SPECIAL REPAIR TO BDY WALL ALONGWITH SWAN NECK FENCING INCL CONCERTINA COIL AT DILKUSHA COLONY AND GAUR ENCLAVE AND PROVN OF SEPTIC TANK AND SOAK WELL AT BLDG NO 4 TO 9 THIMMAYA MARG UNDER GE (WEST) LUCKNOW

Amount

Demolition of brick or stone boulder masonary, built in cement mortar including all quions, arches, Pillars etc but excluding ashlar facings, dressed stone work and precast concrete articles all as specified and directed.

Demolition of cement concrete (reinforced) such as lintels, roof, shelves, manhole cover, chajjas and similar suspended work not exc 15 cm thickness below or above ground level complete all as specified and directed.

Demolition of (RCC jalis) precast concrete articles, set in cement mortar complete all as specified and directed.

Dismantling fencing wire mesh, any type all as specified and directed.

Dismantling posts or struts (wood, steel or R.C.C.) any section, including taking out embedded portion and making good disturbed ground complete all as specified and directed.

Material and Labour for brick work with fly ash bricks old size , straight or curved on plan, exc 6m mean radius, built in CM 1:6 complete all as specified and directed.

M & L Brick work, with fly ash bricks, straight or curved on plan to any radius as in half brick thick walls built in CM. 1:4 using old size brick complete all as specified and directed.

Taking down cement or cement lime plaster on brick or stone walls etc. including raking out joints, hacking for key, scrubbing down with water, etc complete all as specified and directed.

Material and Labour for rendering 15 mm thick cement plaster in CM 1:4 with water proofing compund (@ 3% by weight of cement) on fair faces of brick work or concrete surface and finishing the surface even and smooth without using extra cement all as specified and directed. (Note:- Water proofing compound shall be measured and paid seprately.)

Supply only integral water proofing compound conforming to IS 2645 complete all as specified and directed.

Reinforced cement concrete (nominal mix) type B-1 1:2:4 (using 20mm graded stone aggregates) Beams, cantilevers, bressummers, lintels over 1.5m span complete all as specified and directed.

Material and Labour 10mm dia mild steel TMT bar, cut to length, bent to shape required including cranking, bending spirally for hoping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clip complete all as specified and directed.

M & L for use and waste of formwork to sides and soffits of floor or roof beams, beam haunchings, girders, bressummers, lintels, cantilevers, shelves including supports, overhangs, etc. also splay between floors and beams, etc. and similar works for rough finished surfaces complete all as specified and directed

M & L for use and waste of Formwork to edges of concrete flats, treads, breaks in floors, window cills, concrete railings, openings in concrete walls, floor and roofs n exc 20 cm wide and sides of RCC/PCC bands in walls, horizontal or sloping and similar work exc 10cm but n exc 20cm wide for rough finish surface of concrete complete all as specified and directed.

M&L Cement Concrete 1:2:4 type B-1 using 20mm graded stone aggregate as in lintels upto 1.5m clear span, cills, steps, seismic and other bands, plinth courses, string cources, lacing cources, parapets and railing upto 60cm in hight, copings, kneelers, apex stones, bed plates, water troughs, hold fasts and the like including weathering, slightly rounded or chamfered angles and throating including necessary formwork complete all as specified and directed.

M&L mild steel framed work such as posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc., flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting and/or welding etc. and similar work conforming to Fe-290 Gde E-165 complete all as specified and directed.

S&F galvanised, 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails, straining bolts, including securing or tying at crossings with and provn of galvanised mild steel wire, staples or steel pins etc. complete all as specified and directed. NOTE: Each line wire to be measured.

