PROVN OF ARTIFICIAL RECHARGE STRUCTURES FOR RAIN WATER HARVESTING SYSTEM NEAR CB LINE AREA SINGLE OFFR AND ADM BLOCK UNDER GE MIS MHOW

Excavation in trenches n. exc 1.50m wide and n. exc 1.50m in depth in any type of soil for foundation, etc or for shafts, wells, cesspits, manholes, pierholes, etc and getting out complete all as specified and directed.

Excavation in trenches exc 1.50m wide and n. exc 3.00m in depth in any type of soil for foundation, etc or for shafts, wells, cesspits, manholes, pierholes, etc and getting out complete all as specified and directed.

Returning filling in any type of soil including spreading levelling watering and well ramming in layers n. exc 25cm thick complete all as specified and directed.

Removing excavated material to a distance exc 100m and depositing where directed at a level n. exc 1.50m above the starting point complete all as specified and directed.

M&L for brick work with modular size flyash bricks straight or curved on plan exc 6m mean radius built in CM (1:4) complete all as specified and directed.

M&L for RCC (1:2:4) type B-1, using 20mm graded stone aggregate as in slabs, shelves supported on walls, beams and columns in floor or roof including balconies, canopies, deck slabs or in Chajja/facia projection and the like complete all as specified and directed.

Use and waste of formwork to soffits of suspended slab such as roof slab and similar work n. exc 200mm thick (horizental or sloping) rough finished flat surface complete all as specified and directed.

S&F mild steel framed work as in framed work as in doors or gates of angle or manhole cover, other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering, doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing comp in manhole cover frames conforming to Fe 410-W (Gde-E-250) quality 'A' complete all as specified and directed.

S&F mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed.

S&F mild steel bars (TMT bars) 5mm dia and over upto and including 10mm dia in strriups, spacers, nibs and binders complete all as specified and directed.