Construction of Irrigation Division Kathua and Superintending Engineer Hydraulic Circle Kathua office building in new Irrigation Colony under Modernization of Kathua Canal Under NABARD MH-4701

Amount

Earth work in excavation by manual means over areas (exceeding 30cm in depth, 1.5m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth, lead up to 50m and lift up to 1.5m,as directed by Engineer-in-Charge. All kinds of soil.

Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundations etc. in layers not exceeding 20cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and lift up to 1.5 m.

Supplying and filling in Plinth with fine sand under Floor Level including watering damming complete including carriage.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:4:8 (1 Cement : 4 coarse sand (zone-III) : 8 graded stone aggregate 40 mm nominal size)

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:3:6 (1 Cement : 3 coarse sand (zone-III) : 6graded stone aggregate 40 mm nominal size)

Providing and laying damp-proof Course 50mm thick with cement concrete 1:2:4 (1 Cement : 2 Coarse sand: 4 graded stone aggregate 20mm nominal size)

Applying a coat of residual petroleum bitumen of penetration VG-10 of approved quality using 1.7 kg per square meter on damp proof course after cleaning the surface with brushes and finally with a piece of cloth lightly soaked in kerosene oil.

Reinforced cement concrete work in beams, suspended floors, roofs having slope up to 15° landings, balconies, shelves, chajjas, lintels, bands, plain window sills, staircases and spiral stair cases up to floor five level, excluding the cost of centering, shuttering, finishing and reinforcement, with 1:2:4 (1 cement : 2 coarse sand (zone-III) : 4 graded stone aggregate 20 mm nominal size).

Reinforced cement concrete work in beams, suspended floors, roofs having slope up to 15° landings, balconies, shelves, chajjas, lintels, bands, plain window sills, staircases and spiral stair cases above plinth level up to floor five level, excluding the cost of centering, shuttering, finishing and reinforcement, with 1:1.5:3 (1 cement : 1.5 coarse sand (zone-III) : 3 graded stone aggregate 20 mm nominal size).

Steel Reinforcement Cold twisted bars

Brick work with common burnt clay FPS (non-modualar) bricks of class designation 75 in foundation and plinth Cement mortar 1:6

Extra for brick work with common burnt clay bricks/cement concrete bricks in superstructure above plinth level upto floor five level

Providing and fixing wash basin with C.I /M.S brackets 15mm C.P. brass pillar taps , 32mm CP brass waste of standard pattern, including painting of fittings and brackets, cutting and making good the walls wherever required . White Vitreous Chiana wash basin size 600x480mm with single 15mm CP brass pillar taps

Providing and fixing white viterous china pedestal for wash basin completely recessed at the back for the reception of pipe and fitting.

Providing wood work in frames of doors windows clerestory windows and other frames wrought framed and fixed in position with hold fast lugs or with dash fasteners of required dia and length (hold fast lugs or with dash fasteners shall be paid for separately) Second class Deodar wood

Providing wood work in frames of doors windows clerestory windows and other frames wrought framed and fixed in position with hold fast lugs or with dash fasteners of required dia and length (hold fast lugs or with dash fasteners shall be paid for separately) Saal wood

Decorative plywood one side decorative veneer and commercial veneer on other face (type 1) conforming to IS 1328 BWR type Ply wood 7 ply 9mm thick

Providing and fixing M.S. grills of required pattern in frames of windows etc. with M.S. flats, square or round bars etc including priming coat with approved steel primer all complete. Fixed to steel windows by welding

Providing and fixing 35mm thick wire guage shutters using glavanised M.S wire guage of avg width for aperture 1.4mm in both direaction with wire of dia 0.63mm for doors, windows and clerestory windows with hinges and necessary screws: Second class deodar wood

Providing and fixing panelled or glazed shutter for doors windows clerestory windows including ISI marked MS pressed Butt hinges bright finished of required size with necessary screws excluding panelling which will be be paid for separately all complete as per direction of Engineer -in-charge : Second class Deodar

Providing and laying vitrified floor tiles in different sizes (thickness to be specified by the manufactures) with water absorption's less than 0.08% and confirming to IS : 15622 of approved make in all colours and shades, laid on 20mm thick cement mortar 1:4 (1 cement : 4 coarse sand) including grouting the joints with white cement and matching pigments etc., complete.Size of tile 60x60 cm

Providing gola 75x75 mm in cement concrete 1:2:4 (1 cement :2 coarse sand : 4 stone aggregate 10 mm and down gauge) including finishing with cement mortar 1:3 (1 cement : 3 fine sand) as per standard design In 75x75 mm deep chase

12 mm cement plaster of mix : 1:4 (1 cement: 4 coarse sand)

Providing and applying white cement based putty of average thickness 2mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete.

