Repair of crane bay building at 220 kv sub station Jamsher

Amount

Regrading terracing of mud plaster covered with tiles or bricks in cement by dismantling tiles or bricks, removing mud plaster, preparing the surface of mud plaster to proper, slope, relaying mud plaster Gobri leaping and tiles or bricks grouted in cement mortar 1:3 (1 cement and 3 fine sand)

Cement concrete 1:2:4 gola10cm x 10cm concave quadrant along junction of roofs with parapet wall finished smooth, where specially specified.

Replacement of worn out tiles with new one

Providing and fixing Polythene sheet 250 MICRON

Scraping of Cement Plaster

12.5mm thick cement plaster 1:4

Extra for plastering exterior walls of height more than Third storey from ground level for every additional height of single storey or part thereof.

Removing Doors and Windows (Steel or wood) with chowkhats by making recesses in walls when the wall is not to be dismantled

Dismantling cement conglomerate floors (25mm to 50mm) thick with concrete base

Cement Concrete 1:8:16 with 40mm gauge stone aggregate.

Conglomerate floor 50mm thick cement conc. Topping 1:2:4

Providing and fixing aluminium work for doors, windows, ventilators and partitions with extruded built up standard tubular sections/appropriate z sections and other sectionsJindal, Hindalco, Mahavir or equivalent make approved by Engineer in Charge For fixed portion and chaukhats

For shutters of doors, windows & ventilators including providing and fixing hinges/pivots and labour for fixing of fittings wherever required including the cost of PVC Plug / neoprene gasket required

Providing and fixing 12mm thick prelaminated particle board flat pressed three layer or graded wood particle board in paneling fixed in aluminium doors, windows shutters and partition frames with C.P. brass / stainless steel screws etc. complete

Providing and fixing of 5mm thick plane glass

Cost of Aluminium fittings complete for doors, windows such as tower bolts, handless and screw etc. for these fittings (Excluding sliding bolt)

Wiring fan point without fan box in PVC insulated copper conductor single core FRLS cable (ISI marked) overall 1.5 sq. mm, 1100volts grade with step type electronic fan regulator 100watts.

Wiring light point in PVC insulated copper conductor singl core FRLS cable (ISI marked) overall 1.5 sq. mm, 1100volts grade.

Wiring 3 pin 6 Amp. wall socket (Shuttered) point in PVCinsulated copper conductor single core FRLS cable (ISI marked) overall 1.5 sq. mm, 1100volts grade complete wit\ FRLS cable (ISI marked) overall 1 sq. mm, 1100volts grade.

Wiring 3 pin 16/20 amp. power plug control (shuttered) and switch.

PVC insulated copper conductor single core FRLS cable (ISI marked) overall 2.5 sq.mm, 1100volts grade

PVC insulated copper conductor single core FRLS cable (ISI marked) overall 4 sq.mm, 1100volts grade

Supply and Erection of Heavy gauge PVC conduit pipe 25mm dia. (ISI marked 2mm thick) Flushed

Supplying and Erection of Miniature circuit breaker single pole 0.5 to 4amp. (Breaking capacity 10kA, Curve-C) suitable for 240/ 415 volts 50cycles AC supply

Wall painting with plastic emulsion paint of approved brand and manufacturer to give an even shade (two coats)

Preparation of plastered or concrete surface for painting (including sand papering the surface) using ready mixed cement based wall putty by applying two coats to get required finish

Finishing walls with acrylic smooth exterior paint of required shade with two coats applied @ 1.67 litre/10sqm over and including base coat of water proofing Cement Paint applied @ 2.20 Kg/10 sqm

Extra rates for white washing, distempering, painting and decorative cement based paints etc for superstructure Where any single storey height exceeding 4 mtr in height for every additional height of 2 mtr or part thereof (External or Internal)

Stripping and stacking iron sheets of a roof including ridging, flashing, eaves boards gutters and down pipes. Roof top

Add for roof trusses of iron or wood, (rafters, purling etc.) in case of item Nos. 8.10 and 8.11.

Painting two or more coats with synthetic enamel paints in all shades on old wood work or metallic or plastered or concrete surface to give an even shade including rubbing down old paint.

Extra rate for replacement of G.I sheet at height of 20 mtr

Corrugated GI Sheet roofing 0.80 mm thick fixed with galvanized iron J or L hooks 10mm dia, GI Limpot and bitumen washers complete excluding the cost of purling rafters and trusses.

Corrugated GI Sheet roofing 0.80 mm thick fixed with galvanized iron J or L hooks 10mm dia, GI Limpot and bitumen washers complete excluding the cost of purling rafters and trusses.

Supply & Fixing of Exhaust fan 18" sweep of crompton make including Louver( model- T5JB132EB) of 1x28 WT-5

Supply & Fixing Ceiling Fan 1400 mm Sweep of Crompton Make

Supply & Fixing General purpose tube fitting of Havells make of 20 watts LED

Supply & Fixing General purpose tube fitting of cropmton make on wall model no. DIL B124 14 EB9 (1*36 WATT)

Extra Carriage for carse aggregate,coarse sand

Extra Carriage for tiles

Extra Carriage for fine sand

diff. in material rate for crushed bajri 13.2mm

diff. in material rate for crushed bajri 11.2mm

diff. in material rate for coarse sand

diff. in material rate for stone metal

diff. in material rate for Tiles

PAUL AND COMPANY