LIFT IN CIRCUIT HOUSE RANIPET

Amount

Design, Engineering, Supply, Fabrication, Erection, Testing, commissioning and handing over of 1 no 10 persons capacity Gearless Without machine room (Glass Lift )passenger lift as per the following specifications including taxes and duties. (Make: KONE, JOHNSON /Equivalent) (1)Location: (Circuit House Building at Ranipet), (2)No of lift: one no, (3)Type of lift: passenger (Machine Room Less model ), (4)Capacity of lift: 10 persons / 544 Kgs, (5)Speed: 1.5mtr / sec, (6)Type of drive: V3F drive with enhanced ride comfort and near zero level functions, (7)No of floors: GF+1Floor, (8)Total travel: 3 .3+3.3 =6.6Mts, (9)Leveling accuracy: high level accuracy with smooth and jerk free stopping, (10)Construction of CAR: No 3 hardened sheet high quality stainless steel car and hand rail granite flooring and Perspex false ceiling, (11)Position of machine: directly above the lift well, (12)No of landing service: Front side-2 No’s, (13)No. of car entrance: one in the front side only, (14)Car entrance door: power operated automatic V3F drive center opening sliding SS door, (15)Landing entrance door: power operated V3F drive center opening sliding SS door with provision for emergency exit key at all landings, (16)Size of Lift Well 2200 X 2200 X (MM Wide * MM Depth), (17)Lift pit:1600 mm, (18)Lift Car Inside Size 1300 X 1350 X (MM Wide * MM Depth), (19)Clear opening of Gates / Doors / Lintel : 1000 X 2000 (MM Wide * MM Height) Lintel - 2100 mm, (20)Lift machine room size: Nil, (21)Power supply: AC 3 PHASE, 50 CYCLES, 415 VOLTS ±10%, (22)Control: micro computer (micro processor):based simplex collective control with / without attendant, (23)Car fittings: CFL lighting with 1 no 300 mm sweep cabin fan.,

(24)Lift well: RCC construction with brick masonry to be constructed by PWD civil wing, (25)Induction: UP / DOWN digital direction and position indicator for all landings and inside the car, (26)Emergency alarm bell: battery operated bell to be provided with automatic charging, device, (27)Emergency light: battery operated light to be provided with automatic charging device, (28)Fire mans switch: to be provided at the GF, (29)Minor builder works: to be provided by the lift contractor, (30)Scaffoldings: to be provided by the lift contractor, (31)Sill angles and facia plates: SS to be provided by the lift contractor, (32)Steel for lift machinery: to be provided by the lift contractor, (33)Servicing and maintenance: free comprehensive servicing and maintenance for one year Guarantee period to be provided by the lift contractor, (34)Automatic rescue device: to facilitate the landing of the nearest floor at the time of power failure this shall consist of suitable battery system with charger inverter under voltage protection system etc. complete with all accessories, (35)Provision for intercom with phone: to be provided by the lift contractor, (36)Lift license: preparation of drawings payment of charges to CEIG and insurance policy if any and obtaining CEIG approval for the lift as per lift act should be done by the lift contractor, (37)Floor position announcer: to be provided by the lift contractor, (38)Special features a) Infra red door sensor with full height screenb) Full width half height rear panel mirrorc)Tubular SS hand rail in car d) Stainless steel signal features e) Vandal proof SS button with SS coverf) SS door frames for landing doors g) V3F door operator h) Call register signal,

(39)Over speed governor phase failure and phase reversal relay alarm bell T guide brackets for car and counter weight rubber padding under the winding unit motor of adequate capacity signal reduction worm gear electromagnetic brake with compression springs car safety gears buffers electro mechanical locks emergency key side supporting angles motor over load protection devices final limit switch main suspension ropes counter weight lifting joist for mounting the machineries, (40)Guarantee: guarantee at least for one year for the material and workman ship of equipments should be offered by the lift contractor, (41)Site testing in accordance with IS 14665 should be carried out at the time of handing over to the user department, (42)Supply operation and maintenance manual and necessary tools for operation and a set of Spare parts required for one year. ( Make : KONE, JOHNSON / Equivalent )

Supply and run of 1 of No.8 SWG copper wire in suitable PVC rigid pipe on wall and ceiling for earth connection

Earthing as per the ISI specification with an earth electrode of 2.1mt class 'B' GI pipe of dia not less than 40mm, with copper earth plate of size 125mm x 50mm x 6mm, with necessary funneling arrangements with necessary masonry work and with 38mm RCC cover slab for the brick masonry .

R BALAMURUGAN (BID ID -1163324)

R. Gunasekaran (BID ID -1163371)