Tiruppur_Corp_Maintenance and Special Repair of Inner bathroom Toilet works and Construction of Outer workers bathroom Toilet in Commissioner quarters Ward no 29

Amount

Earthwork excavation for foundation in all soils and sub soils except in hard rock requiring blasting and depositing on bank with initial lead of 10m and initial lift of 2m inclusive of shoring, shuttering, bailing out water wherever necessary, refilling the foundation with excavated earth other than sandy soil in layers of not more than 150mm thick layers well rammed and depositing the surplus earth within the compound in place shown by the departmental officers and clearing and levelling the site etc,. complete.

Random rubble masonry in CM 1:5 [one cement and five M-sand] for foundation and basement using best new rough and bond stones including simultaneous pointing above ground level with the same mortar etc., complete complying with standard specification.

Plain Cement concrete 1:4:8 [one cement, four M-sand and eight course aggregates] using 40mm size Hard Broken/Machine crushed Granite Stone Jelly including dewatering if found necessary and laid in layers of not more than 15cm thick and compacted etc., complete complying with standard specification.

Finishing the top of flooring with a layer of cement concrete 1:3 [one cement and three stone jelly] ELLIS PATTERN 25mm thick using 10mm thick and below gauge HBG stone (No sand to be added) and the surfaces rubbed smooth with current etc., complete complying with standard specification.

Hollow block masonry work in CM 1:5 using Solid / Hollow blocks of size 40 x 10 x 20cm made in cement concrete 1:3:6 (one cement three sand six aggregate) confirming to S.S 2145-1965 (including jam blocks closers etc) including curing and neat finishing etc., complete complying with standard specification.

Plastering with CM 1:5 (One cement and five sand) mix 12 mm thick including finishing cost and conveyance of all materials to work site and all labour charges watering, curing and and all other incidental charges etc., complete complying with standard specifications.

Colour washing two coats in all floors using best freshly burnt white shell lime and best quality of approved variety of colouring pigment including cost of lime, colouring pigments, fevicol type gum, brushes, scaffolding charges etc., complete complying with standard specification. Mineral colouring pigments not affected by lime should only be used (strainers and colour solutions should not be used).

Supplying and fixing in position White glazed earthenware Oriya type INDIAN WATER CLOSET of size 580mm x 440mm of approved quality with 'P' (or) 'S' trap confirming to IS:2556 - Part XII with sand cushion and forming flooring around the closet using 40mm broken brick jelly in lime concrete 1:2:5 mix (one lime, two sand and five brick jelly) 100m thick and finishing the top to the required slope and including giving necessary connection to the cast iron soil pipes / PVC pipes by dismantling the brick masonry, reinforced concrete roof / floor slab and making good the disturbed portion to original condition without any leakage etc., complete complying with standard specification.

Wiring with 2 x 1.5 sq.mm. (22 / 0.3 ) PVC insulated single core unsheathed copper conductor cable of 1100V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories and with TW switch box and 5A FT switch with painting of suitable colour with continuous earth wire connection of 14 SWG TC wire for open PVC light point / fan point (for electronic regulator) SD-16

Supply and fixing of single box type 4'40W fluorescent fitting complete with copper choke and condensor with TWround blocks on wall or ceiling with flu tube with PVC unsheathed copper leads from terminals to the fitting SD-88

Supply and fixing Solid PVC door shutters with frame using 19 Gauge 19mm MS square tubes for styles and outer frames. 15mm MS square tubes for top, lock and bottom rails. The steel tubes shall be covered with 5mm thick solid PVC sheets. Shutter using 5mm thick solid PVC sheets for panelling shall rigidly fixed in position including necessary furniture and fittings. The over all size of styles shall be 50mm x 30mm. The over all size of top rail, Lock rail and bottom rail shall be 75mm x 30mm. The over all size of frames shall be 50mm x 45mm with suitable rebate for housing the shutter etc., complete complying with standard specification.

Supply and delivery of the following size of PVC Specials & UPVC Special with IS specification etc., complete.

50mm Dia UPVC Column Pipe Twad 47

50mm Dia PVC Bends fabricated 6 KSC Twad 47

50mm Dia PVC Elbow (Mould) BIS 7834/1975 Part VITwad 47

50mm Dia PVC Equal Tee Fabricated BIS 10124/1982 PartV 6 KSC Twad 47

20mm Dia Tap

Supplying and filling in foundation and basement with filling M-Sand in layers of not more than 15cm thick well rammed, watered and compacted etc., complete complying with standard specification.

Plain Cement concrete 1:2:4 [one cement, two M-sand and four course aggregates] using 20mm size Hard Broken/Machine crushed Granite Stone Jelly including dewatering if found necessary and laid in layers of not more than 15cm thick and compacted etc., complete complying with standard specification.

Supply & fixing & Delivery of box type wooden wardrobes made from ply board marine BWR of MAKE CENTURY /GREENPLY/MAYURPLY which will be finished with laminate approved shade Make (GREEN PLY/ ARCHID PLY/ CENTURY) and postforming shutter HDF of MAKE ACTION TESA/GREENPLY both side laminated of MAKE GREEN PLY. Teakwood with polish every front edge and sides to be a provided. The shutter shell be a provided with SS hinges for center and side portion. SS door handle hanging rod SS 1m, SS tower bolt Godrej multipurpose lock and other details shown in figure 1.94m x 1.35m &1.94m x 0.90m etc., complete complying with standard specification.

Cupboard

Tea bai

Dismantling the existing Floor finish and dadooing walls in cement mortar with Flooring tiles / glazed tiles / cuddapah slabs including removing the debris from the site and stacking useful material at work site for reuse etc., complete complying with standard specification.

Paving the floor with 8mm thick Double Charged Vitrified Tiles in all floors over a base layer of cement mortar 1:3 [one cement and three M-sand] 20mm thick of walls and floors and pointed with the same colour cement neatly, including polishing with electric polishers to a high degree so as to make it perfectly smooth and showing etc., complete complying with standard specification.

Supply and Fixing of UPS and Pressure Pump Motor

Add GST @ 18%

Ramachandra Electricals and Engineering Stores (BID ID -1113700)