MP Fund 2024-2025 Mini Mast

Supply, Delivery,Erection and Commissioning of 12mt GI octangle light pole as per dimension - top dia 70mm, bottomdia 140mm,section-1(section length-10000m) thick 3mm. Baseplate 250mmX250mmx16mm with 4nos of M24 dia bolt(4nos) with safetyladder PCD 250mm with suitable RC works ,with 32AMps 2 pole MCB with MCB DB BOx and Door Arrangements at the bottom of the pole and Round ring arm at the top of the pole suitable for fixing of Flood light luminaries. 6 Nos of 150W LED flood lumiaries complete set with cast aluminium housing and anodized reflector complete with IP65 protection glass with necessary wire connection complete set as per standard specification. 7/20 CTS copper wiring from light pole to service box for power automatic ON/OFF timer switch box with 24x7 hrs programmable digital timer clock, 40 Amps, 4 pole contractor with 220 Volt Coil 64 Amps Miniature, Circuit Breaker, 16 Amps Neutral link fully wired with fibre glass wire 40 Amps double pole ISOLATOR main switch, 63 Amps fuse carrier, Fully wired on a wooden board in 1 Zinc coated box with lock and key arrangements and necessary clamps and angles with bolts and nuts etc complete 1x11.00 Nos (SOR PWD-2024-25 New Item No.M2138 ,page no.219)

Supply and Laying of 2x6sq.mm PVC LTUG Aluminium armoured cable in a trench to be excavated at a depth of 0.75 metre putting 0.15 metre layer of sand and covering the cable completely with bricks and sand and refitting the earth to make good (SD 175) SOR / PWD -Electrical Data 2024-25)

Supply and fixng of TNEB meter board suitable for 3 phase 63A service connection made up of suitable angle iron frame work of size 2 feet x 1-1/2 feet using angle iron of size 1-1/2" x 1-1/2" x 1/4" rigidly fixed on wall covered with hylem sheet of size 2 feet x 1/2 feet of 6mm thickness with necessary bolts and nuts supports and supply and fixing of 3 Nos. 63A fuse units (500V), 1 No. neutral link, copper earth flat of size 1" x 1/4" with inter connection of EB meter to fuse units by 16 Sq.mm PVC insulated copper wire with 1 No 63 Amp 30 MA Four Pole RCD / RCCB (Higher End) with suitable necessary connection with earth connection complete (SD 131) SOR/PWD-Electrical Data 2024-25

Earth work excavation for foundation in Hard stiff clay, stiff black cotton, hard red earth, shales murram, gravel,stoney earth and earth mixed with small size boulders SS.20B and Sand, silt or other loose soil, wet sand,or silt not under water, light black cotton soil, sandy loam ordinary soil and to full depth as may be directed except in hardrock requiring blasting inclusive of shoring shuttering and baling out water and cleaning and levelling the site etc.,complete 10 cum

Supplying and filling in foundation and basement with Crushed Stone Sand (M- Sand) in layers of not more than 15cm thick well rammed watered and compacted etc., complete complying with standard specification.

Plain Cement Concrete 1:4:8 (one cement four fine aggregates and eight coarse aggregates) using 40mm size ISS HBG metal including cost and conveyance of all materials to site and including for the mixing, laying and labour charges and all incidential charges such as water providing etc., complete as per standard specification

Centering for soffits of RCC slabs of plane surface like lintels, beams ,etc.,including strutting 3m high using mild steel sheets of size 90cm X 60cm X and B.G 10 stiffened with M.S angles of size 25mm X 25mm X 3mm laid over silver Oak (C.W) joists of size 10cm X 6.5cm (spaced at about 90cm c/c )and supported dy casurina props of 10cm to 13cm dia (spaced of 75cm C/C) complying with standard specification and directed - 10 m 2 (P & D)Data 38

Suppling and fabricating and placing in position MS (or) R.T.S. bar for reinforcement to all RCC works as per the design given including cost of steel and binding wire also in all floors.

Providing and laying in position Standardised Concrete Mix M-20 Grade in accordance with IS 456 - 2000 using 20mm and down graded hard broken granite stone jelly for all RCC items of works with minimum cement contenet of 325Kg/ cum and maximum water cement ratio of 0.55 including admixture (Plasticiser / super plasticiser) in recommended proportions as per IS 9103 to accelerate, related setting of concrete, improve workability without imparing strength and durability with about (5.0cum), 7730Kg of 20mm machine crushed stone jelly and with about (3.3 cum), 5156kg of 10 - 12mm machine crushed stone jelly and with about (4.79cum) 7670 kg of Crushed Stone Sand (M- Sand), but excluding cost of reinforcement grill and fabricating charges centering and shuttering but including laying, vibrating with mechanical vibrators, finishing, curing, etc and providing fixtures like fan clamps in the RCC floor / roof slabs wherever necessary without claiming extra cost etc., complete complying with standard specification and as directed by the departmental officers -