REPAIR TO STEEL DOOR VENTILATORS VALLEY GUTTER RIDGE AND OTHER CONNECTED WORKS INSIDE DEPOT AT CAD PULGAON

Amount

Taking down old wooden doors (single/double shutter) of any size and any position with complete accessories including chowkat or frame all as specified and as directed.

Taking down of old wooden ventilators not exc 1.5 sqm including chowkats in any position with complete accessories and wire mesh/wire fabric complete all as specified and as directed.

S and F MS Doors made with Framed work as in doors or gates of angle or other section with gusset plates, rails,braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering,running rails and guides) and hanging; also fastening and fixing complete all as specified and as directed.

M and L mild steel flat iron as in holdfast 400 mm long embedded in PCC block with splitted ends and in braces in diagonals, hand made sliding bolts, clamps hooks and similar small work comforming to Fe-290, Gde-E-165 including drilling holes and fixing to steel doors with nuts and bolt complete all as specified and as directed.

Supply and Fix 2 mm thick Mild Steel plain black sheet in steel door and similar work cut to size, holes, punched including round headed screws with plain 40mm lap joints with riveted or welded seams including bending or turning up mitred angles etc as requried complete all as specified and as directed.

Demolition of cement concrete (unreinforced)in ground floor and paving n exc. 15 cm thickness (below above ground level) complete all as specified and as directed.

Material and Labour for PCC 1:2:4 type B1 (20mm graded stone aggregates) as in coping, bed block including necessary form work complete all as specified and as directed.

Material and Labour for rendering 10 mm thick in CM 1:6 on concrete/stone/brick surface to be finished even and smooth without using extra cement including taking down cement plaster complete all as specified and as directed.

M and L for preparation of new plastered surfaces of wall including cornices if any and applying three coat of white wash including cornices complete all as specified and as directed.

Supply and fix 4.00 mm thick plain sheet glass ordinary quality and glazing with wooden beads /oil putty, in square not exceeding 0.5 Sqm in each pane including haking out old glass pane complete all as specified and as directed.

Supply and fix in repair wire netting of galvanised steel wire 1.4 mm dia and size of mess in 25 mm fixed with tinned tacks of wire staples complete all as specified and as directed.

S & F Expanded metal weight not exc 4 kg per sqm, cut to length, bent to shape required and tying with and including annealed mild steel wire not less than 0.9 mm dia or fixed with galvanised steel stapes supplied and fixed complete to wood or steel members all as specified and as directed.

Demolition of brick/stone masonry built in cement mortar including all quoins arches,pillars and precast concrete articles complete all as specified and as directed.

Material and Labour for Walling of random rubble masonary, uncoursed well bonded, bedded and solidly hearted built in CM 1:6, complete all as specified and as directed.

All as per item No. 14 but except stone

Racking out joints/pointing to Random rubble masonary or polygonal rubble uncoursed or brought upto course as built in cement or lime mortar to received the plastering complete all as specfied and as directed.

Material and Labour for rendering 10 mm thick in CM 1:6 on stone masonry surface of internal wall finised even and smooth without using extra cement over and including dubbing out of average 10mm thick CM 1:6 complete all as specfied and as directed.

Material and Labour for rendering 10 mm thick in CM 1:4 on stone masonry surface of external wall finised even and smooth without using extra cement over and including dubbing out of average 10mm thick CM 1:4 complete all as specfied and as directed.

Dismantling of AC sheets(corrugated/semi corrugated) as in roof covering including ridges covering all as specified and as directed.

Dismantling of wrought iron or mild steel work including grills and gratings,valley gutter, ridges and MS wind ties of any description not other wise provided for all as per site requirement complete all as specfied and as directed.

Supply and Fix 6mm thick asbestos cement, corrugated or semi corrugated sheets in roofs etc fixed with 'L' or 'J' or cranked hooks bolt complete all as specfied and as directed.

All as per above item 20, here-in-before but fixing only (except sheets) Note - Old AC sheet obtained vide item No 18 above shall be reused.

Fixing only MS wind ties after fixing of AC sheet all as specified and as directed.

Supply and Fix MS wind ties flat iron of specified size for roof including all necessary drilling,bolting or reveting and similar work coinforming to Fe-290 Gde E-165 complete all as specfied and as directed.

S and F pre-painted galvalume aluminium zink coating GI based corrugated steel sheet 0.50 mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall fixed with self tapping screws 500 mm center to center complete all as specfied and as directed.

S and F pre-painted galvalume aluminium zink coating GI based plain steel sheet 0.50 mm thick of any colour having tensile strength of 550 Mpa as in ridge fixed with self tapping 500 mm center to center screws complete all as specfied and as directed.

Supply and Fix in repair 1mm thick PGI sheet with zinc coating @ 275 grams per sqm on both sides in valley gutter with 150mm lap joint water proof as directed cut to size and bent to shape turning up and down including stopped end punching holes and making with head screws to support with bitumen washers complete all as specfied and as directed.

All as per ser item no 27 here in before but fixing only except sheeting complete all as specfied and as directed.

Dismantling of plain or corrugated steel sheeting any gauge, thickness as in wall/cladding complete all as specfied and as directed.

S and F plain black 0.63 mm thick mild steel sheeting, in ridges, hips, drip and straight flashings complete all as specfied and as directed.

All as per item No. 30 here in before but fixing only except sheeting all complete all as specfied and as directed.

Demolition of concrete in ground floors and pavings n exc 15 cm thickness (below or above ground level) all as specified and directed.

Material and labour for 100mm thick PCC 1:2:4 Type B1 using 20mm graded stone aggregates as in floor laid in bays including finished even and smooth without using extra cement and including spike rolling to surfaces or making impressions of expnded metal whilst the concrete is green complete all as specfied and as directed.

Forming 12 mm thick expansion joints filled with pre-formed bituminous filler and top 30 mm primed and sealed with sealing compound , Grade 'A' ( thickness of concrete slab is 100 mm ) complete all as specfied and as directed.

Material and Labour for painting with two coats of synthetic enamel paint over a coat of red oxide on new steel surfaces exc 10cm width or girth including preparation of new steel surfaces complete all as specfied and as directed.

Material and Labour for painting with one coat of synthetic enamel paint on old steel painted surfaces exc 10 cm width or girth including preparation of old steel painted surfaces complete all as specfied and as directed.

M/S JAI BHAWANI CONSTRUCTIONS

M/S Maa Durga Constructions,Pulgaon

M/s Chandak Constructions, Pulgaon

MAHARASHTRA ENTERPRISES

SHRI RANI SATI TRADERS

M/s Prakash Agencies

SHUBHAM SALES AND ENGG WORKS

Bidder Name

SHRI RANI SATI TRADERS

SHUBHAM SALES AND ENGG WORKS

MAHARASHTRA ENTERPRISES

M/s Chandak Constructions, Pulgaon

M/s Dara Constructions, Pulgaon

M/S Maa Durga Constructions,Pulgaon

M/s Prakash Agencies

M/S JAI BHAWANI CONSTRUCTIONS