S&F Concertina coil fencing with punched tape coil 450mm dia (at stretched position), made out of hot dipped, galvanised steel wire coated with CLR anti corrosive paint, making diamond shape barbs with 18 SWG sheet, spring core 2.5mm thick wire with tape 0.52mm thick and weight of each coil should not be less than 7.50 Kg, each coil should have 50 rounds and should covers 6 RM length, fixed over and including 6 lines of horizontal RBT (reinforced barbed tape) wire or razor wire at points wherever coil touches the bottom of wire with the help of hog rings (14 SWG) and in between Y shaped angle iron post complete all as specified and directed. NOTE: (i) Hogging shall be fixed at a interval of 600mm centre to centre, wherever it touches with the razor wire. (ii) Overlapping of concertina coil and razor wire shall be 300mm. (iii) Y shaped angle iron post shall be measured and paid separately under respective items. MAKE: M/s Global Engg or M/s Specials steels Ltd or M/s Super Fence or other equivalent make as approved by GE.

Material and Labour for preparation of new or previously untreated surface of steel surface of any description over 10cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed.

M & L for Providing precast cement concrete 1:2:4 type B-0 (Using 12.5mm graded stone aggregates) louvres and jallies, 25mm thick (measured solid), including all mouldings but excluding frame set in cement mortar 1:4 complete all as specified and directed.

M & L for Boulder pitching, laid dry, hand packed tightly complete all as specified and directed.

Material and Labour for preparation newly plastered surface of wall and applying two coats of cement base paint over a coat of white cement primer complete all as specified and directed.

Excavating in trenches, n exc1.5 m wide and n exc 1.5 m in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pier holes, etc. n exc 10 sq m on plan and n exc 1.5 m in depth and getting out in soft/loose soil complete all as specified and directed.

M & L for Cement concrete 1:4:8 type D-2 (using 40 mm graded stone aggregate) in foundations, filling and mass concrete complete all as specified and directed.

M & L for salt glazed stone ware drain pipes laid in trenches and jointed and tested for 150 mm bore of pipe complete all as specified and directed.

M & L for cement concrete bed 1:3:6 type C-2 (using 40mm stone aggregate) to drain pipes including packing under, and haunching against the sides of pipes after they are laid and tested complete all as specified and directed.

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm. of soft/loose soil complete all as specified and directed.

Removing excavated soil n exc. 50m and depositing where directed at a level n exc. 1.5 m above the starting point complete all as specified and directed.

M&L 15 mm thick rendering in CM (1:6 ) on fair faces of brick wall or concrete surfaces finished fair and even complete all as specified and directed.

M & L for Cement concrete 1:2:4 type B-2 (using 40 mm graded stone aggregate) in surface channels and drains complete all as specified and directed.

M & L for Extra for forming fair finished drain or channel 30 cm inner girth in cement concrete, using extra cement, including forms, moulds, mi- tred/stopped ends etc. complete all as specified and directed.

M & L for Providing Precast Cement concrete 1:2:4 type B-1 (using 20 mm graded stone aggregate) in cover slab (for manholes etc) set in CM 1:4 complete all as specified and directed.

M&L for construction of Septic Tank suitable for 25 users with RCC M-25 Design Mix (using 20 mm graded stone aggregate) as in bases, baffle walls, beams, roof slab, cover slab, covers etc., brick work with old size fly ash bricks in CM 1:4 and manhole cover made out of 6mm thick MS steel sheet and frame of angle iron 50x50x6mm including all required earthwork in soft/loose soil, cement concrete etc. complete all as shown on CELZ drawing No. TD/687 sheet 1/2 & 2/2 amended upto date complete all as specified and directed.Note : Depth of septic tank shall be the effective depth i.e. below invert level of sewage line

M&L construction of Soakage Well of size 1.80m dia and 4.50m effective depth with fly ash bricks and RCC M-25 Design Mix (using 20 mm graded stone aggregate) as in cover slab etc. including all required earthwork in soft/loose soil, filling of brick bats and cement concrete etc. complete all as shown on CELZ drawing No. TD/576 sheet 1/2 & 2/2 complete all as specified and directed.

M/S BABA CONSTRUCTION

Adamya Group Of Company

M/S Reliance Construction