Fabrication Works Tenders

V.R.C.C (1:11/2:3) using 20 MM size HBG graded chips with nominal mix SS-5 using necessary quantity and excluding cost and conveyance of steel per cum of concrete including cost and conveyance of all materials and all labour charges, seigniorage, curing, centering ( Using Steel) etc., complete as per APSS No.403 with BIS 456-2000 but excluding the cost of steel and its fabrication charges.a) plinth beam

Supply and fabrication of Steel Including cost and Conveyance of all charge setc.

Item Code [23.28-2025]:Item Type [Electrical] :: Supply & fabrication steel structure with MS channel / angle / joist / ISMB / sheet etc. including welding, rivetting, cutting, nut & bolt , one coat of primer & two coat of enamel paint etc. as required complete in all respect. .

Installation of junction boxes of approximate size of 500x370x180mm (inlet entry 1/2" x 12 side, and outlet 1¼ "x 1 Nos) on newly fabricated MS Supports. The work shall include the fabrication of MS supports with necessary mounting holes, drilled on the supports and fixing it on the available structures by welding/using fastners of nuts and bolts in SS 304 material. Junction boxes, and Angles / flats required for the work will be issued by FACT . All consumbles required for the work such as nuts/bolts/screws are under the scope of contractor. Nut/bolts/screws shall be of SS.

90.14.1.2 Fabrication, supply, conveyance, installation testing and commissioning of floor or wall mounting, dust and vermin proof, cubicle type MV panel board comprising of the following components/ devices & complying to IS 8623. Fabrication of fully partitioned, dust and vermin proof enclosure for panel assembly as per form 4 of IS 8623 (with latest amendments) using CRCA sheet as per approved design and requirement, with front and rear access facility, bus bar chambers, hinged doors for all switch gear compartments, earthing the doors using 4 sq mm braided copper conductor, providing necessary cut-outs for mounting meters, relays, indication lamps, bus bar interconnection etc, detachable covers for bus bar chamber and cable alley, powder coating the assembly after subjecting to 7 tank process etc as required. CRCA sheet alone be used for the fabrication. Angles/ flats/ slotted angles etc shall not be used for the fabrication of panel assembly. The measurments will be taken the area of the complete sheets used for panel board including partitions, folding, shrouding etc.Supply and fabrication of MV panel board using 1.6mm CRCA sheet, powder coated (excluding base frame)