PROVISION OF BOOM BARRIER AND SENTRY POST FOR REAR GATE AND GTC LINK AT INS BAAZ UNDER GE(I) CAMPBELL BAY

Amount

Surface excavation n. exc 30cm deep and averaging 15cm deep and getting out in any type of soil all as directed.

Excavation in trenches not exceeding 1.5m in depth and getting out in any type of soil including cutting of roots/ branches below ground level where ever required complete all as directed.

Excavation in trenches not exceeding 1.5m in depth and getting out in hard / dense soil for foundation of poles, structs, stay rods, laying of underground cable etc complete all as directed.

Returning, filling in, including spreading, leveling, watering and well ramming in layers n.exc 25cm in hard/dense soil complete all as directed.

Removing excavated/ demolished material n exc. 50 m and depositing where directed at a level n exc. 1.5 m above the starting point.

Material & labour for PCC 1:4:8 type D2 (using 40 mm graded aggregate) in foundation and mass concrete for angle iron post completed all as specified and as directed

M&L for Pre-cast cement concrete block masonry type B1, 1:2:4, (using 20mm graded aggregate) with solid blocks, exc. 10 cm in width and setting in cement mortar 1:6, complete all as specified and directed by the Engineer In charge

M&L hard core of broken stone of gauge n.exc 63mm deposited spread and leveled in layers ,water and rammed true surfacein plinth protection/ hard standing all as directed by Engineer-in-charge.

M&L 100mm thick PCC type D-2, 1:4:8 (40mm graded stone aggregate) laid in floor sub base cement concrete surface even and smooth without using extra cement.

M&L 40 mm thick cement concrete 1 : 2 : 4 type B-1 (using 20mm graded crushed stone aggregate) laid in base, cement concrete surface even and smooth w/o using extra cement.

M&L Rendering 15 mm thick on fair faces of brick work or concrete surfaces in CM 1:6 in walls is to be finished even and smooth (with out using extra cement) all as specified & directed by the Engr-in-Charge.

M&L for 15 mm thick rendering in CM (1:4) on external surfaces surfaces finished even and smooth without using extra cement using WPC all as specified directed. Note: WPC shall be measured and paid seperately under relevant item

Supply only integral water proofing compound with ISI marked.

M&L for preparing of new surfaces and applying two coats of anti-fungal exterior emulsion paint over a coat of anti fungal primer on external surfaces of walls and ceilings/ chajjas projections complete all as specified & as directed by the Engr-in-Charge.

S&F Steel work as in tubular trusses including special shaped washers etc, complete using ERW or induction butt welded tubes conforming to IS 1161-1998 grade St 240 complete all as specified.

S&F Pre- painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws as specified complete all as specified.

S&F Pre-painted galvalume aluminum zinc coating GI based Plain steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws as specified complete all as specified.

M&L for two coats of synthetic enamil paint over a coat of red oxide zinc chrome on new surfaces of any description complete all as specified.

M&L for 75mm thick PCC type C-2, 1:3:6 (40mm graded stone aggregate) laid in plinth protection/ floor sub base cement concrete surface even and smooth without using extra cement.

M&L for 75mm thick PCC type D-2, 1:4:8 (40mm graded stone aggregate) laid in floor sub base cement concrete surface even and smooth without using extra cement as in path complete all as specified and as directed by Engineer -In-Charge.

M&L 40 mm thick cement concrete 1 : 2 : 4 type B-0 (using 12.5mm graded crushed stone aggregate) laid in base, cement concrete surface even and smooth w/o using extra cement.

M & L for forming Contraction (Dummy) joints 65mm deep X 10mm wide, filled with cealing compound grade 'B' complete all as speciefied

Supplying, laying GI tubing 50 mm dia, light grade for cable protection at road crossing/on poles and tubing sealed at both ends after laying the cables complete all as specified and as directed :- Make: Bansal / Jindal / Tata/surya/prakash.

Supply, test, erect & commissioning of Electrically operated of 4 mtr Boom Barrier of following specification:- fully raised & lowered position withlimit switches and manual Operation in case of Power failure. PCB Electronic Circuit to automatically switch off motor in case of fault., remote, warning lamp, photocell etc. Make : M/s Godrej Security Solution, M/s Matrix Security Solution or its Techno commercial equipments make duly approved by GE.

S&F Triple pole and earth encolsure with a three pin and earth plug with socket complete with one triple pole MCB 20Amps,415v, 50Hz Make : Legrand / L&T / ABB or equivalent

Supply,testing,laying and commissioning of XLPE insulated, armoured heavy duty underground electric cable with stranded aluminium conductor, 1100 volts grade of cross sectional area 16 sqmm 4 core laid in trenches / fixing on walls / poles or passing through pipe including connecting up with suitable glands, lugs, nuts and bolts wherever required and connecting end terminations to DBs/LT panel/Busbar etc complete all as specified and directed. Make : Polycab / Finolex / Gloster / Havells

M&L for Cable with copper conductor PVC round sheathed (flexible) industrial cable of 1 core 1.5 sqmm Make : Polycab / Finolex / Havells or equivalent

M & L HDPE Double Wall Corrugated (DWC)pipes,ISI marked,with outer diameter 50 mm and inner diameter 38 mm conforming to IS-14930 Part-II including necessary pipe fittings such as couplers,end caps,bends,clamps etc laid in trenches/on wall for cable protection complete for cable protection complete all as specified and directed by Engr-in-charge. Make : Ganesh / Telerex or equivalent

M&L for cutting of road,hard standing made of concrete or premix carpet, WBM,Soiling and morrum filling including excavation for laying of cable protection pipe all as directed and making good the road/hard standing by using all old/new materials and with PCC(1:2:4) etc, required to match with the existing surface complete all as specified and directed.

Earthing complete with galvanized steel earth plate electrode 600x600x6 mm thick buried directly in ground (earth pit not less than 2.25 m deep below normal ground level) with top edge of the plate not less than 1.5 m below normal ground level connected to galvanized GI wire 4 mm dia (up to 7.5m in length from earth plate) by means of bolts and nuts checknuts and washers of galvanized iron or steel all as specified and shwon in electrical plate no 5 of SSR part 1 including necessary excavation and earth work in any type of soil PCC 1:3:6 type C1 chamber with RCC 1:2:4 type B1 40 mm thick cover with MS bar 8mm dia 150mm c/c reingorcement, watering funnel 15mm dia light grade for protection of earth electrode 20mm dia for watering all as speicified and directed and tested on completion.

RSL Construction

M/S RAJBUILDERS

Govinda Swamy Construction

M/s Gurunath Construction

MAHESWARI CONSTRUCTIONS

SSP ENGINEERING

M/S PANNER SELVAM