Construction of houses for class - III staff (650 Sft. area) in UHS, Rohtak (Pdg. Street Light only).

Amount

HSR Items

23.3 COPPER WIRING IN PVC CONDUIT (SURFACE/RECESS)

23.3.6 Wiring main and sub mains in two single core for phase and neutral wire and one single core for earth wire PVC insulated Copper conductor cable 1100 Volts grade in PVC Conduit etc as required.

23.3.6.1 1 run of Size 1.50 Sqmm(1/1.40mm)

23.22 MCCB ,DISTRIBUTION BOARDS, MCB's, RCCB's, CHANGE OVER etc

23.22.1 Supply and erection of Modular case circuit breaker single pole/4 pole on existing wall/pedestal/Panel including bounding to earth and making necessary connections required to complete the job in all respect up to the entire satisfaction of the Engineer-in-charge of the work.

23.22.1.3 TRIPLE POLE MCCB 16 to 100 Amp, 25 KA

23.22.2 MCCB Enclosure made of Sheet Steel suitable for mounting MCCB of following ratings

23.22.2.1 MCCB up to 125 A FP

23.22.5 Supply and erection of miniature circuit Breaker 240/415 V in the existing distribution board including making necessary connections:-

23.22.5.1 6 amp. to 32 amp Single Pole

23.27 Supply and erection of Godrej Almirah typeM.S. pedestal made of 50 mm x 50 mm x 6 mm angle iron frame with 3.00 mm thick M.S. sheet covering including shutters with suitable hinges and locking arrangement with Godrej type handle including round bars The top covering should have downward overhang of 75 mm on all sides of pedestal having two sets of water proof ventilation holes of suitable size on the sides, at top and bottom, each set containing four Nos. holes to discharge the heat produced by the current. The shutters fixed with rubber gasket of superior quality and of suitable size to make it water proof. The pedestal duly painted both inside and outside with two coats of paint and primary coat and its legs are embeded upto the entire depth in 1:2:4 cement concrete block, projected 75 mm all around the pedestal and and 200 mm above the ground level including the cost of all labour and material required to complete the job in all respect upto the entire satisfaction of the Engineer in-charge of the work

23.27.2 M.S. pedestal of size 750 mm wide , 900 mm high , 300 mm deep and bottom totally open , duly embeded in cement concrete block of size 900 mm x 450 mm x 200 mm above ground level , having a base of size 1050 mm x 600 mm x 250 mm below ground level.

24.1 EARTHING AND LIGHTENING ARRESTOR

24.1.1 Earthing with GI earth pipe 4.5 m long and 40 mm dia with masonry enclosures on the top etc. (but without charcoal or coke and salt) as required.

24.1.2 Extra for using salt and char coal/coke for pipe earth electrode as required.

24.1.14 Supply and erection of 20mm x 3 mm thick GI, tape fixed with suitable G.I. staples of same size.

24.2.10 Supply and erection of cable route marker made of 50 cm long 10 mm dia M.S. Rod welded/riveted at the top with 10cm dia 3 mm thick MS plate inscribed with 'cable' word on it, having a cross arm 30 cm long of the same dia welded at the bottom, in exiting trench 45 cm below ground level.

24.4.8 Supply and erection of Hot Dip Galvanized octagonal pole of 3mm thickness, with base plate including cost of nut and bolts , earthing studs, Integral Cable termination arrangement 5 mm thick Bakelite base plate on suitable welded.

24.4.8.5 7 Metre Long pole with top dia 75 0mm and bottom dia 150 mm with base plate of size 300 x 300 x 20 mm

24.5.2 S/E mark double walled corrugated (DWC) HDPE, pipe 10 Kg/Cm2 ,laid 0.75 Metre below ground level including digging and refilling of earth including cost of suitable size socket/coupler for HDPE pipe including the cost of labour and material required to complete the job in all respect up to the entire satisfaction of Engineer in charge of the work.

24.5.2.3 DWC/HDPE pipe 63/50 mm outer dialinner dia

M.R. Items

NS - 1 Supply & erection of underground cable loose in existing pipe or trenches complete in all respect upto the entire satisfaction of Engineer in charge of the work.

i) 16 Sqmm 4 core cable armored

ii) 25 Sqmm 4 core cable armored

NS - 2 Supply and Erection of LED street light lumanaries of Havells make Endura CITYLINER NEOSL 70W LED or its equivalent model and specifications of Wipro/Phillips/Bajaj make with die cast housing, toughened glass IP66 with all acessories as supplied by the manufacturer with all labour and material required to complete the job in all respect upto the Entire Satisfaction of the Engineer-in-Charge of the work.

NS - 3 Supply & Erection of 65 Amp. 3 Phase automatic / digital time switch of Indo Asian make HSN code 8537 along with contactor of required capacity of Indo Asian make movement controlled by precisaty quartz osciliation operation on main supply of continue to run on built in rechargeable nickle cadium call for 150 hours in the event of power failure including cost of all petty items complete in all repsect upt the entire satisfaction of Engineer-in-Charge of the work.

NS - 4 Supply & Erection of double arm bracket made of 40mm dia G l pipe B class lSl 1.50mtr. Long with coller pipe (Gl) 75mm dia 60 cm Long top covered with ornamental cap duly welded painted 2 coats of aluminum paints on bracket and golden paint of ornamental cap including the cost of labour and petty material etc. complete in all respect up to the entire satisfaction of Engineer-in charge of the work.

DEVENDER KUMAR CONTRACTOR

Balraj Singh Contractor

Rajesh Electric Works