REPAIR TO FOOTPATH, PAVER BLOCK, CULVERT AND RCC PAVED AREA AT CERTAIN LOCATION AND MAINT TO STATION RANGE AT 6 WING AF UNDER GE (AF) BARRACKPORE

Amount

Demolition of cement concrete (unreinforced) in ground floors and paving n.exc. 15cm thick (below or above ground level) and removal of rubbish from the site complete all as specified and as directed.

Demolition of cement concrete (reinforced) of any description and in any position not otherwise specifically provided including reinforcement cut as required to facilitate demolition and removing debries from site of work complete all as directed.

Demolition of brick work or stone boulder masonry, built in cement mortar including all quoins, arches, pillars etc. including removing of unserviciable material from site complete all as specified and directed.

Taking down cement plaster of any description built in cement mortar on brick or stone walls etc including racking out joints, hacking for key, scrubbing down with water etc. and removing debrish from site complete all as specified and directed.

Materials and labour for sand filling under paver block for cushioning complete all as specified and as directed.

Material and labour for hardcore of broken stone or boulder of gauge n.exc 63mm, deposited, spread and leveled in layers n.exc 15cm thick, watered and rammed to a true surface complete all as specified and directed.

Material and labour for extra for forming fair finished below culvert or drain or channel 30 cm inner girth in cement concrete, using extra cement, including forms, moulds, mitred /stopped ends etc complete all as specified and as directed. Note : Inner girth only shall be measured for payment.

Material and labour for PCC (1:2:4), type B1, (using 20mm graded stone aggregate), as in coping, bed plate, kerbs, water troughs and like including weathering, slightly rounded or chamfered angles and throating, including necessary formwork complete all as specified and as directed

Material and labour for PCC (1:4:8) type D2 (using 40 mm graded stone aggregate ) as in foundation, filling and mass concrete complete all as specified and directed.

Material and labour for PCC (1:3:6) type C2 (using 40 mm graded stone aggregate ) as in surface channels or culvert or drains complete all as specified and directed.

Material and labour for RCC (1:2:4) type B-1 (using 20mm graded stone aggregate) as in beams, cantilevers, bressummers, lintels over 1.5m span complete all as specified and directed.

Material and labour for pre-cast RCC (1:2:4) type B1 (using 20 mm graded stone aggregate) in landings, cover slab, chulla hoods, chajjas, water troughs, shelves and similar articles of any thickness and size and set in cement mortar (1:4) including necessay formwork complete all as specified and directed.

Supply only integral water proofing compound (WPC) complete all as specified and directed.

Material and labour for brick work with sub class `B` bricks, old size, straight or curved on plan exc 6m mean radius built in cement mortar (1:6) complete all as specified and directed.

Use and waste of form work to sides and soffits of floor or roof beams, slab, girders, bres-summers, lintels, cantilevers, shelves including supports, overhangs, etc. also splays between floors and beams, etc. with rough finished flat surfaces of concrete complete all as specified and as directed.

Supply and fix mild steel works as in hand rails, half round or other steel section or core for wooden hand-rail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embedding in concrete and screwing etc. wind ties for roof including securing bolts; posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 including dismantling of wrought iron or mild steel work of any description complete all as specified and directed.

Material and labour for mild steel TMT bar 10 mm dia and over cut to length bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed.

All as per item No 17.00 above but 6 to 8mm dia for stirrups, spacer, binders and -ditto-.

Material and labour for 75mm thick PCC (1:3:6) type C-2 (using 40mm graded stone aggregate) as in plinth protection including finishing the concrete surface even and smooth without using extra cement complete all as specified and directed.

Material and labour for 75mm thick PCC (1:3:6) type C-2 (using 40mm graded stone aggregate) as in path or similar type place and finishing the surface fair and even complete all as specified and directed.

Material and labour for 60mm thick and M-35 Grade pre-polished machine pressed precast cement concrete interlocking paver blocks of any shape and size confirming to IS-15658-2006 complete all as specified and as directed.

Material and labour for 100mm thick and M-50 Grade pre-polished machine pressed precast cement concrete interlocking paver blocks of any shape and size confirming to IS-15658-2006 complete all as specified and as directed.

Material and labour for 15mm thick rendering on fair faces of brick work or concrete surfaces in cement mortar (1:6) and finish the surfaces even and smooth without using extra cement as in wall complete all as specified and directed.

Material and labour for 15mm thick rendering in cement mortar (1:4) on fair faces of brick work or concrete surfaces in two layers, first layer of 10mm thick and top layer of 5mm thick with using water proofing coumpound (WPC) @ 2% or as per manufacturers instruction and finish the surfaces even and smooth without using extra cement as in wall complete all as specified and directed. Note : WPC will be measured and paid separately under respective item.

Material and labour for preparation of new plastered surfaces of wall and applying three coats of white wash complete all as specified and directed.

BUSINESS SYNDICATE

NARAYAN BUILDERS

Oenix and associates

M/S P K CONSTRUCTION

PIONEER