CMLRRP/2020-21 Thekkecharuvila Pazhangalam

Amount

RETAINING WALL

11.1.1.1 : Excavation for StructuresEarthwork in excavation for structures as per drawing and technical specifications Clause 305.1 including setting out, construction of shoring and bracing, removal of stumps and other deleterious material and disposal upto a lead of 50 m, dressing of sides and bottom and backfilling in trenches with excavated suitable material.I.Ordinary soil(i)Upto 3 m depth

od621049/2020_2021 : Providing concrete for plain/reinforced concrete in open foundations complete as per drawings and technical specifications Clause 802, 803, 1202 & 1203<br><br>I.P.C.C grade M 10<br><br>(i)Nominal mix 1:3:6

11.4.2.1 : Providing concrete for plain/reinforced concrete in open foundations complete as per drawings and technical specifications Clause 802, 803, 1202 & 1203 II.P.C.C grade M 15(i)Nominal mix (1:2.5:5)

Retarring

75.5.5.B.2pb : Modified Penetration Macadam 75 mm thick using Bitumen S-65 - Packed Bitumen Rates <br> Construction of penetration macadam over prepared base by providing a layer of compacted crushed coarse aggregate using chips spreader with alternate applications of bituminous binder and key aggregates and rolling with a three wheel 80-100 kN static roller to achieve the desired degree of compaction as per Technical Specification Clause 506.

75.5.1.1pb : Prime Coat - Low porosity - With Packed Bitumen Rates <br> Providing and applying primer coat with bitumen emulsion (SS-1) on prepared surface of granular base including cleaning of road surface and spraying primer at the rate of 0.70-1.0 kg/sqm using mechanical means as per Technical Specification Clause 502

75.5.9.2.2.Pa : Plastic Roads - Bitumen S-65 <br> 20mm thick Open-Graded Premix Carpet using Bituminous (penetration grade/modified bitumen) Binder <br> Providing, laying and rolling of open-graded premix carpet of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates either using penetration grade bitumen or emulsion to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a three wheel 80-100 kN static roller capacity, finished to required level and grades to be followed by seal coat of either Type A or Type B or Type C as per Technical Specification Clause 508 (with 7% of bitumen replaced by shredded waste plastic) <br> Case - I By Manual Means <br> (II) Bitumen (S-65) (VG - 30)

75.5.12.A.3.2pb : Seal Coat - Manual Means - Type C - Bitumen S-65 - Packed Bitumen Rates <br> Providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using Type A, Type B and Type C as per Technical Specification Clause 510 <br> A. By Manual Means <br> Case III : Type C <br> (II) Bitumen (S-65)

Road Protection work

od624003/2020_2021 : MorD Surface dressing of the ground in all kinds of soil including removing vegetation and in equalities not exceeding 15 cm deep and disposal of rubbish lead up to 50m and lift up to 1.5 m

od622735/2020_2021 : plain cement concrete pavement ,thickness as per design,over a prepared sub base,with 43 grade&lt;br&gt;cement or any other type as per clause 1501.2.2 M 30 (grade),coarse and fine aggregates conforming to IS&lt;br&gt;383,maximum size of coarse aggregate not exceeding 25 mm,mixed in a concrete mixer of not less than 0.2&lt;br&gt;cum capacity and appropriate weigh batcher using approved mix design,laid in approved fixed side&lt;br&gt;formwork(steel channel, laying and fixing of 125 micron thick polythene film, wedges,steel plates including&lt;br&gt;levelling the formwork as per drawing),spreading the concrete with showels,rakes,compacted using&lt;br&gt;needle vibrators and finished in continuous operation including provision of contraction&lt;br&gt;and expansion ,construction joints,applying debonding strips, primer, sealant, dowel bars, near approaches&lt;br&gt;to bridge /culvert and construction joints, admixtures as approved,curing of concrete slabs for 14 days,using&lt;br&gt;curing compound(where specified) and water finishing to lines and grade as per drawing and Technical&lt;br&gt;Specifications clause 1501 (form work excluded)

Name Board

od646643/2020_2021 : MorD: Supplying and fixing name board of size 75x60cm installed in appropriate place visible to the public made of brick wall with GRANITE plaque should be inserted and engraving letters etc complete as per direction of dept officers at site&lt;br&gt;&lt;br&gt;

VIJAYAN PILLAI J

Anoop PR

Bidder Name

Anoop PR

VIJAYAN PILLAI J

NAJMA CONSTRUCTIONS