CONSTRUCTION OF HUTMENT AT SITE ANKINGHAT (GDSQ) UNDER MIDDLE GANGA SUB DIVISION,CWC KANPUR

Amount

Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or10 sqm on plan), including dressing of sides and ramming of bottoms, lift upto 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed within a lead of 50 m. all kind of soil

Providing and laying in position cement concrete of 1:4:8 (1 cement : 4 coarse sand : 8 graded stone aggregate 40 mm Nominal size) excluding the cost of centering and shuttering - All work up to plinth level

Centering and Shuttering work including strutting propping etc and removal of form for

Foundations, footings, bases of columns, etc. for mass concrete )

Foundations, footing bases of column etc for Trepozoidal portion (.104*4)

Lintels Beam, Plinth Beam, girders, bressumers and cantilevers Double Beam

Columns, Pillars, piers, Abutments, Posts and struts (56*4 excluding beam area)

Rainforced Cement Concrete work in beams, suspended floors, roofs having slope up to 15 landings, bolconies, shelves, chajjas, lintels, bands, plain window sills, staircases and spiral stair cases above plinth level up to floor five level, excluding the cost of centering, shuttering, finishing and rainforcement, with 1:1.5:3 (1 cement : 1.5 coarse sand : graded stone aggregate 20 mm nominal size)

Steel Reinforcement for R.C.C work including straightening, cutting, bending, placing in position and binding all complete below and above plinth levelMild steel and Medium Tensile steel bars

Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in foundation and plinth in Cement mortar 1:6 (1 cement : 6 coarse sand)

Half brick masonry with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level Cement mortar 1:3 (1 cement : 3 coarse sand)

12 mm cement plaster of mix 1:4 (1 cement : 4 coarse sand)

Providing and fixing 1 mm thick M.S. sheet door with frame of 40*40*6 mm angle iron and 3 mm M.S. gusset plates at the junctions and corners, all necessary fittings complete, including applying a priming coat of approved steel primer using flats 30*6 mm for diagonal braces and central cross piece

Window and ventilator grill Structural steel work rivited, bolted or welded in built up section strussess and framed work, including cutting hosting, fixing in position and applying a priming coat of approved steel primer all complete

Finishing with Delux Multi surface paint system for interiors and exterious using primer as per manufactureres specification Painting steelwork with delux multi surface paint to give an even shape two or more coat applied @ 0.9 lit/ 10 sqm over and under coat of primer applied @ 0.8 lit/ 10 sqm of approved brand and manufacture

Finishing with delux multi surface paint system for interiors and exterious using primer as per manufactureres specification two or more coats applied on walls @ 1.25 ltr/10 sqm over and including one coat of special primer applied @ .75 lit/10 sqm

Supplying & filling in plinth with jamuna sand under floors including watering, ramming consolidating and dressing complete

Providing & laying in position plain cement concrete flooring with 1:2:4 (1 cement : 2 corse sand : 4 graded stone aggregate 20 mm nominal size)

Providing and laying vitrified tiles in 600*600 sizes (thickness to be specified by manufacturer) with water absorption less than 0.08% and conforming to I.S. 15622 of approved make in all colours & shade, in skirting riser of steps, over 12 mm thick bed of cement mortar 1:3 (1 cement : 3 coarse sand) joining with gray cement slurry @ 3.3 kg/sqm including grouting the joint with white cement & matching pigments etc. complete

Providing and laying ceramic glazed floor tiles of size 300*300 mm (thickness to be specified by manufacturer) of 1 st quality conforming to IS : 15622 of approved make in colours such as white, lvory, Gray, Fume Red Brown, laid on 20 mm thick cement mortar 1:4 (1 cement : 4 coarse sand), jointing with grey cement slurry @ 3.3 kg/sqm including pointing the joints with white cement and matching pigment etc. complete.

