marked, laid dry over Clean dry Sand and grouted with Clean dry Sand in Floors, complete all as specified and as directed. NOTE : Clean Dry Sand will be Measured and Paid separately under appro-priate Item.

M&L Sand (as approved) Filling under Pre-cast Concrete Interlocking Paver Block, etc. including Spreading and Levelling, etc., complete all as specified and as directed.

E/M SERVICES/WORKS

M&L Cement Concrete 1:3:6 (20mm graded stone aggregate) in Copping of Poles, etc., Weathering slightly Rounded or Chamfered Angle and Throating, Fair Finishing to all Exposed Faces of Concrete including necessary Earthwork and Formwork, complete all as specified and as directed.

S&F LED Bollard Light Fitting 8/9/10 Watt (as approved), New Generation, Environmental Friendly, Energy Saving, Long Life, Aesthetically Designed, Aluminium Landscape Luminaire for Diffused Lighting with High Power LED as Light Source, IP-65 Protected, Electrically connecting up with and including suitable Size and Length PVC Flexible Twisted Copper Wire, 3 Core, complete all as specified and as directed.

S&F LED Post Top Lantern 20 Watt, 230 Volt AC, Outdoor type with Decorative Post Top for 360 Degree Indirect Light, having IP 65/66 Protection with Impact and Corrosion Resistant complete with Driver and Lamp, Electrically connecting up with and including suitable Size and Length PVC Flexible Twisted Copper Wire, 3 Core, complete all as specified and as directed.

S&F LED Flood Light Fitting 100 Watt, 230 Volt AC, Out-door type, Decorative having IP 65/66 Protection with Impact and Corrosion Resistant complete with Driver and Lamp, Electrically connecting up with and including suitable Size and Length PVC Flexible Twisted Copper Wire, 3 Core, complete all as specified and as directed.

Excavating in Trenches, not exc. 1.50 Metre Wide and Depth not exc. 1.50 Metre for Taking up/ Laying Electrical Cables, Water Pipe Lines, etc., Forming Surfaces to required Foundation, etc. and getting out as in Soft/Loose Soil, complete all as specified and as directed.

Returning, Filling in including Spreading, Levelling, Watering, Well Ramming in Layers not exc. 25 Cm, Providing Heaps along the Route of the Electrical Cables, Water Pipe Lines, etc. with Surplus Soil in Soft/Loose Soil, complete all as specified and as directed.

Supply and Laying or Fixing or Passing through Pipe, 1100 Volt grade Heavy duty Cable with PVC insulated Aluminium Stranded Conductor served with an Inner sheathing of PVC Tape armoured with Galvanised Steel Wire or Tape and Overall PVC sheathed Weather Proof Flat Twin Core 10 Sqmm, complete all as specified and as directed.

S&F Rigid Non-metallic PVC Conduit of Size 25mm (External Dia) exclusive of Boxes (Junction/ Terminal) but inclusive of all Tees, Bends, Elbows, Reducers, Bell Mouth Tube Ends and Fixing Accessories such as Couplers, Lock Nuts, Saddles, Pipe Hooks, etc., complete all as specified and as directed.

M&L XLPE insulated, Armoured, Heavy duty, Electric Cable with Aluminium Stranded Conductor, 1100 Volt grade, Cross-sectional Area 16 Sqmm, 2 Core, laid in Trenches/ Ducts or Passing through Pipe or Fixing on Poles, etc., complete all as specified and as directed. NOTE : Earthworks, Sand Cushioning, Cable Protection Cover/ Bricks, GI Pipe, etc. will be Measured and Paid separately under relevent Items.

M&L Sand Cushioning (dry) in Trenches/Ducts for protection of UG Cables (below, above and around the UG Cable laid) of 23 Cm Spread thickness (8 Cm in depth before laying the Cable and 15 Cm in depth after laying the Cable) and consolidated (punned) upto 180mm thickness, complete all as specified and as directed. NOTE : Only Punned thickness of Sand Cushioning will be Measured and Paid

Supply & laying Sub-class ‘B’ Bricks of Size 230x115x75mm, Kiln burnt, for Covering to UG Cable as Protection, laid Flat, Transversally Width Equal to the Length of the Cable, complete all as specified and as directed.

Supply, Installation, Commissioning & Testing Factory Made (CPRI Approved/ Tested Manufacturer) LT Panel Board, made out of 3.15mm thick CRCA Sheets, Cubical type, Outdoor type, Single Door, Weather & Vermin Proof, Front and Rear Side Openable, having Rubber Lining, Locking Arrangement, Externally and Internally Painted with Powder coated Paint (First quality) complete mounted on Mild Steel Channel of Size 75x40mm (mininmum) Stand including Plain Cement Concrete 1:2:4 (20mm graded aggregates) Foundation including Under-mentioned Items housed Independent Compartment and having sufficient Working Space :- (a) Aluminium Bus-bar Strip 100 Amp capacity - 04 No. (b) MCB TPN 63 Amp - 01 No. (c) MCB SPN 32 Amp - 02 No. (d) Timer Switch - 01 No.

M&L Earthing with Galvanised Earth Plate Electrode 600x600x6.0mm thick, buried directly in Ground vertically to a depth not less than 2.25 Metre below Ground Level with Top Edge of Earth Plate at depth not less than 1.50 Metre below normal Ground Level, connected to Galvanised Earth Lead Wire 4.0mm dia by means of Bolts, Nuts, Check, Nuts and Washers of Galvanised Iron or Steel and Earth Wire protected with and including GI Pipe 15mm bore (dia) light grade, connected to Test Point upto 7.50 Metre away from Earth Electrode situated, Earth Plate surrounded by a packed thickness of Char Coal or Coke Dust mixed with Common Salt in alternate layers of not exc.150mm thick, PCC Pit in Cement Concrete 1:3:6 (20mm graded stone aggregate) and Pre-cast RCC Cover Slab of Size 350x350x50mm in Cement Concrete 1:2:4 (20mm graded stone aggregate), reinforced with 10mm dia TMT Bars @ 100mm Centre to Centre in both ways, GI Wire Mesh, PGI Funnel with GI Watering Pipe 20mm bore (dia) Medium grade including necessary Excavation in Soft/ Loose Soil, Returning, Filling in and Removal of surplus Spoil upto a distance of 50.00 Metre and all as shown in Electrical Plate No. 3 of MES Schedule Part-I and Testing, complete all as specified and as directed.

M/S Raju prasad

M/S Build Tech

M/s United Builders

SHRI MANOJ KONWAR

M/s Shiva Technical Enterprise

M/S RK Trading

M/S R & R D ENTERPRISES

Prova Stores