Upgradation of a room in the Department of Life Science and Biotechnology, Jadavpur University Main Campus.

Stripping off worn out plaster and raking out joints ofwalls ceilings etc. upto …..…… lead 75 m as directed. (Item No. 10, Page No. 11 of 315)

Applying two coats of bonding agent with synthetic ………… as per manufacturer's specification. [Item No. 8(a), Page No. 45 of 315]

Plaster (to wall ,floor, ceiling etc.) with sand and cement mortar ………. where necessary (Ground floor). ii) With 1:4 cement mortar a) 20 mm thick plaster [Item No. 1, 3rd Corr. Page No. 50 of 96]

Rendering the surface of walls and ceiling with whitecement based wall putty of approved make and brand (1.5mm thick). [Item No. 5/b, Page No. 204 of 315]

Supplying, fitting & fixing of Aluminium fixed partion wall of all aluminium sections viz top, bottom and sidemember, intermediate member, glazing clip made of Aluminium Alloy Extrusions conforming to IS:733-1983and IS: 1285-1975, annodized conforming to IS:1868-1983, fitted with all other accessories viz. EPDM gusket,cleat, angle screws etc. including ……… drawings and direction of Engineer-in-charge. b) For unsupported length of vertical member above 1.50m. height of both ends of vertical member restrained but panel above 0.90 sqm [Item No. 17, Page No. 246 of 315]

Providing and fixing exterior quality AluminiumComposite Panel (ACP) wall cladding on existing Al./MS frame work with GI brackets, ACP fixed on the existing frame work by folding the edges of ACP panel (Engraving the rear surface of ACP sheet) with CP angles, cleats and strainless Steel ………… per specification and direction of Engineer-in-charge. (a) 3mm thick (0.25mm Al.+2.5mm LDPE +0.25mm Al. PVDF coating) [Item No. 27, Page No. 250 of 315]

Supplying and laying true to line and level vitrified tiles of approved brand (size not less than 600 mm X 600 mm X 10 mm thick) in floor, skirting etc. set in 20 mm sand cement mortar (1:4) and 2 mm thickcement slurry back side of tiles ……… specification and direction of Engineer-in-Charge. (II) With Polymerised Adhesive [6 mm thick] & epoxy grouting materials for filling joints including spacer-2 mm (A) Deep Colour & White [Item No. 36, Page No. 66 of 315]

b) Priming one coat on timber or plastered surface withsynthetic oil bound primer ……… sand papering etc. [Item No. 1, Page No. 201 of 315]

Applying Acrylic Emultion Paint of approved make andbrand …… coats including putty (Two coats) ii) Luxury Quality[Item No. 4, Page No. 201 of 315]

A) Painting with best quality synthetic enamel paint of approved make and …...… the surface, if necessary. a) On Timber or Plastered surface. iv) Two coats.