NITNo13ItemNo3

S/o Star delta starter panel in sheet steel enclosure made out of 2 mm CRCA sheet totally enclosed. powder coated free standing floor mounted type, dust & vermin proof, double door canopy type, outward opening, lockable doors having hidden hinges and using non deteriorating neoprene rubber gasket protection. The each part of the fabricated panel will be strictly painted by enameled paint. The various components, assemblies and sub-equipments of the panel will be as per standard given in relevant IS. The bus bar of the panel will be shaped out of high conductivity, electrolytic conductor and shall be liberal sized in aluminum. The control wiring of the panel will be done with PVC flexible copper wires of 1.5 mm cross section. Each wire is terminating with a ferule crimped to the wire. Size 900 mm x 750 x 350 rnm, suitable tor 25 HP motor. MCCB 415 V Triple pole 50 KA 100 Amp – 1 No Ampere Meter 100/5 size 96 x 96 mm - 1 N o Volt meter 0-500V - 1 No Spreader terminal for MCCB - 3 Set Current transformer 100/5 – 3 No Indicating light RY B - 5 No On-Off' push button set (green & red) – 1 Set Power contactor 3 phase 415V 50Amp. - 3 No On delay star delta timer - 1 No Over load relay 30-50 Amp. – 1 No Motor Protection relay - 1 No (32 – 88) O/L range Cable gland & plate for cable termination – 1 Set Make of component: - L&T/Siemens/Schneider/C& S/A E

Supply of Aluminium armoured cable 35sq mm x 3 core Make- Havelles/Finolex/Grandly/Gloster/DJB approved

Power contactor 3 phase 415V 50Amp Make: - L&T/Siemens/Schneider/C& S

On delay star delta timer Make: - L&T/Siemens/Schneider/C& S

Over load relay 30-50 Amp Make: - L&T/Siemens/Schneider/C& S

MCCB 415 V Triple pole 50 KA 125 Amp Make: - L&T/Siemens/Schneider/C& S

Motor Protection relay 32-88 Make: - L&T/Siemens/Schneider/C& S

Dismantling of old damaged enclosure at site by removing cable connection and shifting the same. Fixing/grouting of the MS angle stand and enclosure at site at the convenient height to operate suitably by welding or not bolt as required at site with necessary work fitting of the starter panel on MS angle stand through welding or nut bolt as per site requirement, making cable connection with thimble, tapping etc. dismantling old existing cable & laying new cable as per requirements.

Testing & Commissioning of the starter panel and installed equipments, setting of relay, as per required parameters, with relevant IS testing of the panel as per site requirement

Shakti Trading Co.

Gupta Brothers

CHANDERA BUILDERS

Premier Engineering Company

Raj Engineering Co.

Cantilever Engineers