Augmentation of source Strengthening and Improvement of various GWSS under Jal Shakti Sub Division Chopal in Tehsil Chopal Distt Shimla HP Under JJM

Amount

Excavation in foundation,trenches (for pipes & pits) up to all depths in all classification of earth work such as pick work, jumper work, saturated soil including bailing or pumping out water, blasting soft/hard rock or chiseling soft/hard rock where blasting is prohibited in all lifts including trimming & dressing of sides, levelling of beds to correct grade i/c shoring/strutting, planking,timbering & dewatering wherever required, stacking the usable & unusable material/soil separaterly & after laying, jointing & testing of pipes, returning the useable soil in trenches in 15 Cm layers including consolidating of such deposited layer by ramming & watering & then disposing of all surplus excavated soil/unusable material as directed with in all leads & lifts including restoration of unmetalled surfaces to its original condition & including cost of diversion for traffic,night signals, fixing caution boards, crossing over trenches for access to houses, fencing etc. complete in all respects with in all leads & lifts as per directions of Engineer - in - charge.

Providing and laying cement concrete 1:4:8 (1cement: 4 sand: 8 graded stone aggregate 40mm( Forty millimeter nominal size) and curing complete excluding cost of from work in foundation and plinth with in all leads & lifts as directed by Engineer in Charge.

Prov. and laying cement concrete work 1:1 1/2: 3(1cement:1 1/2 sand:3 graded stone agg. 20mm nominal size) and curing complete excluding cost of form work and reinforcement for reinforced concrete work i/c all leads and lifts complete in all respect.:-

Foundation,footing,bases of columns & the like & mass concrete.

Walls (any thickness) but not less than 0.1 m thickness)attached pillasters,buttresses, plinth and string courses etc.from top of foundation level upto floor two level.

Suspended floors, roofs, landings,shelves and their supports balconies, beams, girders, bressumers and cantilevers upto floor two level.

Prov. and laying cement concrete work 1:1: 2(1cement:1sand:2 graded stone agg. 20mm nominal size) and curing complete excluding cost of form work and reinforcement for reinforced concrete work i/c all leads and lifts complete in all respect.:-

Foundation,footing,bases of columns & the like & mass concrete.

Walls (any thickness) but not less than 0.1 m thickness)attached pillasters,buttresses, plinth and string courses etc.from top of foundation level upto floor two level.

Providing & laying cement concrete 1:2:4 1cement:2 sand 4 graded aggregate 20mm nominal size curing complete excluding cost of form work & reinforcement for RCC work in In suspended floor roofs landing shalves & their support balconies,beams, girders bressumers cantilevers upto floor two level:- with in all leads and lifts as per the direction of the Engineer in charge.

Providing mild steel/tor steel reinforcement for RCC work including bending, binding & placing in position complete upto floor two level with in all leads and lifts as per the direction of the Engineer - in - Charge.

Providing from work steel plates 3.15 mm thick welded with angle iron in frame 30x30x5 mm so as to give a fair finish i/c centering, shuttering, strutting and propping etc. with wooded battens & ballies, height of propping and centring below supporting floor to ceilling not exceeding 4 meters and removal of the same for in situ reinforced concrete and plain concrete work with in all leads and lifts as per the direction of the Engineer-in-charge

Foundation, footings basis of columns etc. and mass concrete.

Vertical surfaces such as walls (any thickness) partitions and the like including attached pillasters, buttress, plinth and string couress and the like with in all leads and lifts as per the direction of the Engineer - in - Charge.

Flat surfaces such as soffits of suspended floor roofs landing & like floor etc.,upto 200mm thickness.

Edges of slab and breaks in floors and walls under 20cm. Wide with in all leads and lifts as per the direction of the Engineer - in - Charge.

Laying , jointing and testing in trenches Galvanised Mild Steel tube of the following dia metres including smooth bending by necessary bends, or through pipe bending machine with necessary all pipe fittings such as Tees, Elbows, Union & Reducers etc. of ISI marked & testing for leakage complete with in all leads & lifts as per entire satisfication of Engineer - in - charge. (Earth work in trenches to be measured and paid for separately)

15 mm Dia.

20 mm Dia.

25 mm Dia.

32 mm Dia.

40 mm Dia.

50 mm Dia.

Providing & fixing of Brass full way wheel valve of the following diametre including necessary all pipe fittings with in all leads & lifts as per entire satisfication of Engineer - in - charge.

15 mm Dia.

20 mm Dia.

25 mm Dia.

32 mm Dia.

40 mm Dia.

50 mm Dia.

Rahul Pandey

Satish Kumar

Jag Darshan Uniyal

Ramesh Kumar Ranaik

Devender Singh

Om Prakash Chauhan

Roshan Chauhan

Shiwang Shukla

Satish Kumar

Anurag Deep