Special Repair of Primary Health Centre at Village Meond Kalan in Fatehabad Distt.

Amount

Earth work in excavation in foundations, trenches, etc.in all kinds of soils, not exceeding 2 metres depth including dressing of bottom and sides of trenches, stacking the excavated soil, clear from the edge of excavation and subsequent filling around masonry, in 15 cm layers with compaction, including disposal of all surplus soil, as directed within a lead of 30 metres (HSR 6.6)

Scraping of white wash and colour wash (HSR 8.32 (a)

Scrapping (c) Cement plaster (HSR 8.32 c)

Cement concrete 1:8:16 with brick ballast 40 mm nominal size in foundation and plinth (HSR 10.26)

Cement concrete 1:8:16 with stone aggregate 40 mm nominal size in foundation and plinth (HSR 10.28)

Cement concrete 1:2:4 with stone aggregate 20 mm nominal size in first storey upto 4 metres above plinth level (HSR 10.59)

Pre – cast cement concrete 1:2:4 with stone aggregate 20 mm nominal size in Kerbs and the like items, finished smooth with 6 mmthick cement plaster 1:3 on exposed surface including form work, placing and fixing in position, complete at the ground level or in first storey. (HSR 10.77)

Cement concrete 1:1½:3 with stone aggregate 20 mm nominal size for reinforced concrete work in slabs with with inclination not exceeding 25 degree with horizontal, excluding steel reinforcement, but including centring and shuttering, laid in position, complete in all respect. [HSR. 10.82 + 10.95 (a)].

First class brickwork laid in cement sand mortar 1:6 in foundation and plinth. (HSR 11.2)

First class brickwork laid in cement sand mortar 1:6 in first storey upto 4 meters above plinth level. (HSR 11.7)

Terracing consisting of tiles 22.86 cm x 11.43 cm x 3.81 cm laid over 87.50 mm mud filling on a layer of 25mm mud plaster and an other layer of mud mortar for laying the tiles, including two coats of bitumen laid hot at 1.65 Kg. per sqm on the top of R.C.C Slab including grouting with cement sand mortar 1:3 and top surface to be left clear etc. (HSR 13.13)

Cement concrete 1:2:4 gola 10 cm X 10 cm quadrant along junction of roof with parapet wall finished smooth, where specially specified. (HSR 13.64)

Providing & Fixing PVC Rainwater Pipe 6 kg. pressure of ISI mark in cement mortar during masonry work. (Note:- Reputed make PVC Pipe such as Supreme, Finolex, Prince will be used as approved by Engineer-in-charge. (HSR 13.89) (a) 100 mm dia PVC pipe 6 kg. pressure 150 mm dia. PVC pipe 6 kg. pressure

Providing & fixing PVC Bend ISI Mark (HSR 13.90) (a) 100 mm dia. PVC Bend

Conglomerate floor 40 mm thick cement concrete topping 1:2:4 (HSR 14.9)

Precast chequered tiles of 20 mm thickness in ordinary grey cement without chips laid on 20 mm thick bed of ement coarse sand mortar 1:3 with neat cement slurry between joints and over the base in floors, treads of steps and landings. (HSR 14.45)

Providing and fixing vitrified tiles of size 600x600mm of approved make in flooring laid in any pattern as specified over base of 20 mm thick cement coarse sand mortar 1:3 and jointed with white cement slurry mixed with pigment to match the shade to tiles. Note:- Tile shall be of premium quality (first quality) of reputed manufacturer like NITCO, KAJA-RIA, SOMANI, ORIENT, JOHNSONS, RAK, SIMPOLO & OASIS (HSR 14.89)

Providing and fixing vitrified tiles of size 600x600mm of approved make in skirting/dado laid in any pattern as specified over base of 12mm thick cement coarse sand mortar 1:3and jointed with white cement slurry mixed with pigment to match the shade to tiles. Note:- Tile shall be of premium quality (first quality) of reputed manufacturer like NITCO, KAJA-RIA, SOMANI, ORIENT, JOHNSONS, RAK, SIMPOLO & OASIS (HSR 14.90)

Providing and fixing 1st quality ceramic glazed wall tiles confirming to IS 15622 (thickness to be specified by the manufacturer) of approved make in all colors shades except burgundy bottle green, black of any size as approved by Engineer-in-Charge in skirting risers of steps and dados over 12 mm thick bed of cement mortar 1:3 coarse and jointed with grey cement slurry inluding pointing in white cemet mixed with pigement of matching shades complete. Size 300x450 mm. (HSR 14.92 b)

