Renovation for I.T.I Assaudha in Jhajjar District.

Amount

Distempering with washable oil bound distemper (of approve manufacture)one coat on old distempered work (HSR 16.59).

Painting one coat with synthetic enamel paint in all shades on old wood work or metallic or plastered or concrete surface to give an even shade including rubbing down old paint (HSR 16.7)

Supplying and fixing glass panes with moulding of commercial hard wood such as holloek, champ, Cherkassy and chap lash etc. (Non coniferous timber other than teak, conforming to I.S. specification No. 1003, kiln seasoned) (HSR 17.36) (c) 4 mm thick (glazing area above 55 sq dm but upto 84 sq dm of each pane)

Marble stone 20mm to 25 mm thick in risers of step, skirting ,dado, pillars and wall lining including matching the grains of marble slab in any pattern as specified laid on 12mm thick cement coarse sand mortar1:3 and jointed with white cement slurry mixed with pigment to match the shade of marble including rubbing and polishing ,including labour for fixing cramps, pms and dowels etc.(using size of marble slab above 0.38 sqm each. (HSR 14.52) (b) Black (iii) Narnaul Zebra

Kotah stone 20 mm thick in skirting risers of steps, dados, and wall facing (lining) and pillars laid on 12 mm thick cement coarse sand plaster 1:3 laid and jointed with neat cement slurry, mixed with pigment to match the shade of stone including rubbing and polishing including labour for fixing cramps, dowels & pins etc. (HSR 14.66)

Terracing consisting of tiles 22.86 cm X 11.43 cm X 3.81 cm laid over 87.50 mm mud filling on a layer of 25mm mud plaster and an other layer of mud mortar for laying the tiles , including two coats of bitumen laid hot at 1.65 kg per sqm on top of R.C.C slab including grouting with cement sand mortar 1:3 and top surface to be left clean etc.(HSR.13.13)

Providing and fixing vitrified tiles of size 600 x 600mm of approved make in flooring laid in any u pattern as specified over base of 20mm thick cement slurry mixed with pigment to match the shade to tiles. Note :- Tile shall be premium quality (first quality) of reputed manufacturer like Nitco, Kajaria, Somani, Orient & Johnsons & RAK (HSR 14.89)

Laying and fixing granite stone in all shades 15 mm to 18 mm thick in flooring, laid in any pattern as specified over a base of 20 mm thick cement coarse sand mortar 1:3 and jointed with white cement slurry mixed with pigment to match the shade of granite stone. (Excluding the cost of granite stone). (HSR 14.96)

15 mm thick cement plaster 1:6 on the rough side of single or half brick wall (HSR 15.12)

12 mm cement plaster 1:4 on walls (HSR 15.5)

10 mm thick cement plaster 1:4 under side of ceiling (HSR 15.52)

Providing two coat of exterior acrylic paint. ( HSR 16.79) (b) 1st quality

Factory manufactured solid flush door shutters, with block board core as per I.S. No. 1659-1969 bonded with water proof type phenol formaldehyde synthetic resin, hot-pressed, conforming to I.S. 2202 part I. and II, fixed in position, including iron hinges, screws, chocks/cleats and stops etc. (HSR 17.93) (a)Commercial veneering with vertical grains or cross bands and face veneer on both sides commercial facing with laminated core and lipped edges:- (ii) 30 mm thick

Conglomerate floor 50 mm thick cement concrete topping 1:2:4,(HSR.14.10)

Providing and fixing HDPE water storage tanks of sintex, Diplast, O.K. supreme make with covers/lids marked with IS:12701 on roof top of buildings including cost of hoisting and placing Iin position, making connections with inlet and outlet pipes, providing overflow and scour provisions with suitable plug on scour pipe including cost of nipples, washers, flanges for connections in tanks complete in all respects to the satisfaction to the Engineer.HSR-30.119 (a) 500 Ltr. Cap.

Providing and fixing in position 15 mm I/d C.P. brass bib cocks of best quality (as required by the engineer I charge) (HSR 30.75 c) c) Bib cock

Providing fixing PVC rain water pipe 6kg pressure of ISI mark in cement mortar during masonry work.(HSR 13.89) a) 100 mm dia PVC pipe

Providing & fixing PVC bend ISI mark(HSR 13.90)

Rajesh Kumar Contractor

Dharuv Guatam