REPAIR TO ROOF OF SHEDS, FLOOR, TILING AND CERTAIN MISC WORK IN TECH AREA AT AF STN UTARLAI

Amount

Dismantling of Asbestos cement (corrugated, semicorrugated, etc.) sheets in roof coverings

S & F Pre- painted galvatume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws as specified

S & F Pre-painted galvalume aluminum zinc coating GI based Plain steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws as specified

S & F Hand rails, half round or other steel section or core for wooden hand-rail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embeding in concrete and screwing etc. wind ties for roof including securing bolts; posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 and including dismantling Complete all as specified and directed

S&F Rolled sections as in main and cross beams, hip and jack rafters purlins where connected to common rafters and running rails and guides for sliding doors; fixed with angle cleats or other connecting plates Fe-410- W(Gde- E-250) quality- B, and including dismantling, Complete all as specified and directed

M & L for preparation of new steel surfaces of any description, exc 10cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified.

M & L for preparation of new steel surfaces of any description, n.exc 10cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified.

Demolition of reinforced cement concrete (reinforcement cut as required to facilitate demolition) as in Roofs, floors (other than ground floors), beams, staircases, landing, chajjas and similar suspended work , Complete all as specified and directed.

M&L for reinforced cement concrete design mix M-25 (20mm graded aggregates) in Slabs supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves and the like, complete all as specified and directed.

Formwork to (rough finished flat surfaces of concrete ) soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work; not exceeding 200mm thick (Horizontal or sloping). complete all as specified and directed.

Formwork to (rough finished flat surfaces of concrete ) edges of concrete flats, treads, breaks in floors, window cills, concrete railings, openings in concrete walls, floor and roofs n exc 20 cm wide and sides of RCC/ PCC bands in walls, horizontal or sloping and similar work exc 10cm but n exc 20cm wide . complete all as specified and directed.

M & L for MS ,TMT bars 10 mm dia and above , cut to length, bent to shape required, including cranking, bending spirally for hooping, hooking ends and binding with MS wire (annealed) not less than 0.90 mm dia or securing with clips quality conforming to Fe-500D or Fe-550D ,complete all as specified and as directed.

M & L for 05 mm thick rendering in CM 1:3, finished even and smooth as in ceiling and applying three coats of white wash complete all as specified and directed.

Demolition of cement Concrete of any description and in any position not otherwise specifically provided for, complete all as specified and directed.

M & L PCC1:2:4 type B-1 (using 20 mm graded stone aggregate) as in coping or similar work etc including necessary form work complete all as specified and directed.

Taking down roof treatment any type any description on top of roof not exceeding 10cm thick including removal of rubbish out side MD and complete all as specified and directed

M&L for 40mm thick cement concrete (1:2:4) type B-1 using 20mm stone aggregate as in roof padding benching kerbs of mud stops, rounded or chamfered on edges including form work complete all as specified and directed

M&L for applying roof treatment on top of roof with APP modified membrane 3mm thick (minimum) with non woven polyester reinforcement (centre core) shall be laid by torch application method with overlap 100mm on length side and 100mm on width side including a coat of bituminous oil based primer ( IS : 3884) @ 250gm / Sqm weight not less than 3 kg/Sqm complete all as specified and directed

M&L for rendering 05mm thick in cement mortar (1:4) on concrete surface as on roof slab, finished even and smooth without using extra cement mix with water proofing compound as per manufacturer instruction complete all as specified and directed Note :- Water proofing compound shall be measure and paid saperately

Taking down cement plaster on brick/ concrete or stone walls, etc. including raking out joints, hacking for key, scrubbing down with water with and including 15 mm thick rendering with cement mortar 1:6 finished even and smooth with out using extra cement and applying three coats of white wash , complete all as specified and directed

Supply only Integral water proofing compound complete all as specified and directed.

Dismantling, floor, hearth or wall tiling including cement mortar bedding (but not backing), and rubbish off the premises complete all as specified and directed

M&L for non Skid ceramic coloured tiles 7 to 8mm thick (square/rectangular) area of each tile exceeding 0.11 but not exceeding 0.18 sqm, in floors and set and jointed in neat cement slurry and pointed in white or coloured cement to match shade of tiles, laid over with and including 15mm thick screed bed in CM 1:6 complete, and all as specified and directed

M&L for glazed ceramic coloured joint free tiles of size (450x300 mm) x 7mm thick in dados skirting etc set and jointed in neat cement slurry and pointed in white or coloured cement to match and including 10mm thick plaster in CM 1:4 finished even and fair complete all as specified and directed

Dismantling of Wall and ceiling boards (fibre, pulp, insulation, etc.) or insulation boards/slabs/ blankets, any thickness, including cover fillets

S&F Anodised aluminium snap grid of size 605 x 605mm frame work for false ceiling all as specified and directed. Note:- Aluminium sections and size of snap grid shall be as per clause No. 10.38 of SSR Part -1 (2009).

S&F 12 mm thick Perforated particle board/ tiles for insula-tion and accoustic purposes, 60x60 cm in size, fixed with nails to timber framework or with staples or on snap grid as in ceiling , complete all as specified and as directed.

Dismantling of pre-cast PCC block walling / brick work or stone / boulder masonry including all quoins, arches, pillars, etc. built in cement mortar or cement lime mortar complete all as specified and directed

M&L for stone walling of squared rubble, regular coursed, well bonded, bedded and solidly hearted,built in cement mortar 1: 6 complete all as specified and directed

M&L for Rendering 15mm thick in cement mortar (1:4) on brick walls or concrete surfaces, finished even and smooth without using extra cement and applying applying two coats of cement base paint over a coat of primer , complete all as specified and directed.

M&L for 15 mm thick rendering on fair faces of brick work or concrete surfaces with cement mortar 1:6 finished even and smooth with out using extra cement and applying three coats of white wash complete all as specified and directed.

Demolition of cement concrete ( unreinforced) ) in ground floors and pavings n exc 15 cm thickness (below or above ground level), and removing of debris out side the MD land Complete all as specified and directed.

M & L for cement concrete 1:4:8 type D2 using (40mm graded stone aggregate) as in sub base floor concrete complete all as specified

M & L for 40 mm thick cement concrete 1:2:4 type B-1 using (20 mm graded stone aggregate) as in floor finished even and smooth with out using extra cement, concrete complete all as specified

Removing building materials etc. to a distance of exc 5 KM including loading, unloading and stacking at the destination

M/S Tanisha Traders

Devi Engineeing

KRISHNA CONSTRUCTION COMPANY

Rasam Engg Co.

M/s Malinath Electricals