Plastering on wall 12mm thick cement plaster 1:6 (15.7)

10 mm Cement Plaster 1:4 under side of ceiling. (HSR 15.52)

Applying pink primer or aluminium priming coat on wood work including preparation of surface, knotting and stopping, etc. (HSR 16.2)

Painting two coats excluding priming coat with synthetic enamel paint in all shades of new wood work or metallic or plastered or concrete surfaces to give an even shade. (HSR 16.3)

Paiting two coats excluding priming coat with ready mixed paint for metalic surface in all shades on new steel or iron work. (HSR 16.17)

Distempering with washable oil bound distemper (of approved manufacture) two coats over one priming coat on new work.(HSR 16.58)

Provinding two coats of exterior acrylic emulsion paint (b) 1st Qlty. (HSR 16.79 (b))

Providing and applying two coats white cement based putty over plastered surface and grindling the surface smooth with sand paper to get an even and smooth finish including cost and carriage of all material, labour charges, scaffolding, sundries etc. complete. (HSR 16.81)

Factory manufactured Solid Flush Door Shutter, with block board core as per I.S. No. 1659-1969 bonded with water proof type phenol formaldehyde synthetic resin, hotpressed, conforming to I.S. 2202 part I and II, fixed in position, including iron hinges, screws, chocks/cleats and stops etc., (excluding the cost of any fittings other than specified above, but including labour for fixing the same in position. (Note:- reputed make such as Duro, Green, Kitply will be used as approved by Engineer-in-charge). HSR 17.93 (a) - Note 1 under 17.18]. Note:- The Agency to whom the work is alloted will have to produce original bill/voucher for all quantity in token of proof of purchase of material. 35 mm thick

Fe-500 EQR TMT steel bar for RCC work, where not included in the complete rate of RCC including bending, binding & placing in the position complete. (HSR 18.22) (Note:- Reinforcement shall be measured in length including hooks, if any, separately for different diameters as actually used in work, excluding overlaps. From the length so measured, the weight of reinforcement shall be calculated in tones on the basis of IS:1732.Wastage, overlaps, couplings, welded joints, spacer bars, chairs, stays, hangers and annealed steel wire or other methods for binding and placing, shall not be measured and cost of these items shall be deemed to be included in the rates for reinforcement).

Pressed steel sheet frames (chowkats), consisting of 2 mm thick steel sheet of the specified section, including iron lugs (hold fasts), iron hinges, conforming to P.W.D. specifications, including bolts for fixing stops, locknotch, provision for receiving tower bolts, and finished with one coat of ready-mixed paint red lead non-setting primer, of approved quality, fixed in position including the cost of cement concrete 1:3:6 for filling in the frame, and cement concrete 1:3:6 for lugs complete (HSR 18.34) (b) Door and window frame of size 76 mm X 38 mm with 35 mm wide single rebate

(d) Door and window frame of size 114 mm X 50 mm with 35 mm wide double rebate.

Providing for laying, jointing, fixing and testing G.I. (Medium class "B" type of Tata & Jindal make) pipe lines and specials tees bends, sockets, elbows etc. inside building and testing etc. complete including cutting threading. Including cost of Special. G.I. specials shall be of Make:- UNIK, TATA, ZOLOTO. (NS) (i) 15 mm internal diameter of pipeline

Toilet Block (3x3)

Cost of Pipe

(ii) 20 mm internal diameter of pipeline

Public Health Items Extra for fixing and jointing union couplings in G.I. and W.I. pipelines. [HSR 28.21]. (a) 15 mm internal diameter

Cost of Pipe

(b) 20 mm internal diameter

Cost of Pipe

Constructing brick masonry inspection chamber sizes as given below upto 0.60 metre average depth in cement mortar 1:5 lime concrete with 40 percent limer mortar 2:3 in foundation cement concrete 1:2:4 benching 12 mm thick cement plaster 1:2 with a floating coat of 1 mm thick of neat cement R.C.C. 1:2;4 slab 100 mm thick./C.C. topping 50 mm thick with 455 mm x 455 mm 610 mm inside light duty C.I. inspection chamber cover and frame weight as per I.S.I. specification painted with 3 coats of black bitumastic superior paint coplete as per standard design. (c) Size 600 mm x 900 mm inside (with 455 mm x 455 mm cover and frame light duty singel weighing 20 Kg with R.C.C. slab). (HSR 29.84) (a) Size 450 mm x 450 mm in side (with 455 mm x 455 mm cover and frame light duty single seal weighing 20 kg with C.C.topping)

