supply and fixing of 16m highmast pole in bus stand opp

Amount

Supply and delivery of 16.00mtrs High mast system with all accessories mast shaft fully hot dip galvanized and should with stand wind velocity of 160km per hour the mast should included head frame SS wire rope 6mm dia double drum winch galvanized lantern carriage arrangement suitable to carry 8nos of luminaries with control gear box and flexible multi core trailing cable as specified in the relevant IS conditions with built-in non flame proof power tool for simultaneous up ward and down ward movement of lantern carriage complete as per standard specification

Supply, delivery of 200W LED Flood lighting in 16.00 mtrs high mast pole including all cost etc,. Complete as per standard specification

Supply and fixing of aviation obstruction fitting with lamp including all cost of materials and labours etc.., complete

Supply of 3,3.5,4 1.1KV grade16 sqmm armored aluminum conductor cross linked poly ethylene insulated PVC Sheathed cables conforming to IS 7098(Part 1)/1988 and As Amended there after with ISI marking including cost of materials etc., complete

Supply, laying and joining of 4 core 25sqmm armored aluminum UG cable from feeder pillar to EB service as directed by departmental officers

Supply, erection and commissioning of outdoor type pillar box made of 16 gauge MS sheet of size 600 x 450 x 200mm with angle iron support and with double door & locking key arrangements finished with anti corrosive treatment and painting mounted on Concrete bed block with M.S angles, cable entry holes and Internal Wiring with suitable capacity of Copper Conductor wire to accommodate the following componants, a) Supply and fixing of 40A 4 pole MCB-1 No for incomming supply and 32A Single pole MCB -3Nos. for out going supply. b) Supply and fixing of 40A L&T make 4Pole power contactor -2Nos. c) Supply and fixing of 0-24hrs L&T Make FM1 Model Dial Type timer d) Supply and fixing of indicator lamps.The control panel shall be pre-wired and tested and panel shall be generally confirming to I.E.rules.& Connector.

Erection and commissioning of 16.0mtrs high mast on the above saidconcrete foundation using suitable equipments.

Fixing of flood light luminaries in the lantern carriage including internal wiring using flexible copper cable complete.

Providing earth pit as per IS 3043 using GI pipe including earthwork , coal and salt and linking the same with mast and feeder pillar

Earthwork open excavation in all soils and sub soils and to full depth as may be directed except in rock requiring blasting but inclusive of shoring, strutting and baling out water wherever necessary and depositing the excavated earth within the compound in places shown by departmental officers with an initial lead of 10m and lift of 2m and clearing and leveling etc. complete complying with standard specification.

Plain Cement Concrete 1:4:8 (one part of cement, four part of Crushed Stone Sand (M- Sand) and Eight part of coarse aggregates) using 40mm size ISS HBG metal including cost and conveyance of all materials to site and including for the mixing, laying and labour charges and all incidential charges such as water providing etc., complete as per standard specification

Supplying and erecting, centering for sides and soffits including supports and strutting upto 3.29m height for plane surfaces as detailed below in all floors with all cross bracings using mild steel sheet of 90cm x60cm BG 10 gauge stiffened with welded M.S. angle of 25 x 25 x 3mm for boarding laid over silver oak joists of size 10cm x 6.50 cm spaced at about 90 cm centre to centre and supported by casurina props of 10 cm to 13 cm dia spaced at not less than 75 cm centre to centre or at suitable intervals etc. complete in all floors complying with standard specification

Supplying, fabricating and placing in position M.S. or R.T.S. reinforcements grill for RCC works as per the design given including cost of steel and binding wire etc., complete complying with standard specification.

Providing and laying in position Standardised Concrete Mix M-20 Grade in accordance with IS 456 - 2000 using 20mm and down graded hard broken granite stone jelly for all RCC items of works with minimum cement contenet of 325Kg/ cum and maximum water cement ratio of 0.55 including admixture (Plasticiser / super plasticiser) in recommended proportions as per IS 9103 to accelerate, related setting of concrete, improve workability without imparing strength and durability with about (5.0cum), 7730Kg of 20mm machine crushed stone jelly and with about (3.3 cum), 5156kg of 10 - 12mm machine crushed stone jelly and with about (4.79cum) 7670 kg of Crushed Stone Sand (M- Sand), but excluding cost of reinforcement grill and fabricating charges centering and shuttering but including laying, vibrating with mechanical vibrators, finishing, curing, etc and providing fixtures like fan clamps in the RCC floor / roof slabs wherever necessary without claiming extra cost etc., complete complying with standard specification and as directed by the departmental officers -

Refilling excavated earth other than sand compliying with standard specification including materials, labour for filling charges,consolidation etc. complete as directed by the departmental officers.

Fly ash in CM 1:5 (one cement & Five Crushed Stone Sand (M- Sand)) using fly ash bricks of size 230 x 110 x 70mm including finishing, curing, etc., complete complying with standard specification - 100CFT

Plastering with Cement Mortar 1:5 (One cement and Five sand), 12 mm thick in all floors including curing etc. complete complying with standard specification and as directed by the departmental officers.

Supply and Fixing of Black Granite Name stone including cost of all material and labour charges and transportation and fixing charges etc complete

Goods and Service Tax @ 18%

INIYA CONSTRUCTIONS (BID ID -1326110)