Municipal Commissioner Nagar Nigam Kashipur Tenders

Floor price in INR per kWh (floor price shall not be less then INR1 per kWh)

Primary & Secondary Chamber Primary Chamber * Single Chmber Furnace of size 4270 mm X 1980 mm X 1820 mm. * Plate thickness- 5 to 8 mm. * Lining of interior of furnace- 400 mm Wall Cermaic Blanketk, High aluminia refractory brick IS-8-1994 line with insulation brick IS 2042-2006 * Operation temperature- 800o C to 1000o C. * Top Smoke Discharge for secondary chamber. * Ash removal doors to be provided for ash collection after combustion. * Ingtion- Automatic. * Temperature Control- Automatic * Material loading- front gate- automatic Secondary Chamber * Operating temperature - 1050o C to 1250o C. * Material of construction- Mild steel with High aluminia refractory brick IS-8-1994 line with insulation brick IS 2042-2006. * Made from IS 2062 Grade Mild Steel Materials (Or better) Duty Lined with Insulation Bricks, Refractory Bricks, Hysil Boards. * Burner Mounting Arrangement with refractory Burner block. Furnace Door: Furnace Door Charging & Discharging Side Fabricated From 5mm To 6 Mm Thickness Door Opening & Closing Automatic. Ash Door: * Ash door (with casted cement lining) to remove Nonhazardous ash from the chamber. * Top Inlet bottom smoke discharge for longer gas residence time. * Furnace door charging & discharging side fabricated from 5mm to 6 mm thickness. * Door opening & closing automatic/manual. Refractory: {Complete set of refractory shaped bricks for construction electric cremation of I.S. 8 bricks (approx. 1007nos bricks,insulation 4000 nos. refractory slid for construction of flue duct , as required, refractory heat resistant fire clay , ceramic blanket hysil board, asbestos ropes etc. as required for outer side of the furnace shall be constructed by red bricks by sand and cement as mortars and construction of chimney from basement of roof level including painting I.e. bricks portion shall be painted by two coats of red oxide as primer and to coats of synthetic enamel. (a) Complete lining & assembling of entire cremation chamber according to standard size with proper arrangement of accommodation of heating elements, resting of dead body with sufficient opening for falling of ashes to the ash chamber & sufficient ventilation for fresh air spraying. (b) complete lining and assembling of Entire cremation chamber according to standard size with provision of drawing out aces from the rear side and sufficient Ventilation for Fresh air injection. complete lining and assembling of entire cremation chamber according to the standard size with provision of air inlet supplying by fresh air blower and arrangement of multi ventilation path for fresh air}.