REPAIR/MAINT OF FENCING, BOUNDARY WALL, GATES AND SEWAGE SYSTEM IN VARIOUS ZONE AT TALBEHAT MIL STN

Amount

Taking down cement or lime plaster on brick walls incl. raking out joints, hacking for key, scrubbing down with water etc. complete all as specified and directed.

M&L for Rendering 15mm in CM 1:4 with liquid water proofing compound on fair faces of brick wall or concrete surfaces finished even and smooth without using extra cement complete all as specified and as directed.

Material and labour for 15-25 mm thick ready mix plaster in multy layer with liquid water proofing compound on fair faces of brick wall or concrete surfaces, finished even and fair, including use of scaffolding, for height of bldgs complete all as specified and directed.

Supply only integral water proofing compound complete all as specified and directed.

Demolition of cement concrete of any description and in any position not otherwise specifically provided for complete all as specified and as directed. Note: All debris obtained from demolition shall be removed 1.5km to 2km complete all as specified and as directed.

M&S Rubber mould precast concrete interlocking paver block with grey cement pigment any shape and size of 60 mm thickness, M-35 Grade of approved quality,laid over and include 50mm thick sand cushion vibtrated with mecanical vibrator complete all as specified and as directed.

Machine pressed precast concrete interlocking paver block with grey cement pigment any shape and size confirming to IS 15658-2006 of 80 mm thickness, M- 40 Grade of approved quality,laid over and include 50mm thick sand cushion vibtrated with mecanical vibrator complete all as specified and as directed.

M&L for Chequered cement concrete tiles 30cmx30cmx25mm thick, set, jointed and pointed in neat cement slurry in floors with grey cement and pigments over 15mm thick screed bed in CM 1:6 complete all as specified and as directed.

M&L PCC (1:3:6) type C-2 using 20mm graded stone aggregate 75mm thick as in plinth protection finished fair even laid in alternate bays n.exc 2m in length all as specified and directed.

M&L for 600mm dia Reinforced concrete pipes, class NP2, laid and jointed complete with collars and laid in trenches complete all as specified and as directed.

M&L for PCC 1:4:8, type D-2 using 40mm graded stone aggregate as in foundations, fillings, mass concreting complete all as specified and directed.

Demolition of brick work or stone / boulder masonary,built in cement mortar incl all quoins , pillars etc complete all as specified and directed.

M&L for brick work with old size sub class B bricks straight or curved on plan exc 6m mean radius built in CM 1:6 complete all as specified and directed.

M&L PCC (1:2:4) type B-0 (using 12.5mm graded stone aggregate) as in band,beam,benching of drain,man hole,coping,slightly rounded or chamfered angles and throating,and similar work including necessary form work surface even and smooth all as specified and directed.

Extra for forming fair finished drain or channel 30 cm inner girth in cement concrete, using ex- tra cement, including forms, moulds, mi- tred/stopped ends etc complete all as specified and directed.

Add or deduct for each 25 mm girth or part thereof over or under 30cm ditto

Excavation in trenches not exceeding 1.5 m wide and not exceeding 1.5 m in depth and getting out in soft/loose soil etc. including trimming bottom and sides of trenches, leveling/ grading and ramming bottom of excavation complete all as specified and directed.

Demolition and breaking up 150 mm dia (Salt glazed ware ,AC / CI or reinforced concrete) set in cement mortor drain pipe, jointed set in cement mortor.incl pcc if any and taking out of trenches,floor & walls if required complete all as specified and directed.

M&L for 150 mm bore SGSW drain pipe (Grade-A) laid in trenches and jointed in CM 1:1 and tested complete all as specified and directed.

M&L for concrete bed for 150 mm bore pipe in laid with PCC 1:4:8 type D-2 to drain pipes including packing under, haunching against the sides of pipes after they are laid and tested complete all as specified and directed.

Returning, filing in, including spreading, levelling, watering and well ramming in layers not exceeding 25 cm thick in soft/loose soil complete all as specified and directed.

Removing surplus excavated soil to a distance exc 250m but n/exc 500m and depositing where directed complete all as specified and directed.

S&F of Solid HDPE man hole cover of size 76cmx76cmx60mm thick with handle fitted to manhole any type complete all as specified and as directed.

Demolition of reinforced cement concrete of any description and in any position not otherwise specifically provided for complete all as specified and directed. Note: All debris obtained from demolition shall be removed 1.5km to 2km complete all as specified and as directed.

M&L for RCC 1:2:4 type B1 using 20 mm graded stone aggregate as in Slabs supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves and the like complete all as specified and as directed.

Formwork to soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work; not exceeding 200mm thick (Horizontal or sloping) complete all as specified and as directed.

M&L TMT bars 10 mm dia and over cut to length bend to shape required incl. cranking hooking ends and binding with and incl. MS wire (annealed) not less than 0.9 mm dia or securing with clips complete all as specified and as directed.

All as per Ser item No 27.00 above but 6 mm to 8 mm dia for stirrups complete all as specified and directed.

Dismantling posts or struts (wood, steel or R.C.C.) any section, including taking out embedded portion and making good disturbed concrete,brick,masonry work complete all as specified and directed.

Excavating in post holes in soft/loose soil each n. exc. 0.5 cum getting out , returning filling in and ramming earth or broken rubble mixed with earth around in layers not exc 25 cm, watering & removing surplus soil to a distance N.exc 50 m and making good surface complete all as specified and directed.

Dismanting of Barbed wire fencing or any type and size complete all as specified and directed.

S&F Galvanised. 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails strain- ing bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. as directed (each line wire to be measured) complete all as specified and directed.