(b) Size 450 mm x 600 mm inside (with 455 mm x 610 mm cover and frame single seal pattern I weighing 38 kg with C.C. topping)

Providing and fixing in position best Indian make (Ordinary) lavotory. Suites consisting of: for wash size 630mmx450mm with one no. tap (HSR 30.41 (v)

PROVIDING AND FIXING IN POSITION 32MM DIA. G.I. WASTE PIPE EMBEDDED IN WALL or lead waste pipe (weighing 3.47 kg per metre and 2.8 mm thick) upto floor level including cost of wipped solder joint etc., complete (as required by the Engineer-in-charge). (HSR 30.48)

Providing and fixing in position best Indian make chromium plated brass Bottle trap 32 mm dia. Metre (HSR 30.50)

PROVIDING AND FIXING IN POSITION BEST QUALITY STAINLESS STEEL SINKS WITH COMPLETE FITTINGS AS FULLY DESCRIBED IN ITEM NO. 30.51 ABOVE. (HSR 30.53) (a) 600 mm x 450 mm x 200 mm

PROVIDING AND FIXING 40 MM I/D G.I. WASTE PIPE EMBEDDED IN WALLS OR LEAD WASTE PIPE weighing 4.46 Kg./metre and 3.0 mm thick UPTO FLOOR LEVEL as required by the Engineer-in-charge INCLUDING COST OF UNION AND PLUMBER JOINT. (HSR 30.62)

Providing and fixing 40 mm i/d chromium plated brass trap with chromium plated brass pipe to wall with wall flange, complete (as per requirement of the Engineer-in-charge) for use with sinks (HSR 30.63 ) (a) With Bottle Trap (Indian make)

PROVIDING AND FIXING IN POSITION BEST INDIAN MAKE PAPER HOLDERS FIXED INTO wall with C.P. brass screws complete in all respects INCLUDING CUTTING AND MAKING GOOD THE WALLS ETC. (HSR 30.67) (a) C.P. brass

PROVIDING AND FIXING IN POSITION BEST INDIAN MAKE TOWEL RAILS FIXED in with rawlslugs embedded in walls with C.P. brass screws. Complete in all respect INCLUDING CUTTING AND MAKING GOOD THE WALLS ETC. (HSR 30.68) (a) 25 MM DIA C.P. BRASS ADJUSTABLE(i) 750 mm long

PROVIDING AND FIXING IN POSITION GLASS SHELF FIXED IN WITH RAWL PLUGS WITH C.P. BRASS SCREWS COMPLETE INCLUDING CUTTING AND MAKING GOOD THE WALLS ETC. (HSR 30.69) (a) With C.P. brass brackets and guard rail (i) 600 mm X 125 mm

Providing and fixing in position best Indian make Soap dish fixed into wall with C.P. brass screws and complete in all respects including cutting and making good the walls etc. (HSR 30.70) (a) C.P.BRASS (i) Soap dish large

PROVIDING AND FIXING IN POSITION BEST INDIAN MAKE BEVELLED EDGE 5.5 MM THICK MIRROR mounted on ASBESTOS sheet GROUND FIXED IN POSITION BY MEANS OF 4 NOS. CHROMIUM PLATED BRASS SCREWS AND WASHERS over rubber washers and rawl plug embedded in the wall or chromium plated brass clamps with C.P. brass screws (as required by the Engineer-in-charge) COMPLETE INCLUDING CUTTING AND MAKING GOOD THE WALLS ETC. (HSR 30.71) (a) INDIAN MAKE (i) 600 mm X 450 mm

Providing and fixing in position superior quality 65mm i/d opening C.P. brass dome type hinged grating weighing about 750 gms. Fixed in cement mortar 1 : 2 complete in all respects (as required by the Engineer-in-charge). (HSR 30.74)

Providing and fixing in position 15mm i/d C.P. brass bib cocks of best quality (as required by the Engineer-in-charge). (HSR 30.75) (a) Bib cock long body

Providing and fixing in position C.P. brass stop cocks (as approved by the Engineer-in-charge) (HSR 30.76) (a) 15 MM STOP COCK (ii) Concealed stop cock with flange

Providing and fixing C.P. brass liquid soap container of best quality (as required by the Engineer-in-charge). (HSR 30.77)

PROVIDING AND FIXING IN POSITION BEST INDIAN MAKE FLEXIBLE TUBE CONNECTION (HSR 30.82) (b) C.P. Brass (iii) 15 mm X 450 mm

Kuldeep Singh Contractor

Ram Niwas Contractor

SHREE GANESH TRADERS

Aman Kumar