Cement concrete flooring 1:2:4 (1Cement: 2 coarse Sand : 4 graded Stone aggregate) finishied with floating coat of neat cement including cement slurry, but excluding the cost of nosing of steps etc. complete. 50mm thick with 20mm nominal size stone aggregate crushed

Painting with synthetic enamel paint of approved brand and manufacture to give an even shade : Two or more coats on new work

Finishing wall with delux multi surface paint system for interiors and exterior using primer as per manufactures specifications Two or more coats applied @1.25litre/10sqm over and including 1 coat of special primer applied @0.75litre/10sqm

Providing and laying 60mm thick factory made cement concrete interlocking paver blocks of M-30 grade with 50mm thick compacted bed of coarse sand

Applying primaring coat with ready mixed pink or grey primer of approved brand and manufacture on wood work ( Hard and soft wood)

Providing and fixing white vitreous china pedestal type water closet (European type W.C. pan) with seat and lid, 10 liter low level white P.V.C. flushing cistern, including flush pipe with manually controlled device (handle lever), conforming to IS:7231, with all fittings and fixtures complete, including cutting and making good the walls and floors wherever required: W.C. pan with ISI marked white solid plastic seat and lid.

Providing and fixing G.I. inlet connection for flush pipe connecting with W.C. pan.

Centering and shuttering including propping , strutting etc. and removal of form work. i. Foundation

Coloumn, pillars, pipers, abutments , posts and struts.

Lintel Beams

Suspended floors, roofs landing, balconies and acess platforms, Slab

Edges of slab and breaks in floors and walls under 20 cm wide.

Stairs (excluding landings ) except spiral Staircases

Providing and fixing PTMT waste coupling for work waste wash basin and sink approved quality and color waste coupling 31mm, 79mm legth 62 breadth and weigthing and less than 45gms

Providing and fixing C.P. brass long nose bib cock of approved quality conforming to IS standards and weighing not less than 810gms. 15 mm nominal bore.

Providing and fixing CP Brass 15mm angle ball size Bottle Trap of approved quality & make and as per the direction of Engineer-in-charge.

Providing and placeing on Terrace ( at all floor levels Polyethenylene water storage ISI : 12701 makred indicating the BIS License No. with cover and suitable locking arrangement and marking necessary holes for inlet, outlet and overflow pipes but without fittings and the base support for tank (Sintex, Electroplast, Star, Lotus or equivalent having vailed license.)

Providing and fixing 15 mm nominal bore C.P. stop cock (concealed) of standard design and of approved make conforming to IS : 8931

Providing and fixing PTMT Bottle Trap for wash basin and sink. Less than 260gms

Providing and fixing mirror of superior glass (of approved quality) and of required shape and size with plastic moulded frame of approved make and shade with 6 mm thick hard board backing.Rectangular shape 453x357 mm

Providing and fixing SS AISI-316 Grade Napkin Ring (Round)complete with brackets fixed with CP brass screws PVC sleeves etc. Complete: 200 mm dia .Model No- SDA-055 , of KICH or equivalent,.(Make: Kich/Jaquar/Cardin

Providing and fixing white viterous china flat back or wall corner type lipped front urinal basin of 430x260x350mm and 340x410x265mm sizes respectively with automatic flushing cistern wiith CI /MS brackets standard size of GI flush pipe and CP brass spreaders with brass unions and GI Clamps complete, including painting of fittings and brackets , cutting and making good the walls and floors wherever required : Range of three urinal basins with 10 L PVC white automatic flushing cistern of approved quality

Providing fixing brass ferrule with C.I. mouth cover including boring and tapping the main : 15 mm nominal bore

Providing and fixing Chlorinated poly vinyl chiloride (CPVC) pipes having thermal stability for hot and cold water supply including all CPVC plain and brass threaded fittings , this included jointing of pipe and fittins with one step CPVC solvent cement, treanching, refilling and testing of joints complete as per direction engineer -in-charge (External work) a) 20mm nominal outer dia pipes

b) 25mm nominal outer dia pipes

C) 15mm nominal outer dia pipes

Constructing soakpit 1.20mx1.20mx1.20m filled with brickbats including SW drain pipe 100mm dia Meter 1.20m long complete as per standard design.

