e-NIT No.07 / EnM (WEST)/ 2021-22, Item No.14

Dismantling of old/existing panel from site after disconnecting the incoming and outgoing electric supply and shifting the material to store.

Fabrication of starter panel sheet steel enclosure made out of 2 mm CRCA sheet totally enclosed, powder coated free standing, floor mounted type, dust& vermin proof, outward opening, lockable doors having hidden hinges and a bolted back cover both using non-deteriorating neoprene rubber gaskets to provide IP-54 protection .The each part of the fabricated panel will be strictly subjected to seven tank treatment. The various components, assemblies and sub equipments of the panel will be as per standard given in relevant IS. The bus bar of the panel will be shaped out of high conductivity, electrolytic conductor and shall be liberal sized in aluminum. The control wiring of the panel will be done with PVC flexible copper wires of 1.5mm cross section. Each wire will be terminating with a ferule crimped to the wire, size 1500 mm x1000 mm x 350 mm. Having following components of approved make. Make of Items:- L&T/C&S/AE/Havells/As approved by DJB

MCCB 415V, TP 3phase 50KA 50Hz, 200 Amp with spreader

MCCB 415V, TP 3phase 50KA 50Hz, 100 Amp with spreader

MCB Single pole 6 Amp.

MCB Triple pole 32 Amp.

MCB Triple pole 63 Amp.

PVC insulated copper flexible cable single core 16 sq.mm Make: Havells/Finolex

Power capacitors 415V unit of 20 Kvar Make: Epcos

Over load relay 30-50

Over load relay 6-10

Digital Amp. Meter

Digital Volt Meter0-500V -

Motor protection Relay Make:

Power contactor 220V 3 phase 70Amp.

Power contactor 220V 3 phase 50 Amp.

Power contactor 220V 3 phase 25 Amp.

Star delta timer on delay.

Indicating lights LED type RYB & On/OFF

Current Transformer 200/5,100/5,30/5

On load change over switch 200 Amp. Open execution type

Fitting of the above components in panel enclosure with terminal blocks, channels, ferrules, thimble, support insulator on bus bar, required hard wares complete in all respect.

Loading ,unloading by crane or heavy labor and cartage up to site cleaning & dressing the surface for Installation of the panel at site on base frame ,laying of cable, termination of cable both incoming & out going side.

Testing & commissioning of panel, as per required parameters with relevant IS .testing of the panel prior to switching on as follow i) Continuity and earth testing ii) Meggaring of all equipment’s for phase to phase, neutral to body, neutral to earth and phase to earth. iii) Checking for all tightness of nut and bolts iv) Alignments of doors etc. v) Interlocking tests. All function tests

Premier Engineering Company

RISHABH ENGINEERS

HARI ELECTRICAL CO.

HYDROCON ENGINEERS

AQUA GASEOUS CONTROLS (INDIA)

P.K. Electricals