PROVN OF WIDENING OF ROAD AROUND RAMAN STADIUM OF SIKH LI REGT CENTRE UNDER AGE (I) FATEHGARH

Amount

M&L for earth work in excavation by mechanical means (Hydraulic excavator) means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and lift upto 1.5 m complete all as specified and directed.

M&L for rolling and consolidating formation surfaces in cutting with power roller exc. 8 tonne but n. exc. 12 tonne complete all as specified and directed.

M&L for soling (or sub base) 150 mm thick (spread thickness) with broken boulders or quarried stones, interstices filled, surface and rolled and consolidated to required gradient and camber complete all as specified and directed.

M&L for WBM 150 mm thick compacted thickness in two layers of 75 mm each with course aggregate of grading II (63 to 40 mm) size, spread, leveled and rolled and consolidated to required gradient and camber using limestone, sand stone, flint or quartzite complete all as specified and directed.

M&L for preparing unsurfaced WBM surface by wire brushing with wire brushed for removing caked mud etc sweeping with brooms and finally fanning the cleaned surface with gunny bages to remove all loose dust etc on unsurfaced WBM complete all as specified and directed.

M&L for applying evenly a tack coat with bituminous primer (paving bitumen VG-30) @ 10 kg per 10 sqm over the prepared surfaces by mechanical sprayer complete all as specified and directed.

M&L for premix bituminous macadam (consolidated thicked 75 mm or less) with 4% binder content using paving bitumen VG-30 grade by weight of total mix laid / rolled and compacted to required camber and gradient complete all as specified and directed. Note :- (a) Premix Bituminous macadam shall be obtained from hot mix plant and spreading shall be done with mechanical paver and hand mix (where required) and asphaltic dense concrete work shall be done within 48 hours after completion of rolloing and consolidation of bituminious macadam. (b) Contractor shall quote his rate on the basis of binder as mentioned in above item if there is any variation in the actual binder content used in lower side, the rate shall be adjusted @ Rs.45/Kg. However no price adjustment shall be made if the binder content works out to more than as specified in Sch 'A'

M&L for applying evenly a tack coat with bituminous primer (paving bitumen VG-30) @ 5 kg per 10 sqm over the prepared surfaces by mechanical sprayer complete all as specified and directed.

M&L for 30 mm thick (consolidated average thickness) bituminous semi dense asphaltic concrete with 5.5% binder content by weight of total mix rolled and compacted using 8 to 10 tonne capacity power road roller to achieve the required compaction camber and gradient complete all as specified and directed.

M&L for providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement : 3 coarse sand) including making joints with or without grooves (thickenss of joints except at sharp curve shall not to more than 5 mm) including making drainage opening wherever required complete all as specified and directed.

M&L for preparation of new surface of concrete and applying two coat of synthetic enamel paint over a coat of primering paint plaster coat on concrete surface over 10 cm width or girth not otherwise described complete all as specified and directed.

M&L for preparation of road surface and applying thermplastic reflective paint for marking of minimum 2.5 mm thick single coat as a centre line or edge line etc road marking of 150/100 mm width using "HOT MARK" thermoplastic paint (hot application) white / yellow by indigenous modern propelled road marking machine as directed including all ingredients such as bider, glass beads, titanium dioxide, calcuim caronatre, inter filler ete thermoplastic requirement for glass beads shall be conforming to BS-6086 of MOST specification including spraying of glass beads etc complete all as per manufacture's instruction and as directed.

Supply and fixing in repair cat eye solar reflective type of metal body alloy of size 100 mm x 100 mm x 20 mm with PAMA striplans reflector of model No.DA 972 0 fixed with and including MS stud of suitale size as per manufactures instructions complete all as specified and directed.

M/S Shree Gopal Engineers & Contractor

Manu Enterprises

Yadav Builders

M/S Solanki Brothers

Gupta Automobiles