Providing and fixing 1 st quality ceramic glazed tiles conforming to IS : 15622 (thickness to be specified by the manufacturer), of approved make in all colours, shade except burgundy, bottle green, black of any size as approved by Engineer-in-charge in skirting, risers of steps and dados, over 12 mm thick bed of cement mortar 1:3 (1 cement : 3 corse sand) and jointing with gray cement slurry @ 3.3 kg/ sqm including pointing in white cement mixed with pigment of matching shade complete

10 cm thick (Average) mud phaska of damped brick earth on roofs laid to slope consolidated and plastered with 25 mm thick mud mortar mixed with bhosa @ 35 kg/cum of earth and gobri leaping with mix 1:1 (1 clay : 1 cow dung) and covered with flat tile bricks, grouted with cement mortar 1:3 (1 cement : 3 fine sand) mixed with 2% of integral water proofing compound by weight of cement and finished neat with common burnt clay F.P.S (non modular) brick tiles of class designation 10

Providing and fixing on wall face unplasticised Rigid PVC rain water pipes conforming to IS : 13592 Type A, including jointing with seal ring conforming to IS : 5382 leaving 10 mm gap for thermal expansion, single socketed pipes of 75 mm diameter

Sanitary installation

Providing and fixing white vitreous china pedestal type water closet (European type W.C. pan) with seat lid, 10 lit low level white P.V.C flushing cistem, including flush pipe with mannually controlled device conforming to IS : 7231 with all fittings and fixtures complete, including cutting and making goo the walls and floors wherever required W.C. pan with ISI marked white solid plastic seat and lid

Providing & fixing C.P. brass long body bib cock of approved quality conforming to IS standards and weighing not less than 690 gms (15 mm nominal bore)

Providing and fixing wash basin with C.I. brackets, 15 mm C.P. brass pillar taps, 32 mm C.P. brass waste of standard pattern, including painting of fittings and brackets, cutting and making good the walls wherever require White vitreous China wash basin size 630*450 mm with a single 15 mm C.P. brass pillar tap

Providing and fixing white vitreous china pedestal for wash basin completely recessed at the back for the reception of pipes and fittengs

Providing and fixing 600*450 mm beveled edge mirror of superior glass (of approved quality) complete with 6 mm thick hard board ground fixed to wooden cleats with C.P. brass screws and washers complete

Providing and fixing Chlorinated Polyvinyl Chloride (CPVC) pipes having thermal stability for hot & cold water supply, including all CPVC plain & brass threaded fittings, i/c fixing the pipe with clamps at 1.00 m spacing. This includes jointing of pipes & fittings with one step CPVC solvent cement and the cost of cutting chases and making good the same including testing of joints complete as per direction of Engineer in charge 15mm nominal outer dia pipes

Providing and placing on terrace (at all floor levels) polyethylene water storage tank, IS : 12701 marked, with cover and suitable locking arrangement and making necessary holes for inlet, outlet and overflow pipes but without fittings and the base support for tank.

Electrical Fittings

point wiring in PVC conduit with piano type switch wiring for light point/ fan point with 1.5 sq mm FR PVC insulated copper conductor, single core cable in surface PVC conduit with piano type switch phenolic laminated sheet, suitable size M.S. box and earthing the point with 1.5 sq mm FR PVC insulated copper conductor, single core cable as required

Circuit wireing in PVC conduit along with earth wire with the size 2×1.5 sq+1×1.5 sq mm earth wire

Power plug wireing for light/ power plug with 2×4 sq mm FR PVC insulated copper conductor, single core cable in surface PVC conduit along with 1 no 4 sq mm FR PVC insulated copper conductor, single core cable for loop earthing as required

Supply and fixing of 15/16 amp one way switch piano type ISI marked

Supply and fixing of Piano type 6 pin 15/16 amps socket outlet ISI marked

Supply and Fixing of 200mm×150mm×60mm deep metal box on surface or recess with suitable size of Phenolic laminated sheet cover in front including painting etc. as required

Supplying and fixing 3 pin, 5 amp ceiling rose on the exixting junction box including connections etc as required

supplying and fixing brass batten/angle holder including connections etc as required

Earthing with GI earth pipe 4.5 m long 40 mm dia including accessories and providing masonary enclosure with cover plate having locking arrangement and watering pipe etc with charcoal and salt as required

Installation, testing and commissioning ceilling fan including wireing the down rods of standard length with 1.5 sq mm FR PVC insulated, copper conductor, single core cable and earthing etc as required

ITC exhaust fan upto 450 mm sweep

Supplying and fixing 14 way, double door, single pole and neutral sheet steel MCB distribution board, 240 volts on surface complete with all accessories excluding MCB/RCCB/Isolator

6 amps to 32 amps rating MCB 10 KA breaking capacity

Supply of 48" ceiling fan complete

Supply of 6" Exhaust fan complete

Supply of 25 W CFL

Supply of 15 W CFL

Supply of Tubelight set

CHANDRAYAAN BUILDCON