MTPS II CHP II Replacement of Oil Seal in B3 400 Gear box Ratio 20 9 1of Make Ms Premium Energy Transmission in Conveyor 7 2 at DH 1

Amount

Charges for decoupling gear box from head pulley slow speed coupling, removing SC-10 flexible element, and brake assembly from bed. Draining oil from gear box, removing gear box bed bolt, removing the cooling fan cover from input shaft, leading and lifting the gear box from the bed including required consumables and hire charges for T&P’s etc.,

Charges for arranging supporting plates of fixture to the required position. Providing 50/100 Tonne hydraulic jack on the fixture and tighten its bolt and nuts, heating the slow speed coupling fitted with the output gear shaft assembly by using gas cutting torch, removing the coupling from the gear box output shaft and remove the fixture plate, hydraulic jack and coupling from the fixture including required consumables and hire charges for T&P’s etc.,

Charges for arranging supporting plates of fixture to the required position providing 50 Tonne hydraulic jack on the fixture and tighten its bolt and nuts, heating the brake drum fitted with the input gear shaft assembly by using gas cutting torch & hydraulic jack, removing the brake drum from the gear box input shaft. Remove the fixture plate, hydraulic jack and brake drum from the fixture including required consumables and hire charges for T&P’s etc.,

Charges for measuring and preparing input shaft, transporting of waste oil about 1 barrel available at site, heating the released brake drum brake in oil bath by fire wood to the required temperature, lifting, positioning and shrink fit the brake drum with the gear box input shaft. After cooling, the waste oil stored in drums and kept inside the site including required consumables and hire charges for T&P’s etc.,

Charges for cleaning the (spiral bevel input pinion, spiral bevel wheel and it is bearing & oil seals) dismantling the input assembly, removing the input bearing by using special type of puller inspecting the spiral bevel input pinion, spiral bevel wheel input bearing and oil seal, replacing if required including charges for Input oil seal anabond, other required consumables and hire charges for T&P’s etc.,

Charges for arranging the chain block, leading, lifting the gear box after assembling the slow speed coupling on output shaft and brake drum on input shaft of the gear box and positioning the gear box on the bed, filling SP 460 oil to the required level including required consumables and hire charges for T&P’s etc.,

Assembling the gear box in position and alignment work which includes assembling the gear box in the bed, mounting the coupling in position and alignment with the motor including required consumables and hires charges for T&P’s etc.,

Chennai Radha Engineering Works (P) Ltd.

ANBU ENGINEERING INDIA PRIVATE LIMITED