Providing and fixing plain bend of required degree: Sand cast iron S&S as per IS: 3989

Providing and fixing PVC waste pipe for sink or wash basin including PVC waste fittings complete Flexible 40mm dia

Providing and fixing soil,vent pipes 100mm dia cerntrifugally cast (spun ) iron S&S Pipe as per IS : 3989.

Mortice latch and lock 100x65mm with 6 levers and a pair of brass lever handles

125mm MS handles

150mm MS hooks and eyes

100mm MS hooks and eyes

Oxidise mild steel sliding door latch 250x 20 x 6mm

Providing and fixing collar 100mm dia Sand cast Iron S&S as per IS : 3989.

supplying and fixing C.I Cover without frame for manholes 500 diameter C.I Cover (Medum Duty ) the weight of the cover to be not less than 58 Kg.

Providing and fixing MS tube hand rail of approval size by welding etc. to steel ladder balcony railing staircase railing and similar works including applying primining coat of approved steel primer

Anodised aluminium sheet 2.5MM thick (anodised transparent or dyed to required shade according to IS 1868 Minimum andodic coating of grade AC 15).

Wiring for light/power plug with 2x4 sqmm FRLS PVC with 1.5 sqmm FRLS PVC

Wiring for main circuit/sybmain wiring along with earth wire 2x2.5 sqmm + 1x2.5 sqmm earth wire

2x6 sqmm + 1x6 sqmm earth wire

2x16 sqmm + 1x6 sqmm earth wire

Supplying and fixing of following sizes of medium class PVC conduit 25mm

Supplying and fixing of following modular switches/modules class GI box 1 or 2 Module

3 Module

4 Module

6 Module

Supplying and fixing following modular switches/socket 5/6 A Switch

3 pin 5/6 A Switch

15/16 A Switch

6 pin 15/16 A Socket outlet

Supplying and fixing two module stepped type electronic fan regulator on existing modular sheets

Supplying and fixing suitable size 20A, 240V, SPN industrial type sockets

Supplying and fixing call bell/buzzer

Supplying, laying and fixing 100mm dia GI pipes in ground complete

Supplying and fixing 5A to 32A rating, 240/415V, 10KA C curve Single pole

40Amp SPN

63Amp SPN

Supplying and fixing following way horizontal type single pole and neutral sheet steel, MCB distribution board 240V 16 way double door

Supplying and fixing LT switchgear power control panel floor/wall mounted indoor type

MCCB 200Amp 36 KA FP ICU=ICS=100%

Aluminium bus bar 300Amp 4 strips

Changeover switch 150Amp

SITC of Surface 12W LED ceiling mounted light fixture including connections etc

Supplying and fixing of LED street light 75W complete with GI pipe with controlling switch

Supplying and fixing of 1200mm sweep 3 blade energy efficient

laying of 1 no. PVC insulated power cable of 1.1KV Above 95 sqmm to 185 sqmm direct in ground including refilling

End termination with brass compression glands 3.5x120 sqmm

Supplying of multicore stranded/solid conductor 3.5mmx120 sqmm

Earthing with GI earth plate 600mmx600mmx600mm

Providing and fixing 25mm x 5mm GI strip on surface

Supplying and drawing following sizes of FRLS PVC insulated copper conducter 1x1.5 sqmm

3x2.5 sqmm

3x4 sqmm

3x6 sqmm

Supplying and fixing of following Electrical items : a) LED bulb 20W b) LED bulb 30W

Supplying and fixing of following Electrical items : b) LED bulb 30W

Carriage of sand & Bazari Av. 10 Km by MT .

Carriage of Brick av. 10Km by MT

Miscallances items ( Hinges, Bolts admixture, Main Gate Faucet).

M/S NARESH KUMAR SHARMA

GARIB PERVER DUTT