S&F Hand rails, half round or other steel section or core for wooden hand-rail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embeding in concrete and screwing etc. wind ties for roof including securing bolts; posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165, complete all as specified and directed.

S&F Framed/ Unframed work as in doors or gates of angle or other section with gusset plates,rails,braces,also small article for old gates etc complete,all small articles including drilled for fixing of steel sheeting or other covering etc to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings and hanging also fastening and fixing complete all as specified and directed. Note : Gate design approved by Engineer-in-Charge/AGE (I).

S&F Welded steel wire fabric of size 25mmx25mm weight n.exc 4kg/sqm fixed to MS frame work complete all as specified and as directed.

S&F Mild steel round bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for Chain link fencing confirming to Fe 410-w (Gde E-250) complete all as specified and directed.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire complete all as specified and directed.

Supply only Chain link MS galvanisd fencing, any size or type (weight exc 2.5 Kg/Sqm) complete all as specified and directed.

S&F 10mm dia of shank Mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, each screwed end to be fitted with washers and one hexagonal or square nut, exc 5 cm but n.cex 10cm long complete all as specified and directed.

M&L for RCC 1:2:4 type B1 using 20mm grades stone aggregates as in column ,pillars,posts etc complete all as specified and directed.

M&L for RCC 1:2:4 type B1 using 20 mm graded stone aggregate Foundations, beams,plinth beams,base of column,lintel band,roof beam etc complete all as specified and directed.

Demolition of stone slab and tiles of any description or thickness in floor aprons etc laid / bedded and pointed in any mortar complete all as specified and directed.

M & L for 20mm thick Granite (Z black) work (table rubbed and polished) in steps, jambs, pillars, window-cills, cooking plat forms and like in cement mortar (1:4) including pointing in white cement (1:2) us ing marble dust with admix ture of pigment to match with shade of granite complete all as specified and directed.

Moulding as In/Outer edge of granite stone complete all as specified and directed.

Formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams,sides and soffits (if any) of foundation and plinth beams;and similar work; vertical or to batter complete all as specified and directed.

Form work to sides of pillars,posts ,columns (square/rectangular)or any other shape for fair finished surfaces complete all as specified and directed.

S&F in repair Aluminium composite panel sheet 3mm thick PVCF wooden or plain finished of brand name 'Euro bound'/"Alstrong"./ "Viva" fixed with necessary aluminium tube of size 25mm x 38mm x 1.5mm thick with required cilicon & screw as in ceiling/coloumns and in vertical surface complete all as specified and directed.approved sample as kept in AGE(I) Office complete all as specified and directed.

Dismantling of floor hearth/wall tiles including cement mortar bedding (but not backing) and removing serviceable tiles. and removing debris out of MD land all as specified and directed.

M&L for exterior wall tiles 6 to 8 mm thick area exceeding 0.06 sqm but not exceeding 0.18 sqm each tiles etc set & jointed in cement and pointed in coloured cement to match the shade of tile and including 10mm thick rendering or backing layer in cement mortar 1:4 complete all as specified & directed.

Material and Labour for heavy duty outdoor vitrified tiles dark or light shade /double charge /ultra charged 16 mm thick (square/ rectangular) polished, area of each tiles not exceeding 0.36 sqm in floors etc. set and jointed in neat cement slurry and pointed in white or coloured cement to match shed of tiles over and including 20 mm thick screed bed or bedding layer in cement mortar 1:6 complete all as specified and directed.

S&F for polymeric HDPE LED Kerb stone of size 50 cm x 20 cm x 15 cm joint in cement mortar (1:6 ) and struck flush including load carry capacity 800 kg LED strip length 465 mm operational voltage reqd 36 volts with 2 nos connectors (1 male 1 female) and 5 N0 foundation rods dismentling of old PCC kerb stone coloured of kerb stone approved by GE complete all as specified and directed.

S&F for SMPS LED Kerb stone driver output 9.7 a, 36 v with 16 A double pole MCB and junction box (brand Sintex) complete all as specified and directed.

S&F in repair galvanised, concertina coil of 610 mm dia made of 0.5 mm thick 19 mm wide strip and 2.59 mm dia high tensile wire 125 Nos of clips having 50 Nos of circle and covering 6 running metre and 5 clips per spiral using a cerntar core of high tensile wire around which a tape of rezor sharp barbes machine crimped etc complete all as specified and directed.

Providing precast cement concrete louvres and jallies, 1:2:4 type B0 using 12.5mm grades stone aggregates 40mm thick set in cement mortar (mea sured solid), 1:4 including all mould- ings but excluding frame (Pre cast frame shall be measured separately) complete all as specified and directed.

M & L for preparation of new steel surfaces of any description not otherwise described over 10 cm width or girth and applying two coats of synthetic enamel paint over one coat of red oxide zinc crome primer complete all as specified and directed.

M & L for preparation of new steel surfaces of any description not otherwise described n.exc10 cm width or girth and applying two coats of synthetic enamel paint over one coat of red oxide zinc crome primer complete all as specified and directed.

M&L for preparation of newly plastered surfaces of walls and applying two coats of cement base paint over a coat of cement primer complete all as specified and as directed.

M&L for preparing of surfaces of walls by washing rubbing down & stopping of painted surfaces and applying one coat of cement base paint, in any colour complete all as specified and as directed

M&L for preparation of plastered surfaces of wall and applying one coat of weather proof exterior emulsion paint complete all as specified and as directed.

HARNAM SINGH ANIL SINGH (BID ID -3075414)

M/S A.R BUILDERS (BID ID -3083379)

M/S Kharya Associates (BID ID -3076606)

M/S SHIVA TRADERS (BID ID -3083511)