Fabrication Works Tenders

Supplying, Fabrication, Erection on suitable RCC foundation and Commissioning with 3 (three) months Trial Run (including cost of routine testing of water sample for performance evaluation) of pressure type Iron removal plant as per design norms of the P.H.E. Dte. with necessary accessories viz. MS fabricated shell with minimum 10 mm thick MS plate with 2 (two) coats of anticorrosive paint & minimum 12 mm thick MS media supporting plate fitted with required no. of pot strainer, MS fabricated oxidation chamber with minimum 10 mm thick plate with necessary pipe connection, valves, Gauges & other instruments as required as per departmental approved design & drawing including cost of filter media, Air Compressor & Air blower with motor, starter, main switch etc. of required capacity & approved specification including power connection from main line etc. all complete. (Rate excludes the cost of Concrete Platform & drain, and the cost of Blower Room): 35m³/hr. capacity

SUPPLY, FABRICATION, ERECTION AND LAYING OF PIPELINES AND HOOKUP WITH EXISTING & OPERATIONAL PROPANE / BUTANE IPPL PIPELINE THROUGH HOT TAPPING METHOD NEAR UNDER-CONSTRUCTION CAPTIVE JETTY OF IOCL AT KAMARAJAR PORT LIMITED, ENNORE, CHENNAI

Fabrication & strengthening of Platform with necessary support arrangement at various location of Boiler & Turbine

Improvement of water supply by way of providing/fitting, Fabrication and installation M.S. Pipe 150mm dia x 18 mtrs approx. in length for unit No.8 & 9 HC pumpset in place of existing worn out/damaged suction lines along with allied works at pumping station Dhounthly. The Job involves dismantling of worn out/damaged suction lines installed inside the sump tank with the help of gas cutter, after dismantling worn out/damaged suction line the job involves extraction of dismantled suction lines of units No. 8 and 9 from the sump tank with the help of proper tool, tackles and manual labour. Job also involves providing, fabrication and fitting of M.S. suction Pipes 150mm dia of suitable length as per site requirement with the help of an arc electric welding/ gas cutting. The job further involves fitting of suction lines with suction side of both the pumps, providing and fitting of 04 Nos. long bends and flanges on both the suction lines. Complete job including cost of material i.e. nuts, bolts, packing of foot valve leak proof, welding/ gas cutting sets to and fro charges, skilled/unskilled labour and unforeseen charges etc.

Supplying, Fabrication, Erection on suitable RCC foundation and Commissioning with 3 (three) months Trial Run (including cost of routine testing of water sample for performance evaluation) of pressure type Iron removal plant as per design norms of the P.H.E. Dte. with necessary accessories viz. MS fabricated shell with minimum 10 mm thick MS plate with 2 (two) coats of anticorrosive paint & minimum 12 mm thick MS media supporting plate fitted with required no. of pot strainer, MS fabricated oxidation chamber with minimum 10 mm thick plate with necessary pipe connection, valves, Gauges & other instruments as required as per departmental approved design & drawing including cost of filter media, Air Compressor & Air blower with motor, starter, main switch etc. of required capacity & approved specification including power connection from main line etc. all complete. (Rate excludes the cost of Concrete Platform & drain, and the cost of Blower Room): 25m³/hr. capacity