Civil works for installation of 3D Welded Mesh Fencing at Armour Unit, Rohtak, Haryana

Surface dressing of the ground including removing vegetation and inequalities not exceeding 15 cm deep and disposal of rubbish, lead up to 50 m and lift up to 1.5 m.

Demolishing R.C.C. work manually/ by mechanical means including stacking of steel bars and disposal of unserviceable material within 50 metres lead as per direction of Engineer - in- charge.

Earth work in excavation of all kinds of soil by mechanical means (Hydraulic excavator)/ manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and for lift upto 1.5m, as directed by Engineer-incharge.

Providing and laying in position cement concrete of specified grade 1:4:8 (1 Cement : 4 coarse sand (zone-III) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources) excluding the cost of centering and shuttering, complete as directed by Engineer-in-charge.

Providing & laying RCC M25 Design Mix of specified grade exclude the cost of centering & shuttering all work at all levels as indicated in drawing including cost of mixing, placing, compaction, vibration, pumping, consolidation, curing complete, foundation, walls etc., with 20mm & down size metal at all levels as per drawing. (330 kgs of minimum cement content)

Supply and fixing of Tata make or Equivalent approved make 3D welded mesh fencing of 2.4 meters in height, manufactured from pre-galvanized mild steel wire of 4mm diameter and post 60X60X2.2 mm in size, electro-fusion welded to form a mesh pattern of 50 mm X 200 mm, with minimum of three horizontal V-bends for reinforcement and rigidity across the height of panel. Each mesh panel shall be of width not exceeding 2500 mm and powder coated with exterior grade epoxy / polyester powered of minimum 60 micrones fabricated from pre-galvanized steel, factory-finished with. The post shall be supplied with factory-fitted weather –resistance plastic cap and necessary base plate wherever required. Fixing of panels to the post shall be done using Mild steel clamp, security bolts, Nuts, washers, rubber gaskets, and anti –theft fasteners design. Post shall be installed at interval not Exceeding 2.6 meters center to center all work should be approved by Engineer-in-Charge.

Please Enable Macros to View BoQ information