Nagercoil Corporation Construction of Partition work in Engineering Section, Health Section and Reporter Area at Office new building

Amount

Construction of Partition work

Supplying and fixing in position of Alu. Anodised Partition with 62x38x2mm extruded box section at bottom vertical and horizontal members. The vertical member are spaced at 90 cm c/c and to horizontal members are spaced at 1.2M, 2.1M and 2.4M height the bottom panels should be covered with 12 mm thick PLB exterior grade and the top and middle panels should be fixed at 4mm thick glass thick glass with necessary glassing clips.rubber beading, etc., including necessary dismantling holes in RCC columns, beams masonry wherever necessary with power power drill ti the extent required and made good to the original conditions after fixing as directed by the departmental officers. All the Aluminium sections should be anodised to 1.5microns as per ISI specification 1868/1962.

Supplying, fabricating and fixing in position of Alumi.Anod.natural colour matt finish door half glazed and half PLB board using 12 mm thick PLB board and 5.5 mm thick glazed door using rectangular Alu.Box section of following sizes for frame and shutter with necessary accessories such as rubber beading, Al. Clips, Best double action floor springs, Aluminium Handles on both sides,floor stopper,Tower bolt, Locks and glass including all materials, Labour, power consemption charges required for fabrication if necessary chipping, dismantling making necessary holes in RCC Coloums, Beams or Masonry wherever necessary with power drill to the extent required and made good to the original conditions after fixing etc.,complete. The Alumi. surface must be anodised with matt finish under electrically controlled condition in accordance with IS specification 1868 / 1962 of Anodic filthickness of not less than 15 Microns (Fifteen) for all sections.

Providing and fixing 600mm depth shelf with doors made to shape, pattern as per drg., and Using 18 mm thick BWP plywood finishing with 1mm thick approved Laminate shown in Architect drawing.The rate shall be inclusive of supply and fixing of ebco or equivalent make hardwares like soft close type hinges,Intermediate Laminate shelves,adhesives and wastages etc, as required to be completed as per standard practice and detailed drawing

Providing and fixing Table with doors made to shape, pattern as per drg., and Using 18 mm thick BWP plywood finishing with 1mm thick approved Laminate shown in Architect drawing.The rate shall be inclusive of supply and fixing of ebco or equivalent make hardwares like soft close type hinges,Intermediate Laminate shelves,adhesives and wastages etc, as required to be completed as per standard practice and detailed drawing

Supply of plastic chairs, transportation etc

Supply of Iron chair , U type with Plastic wired

Supply and Fixing of imported office table with processed wood, transporation etc

P.C. ANTHONI MARIYA GRATAS