Repairs to Box Culvert Water Line Across Open Channel Behind IB at O. F. Itarsi.

Amount

Demolition of Cement Concrete in ground floors and pavings n exc 15 cm thickness (below or above ground level) etc as directed

Removing of demolished material lead n exceeding 100 mtr all as directed.

M & L excavating over areas in hard dense soil, n exc 1.5 m deep and getting out and Removing excavated material n exc. 50m and depositing where directed at a level n exc. 1.5 m above the starting point.

M & L excavating over areas in hard dense soil, Exc. 1.5 mtr and n exc 3 m deep and getting out and Removing excavated material n exc. 50m and depositing where directed at a level n exc. 1.5 m above the starting point.

M & L for hardcore of broken stone or boulders exc 63mm but n exc. 100mm, deposited, spread and levelled in layers n exc. 15cm thick, watered and rolled/rammed to a true surface, complete all as specified

Providing & Laying of cement concrete D2-type, 1:4:8 mix. (40mm graded aggregate) in foundations, filling, Floors etc. excluding the cost of form work but including the cost of finishing & curing etc. all as directed.

M&L for Reinforced cement concrete (nominal mix) Type B1 1:2:4 (20 mm graded aggregate) Slabs supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves

Providing form work to sides & soffits for rough finished flat surfaces of concrete i.e. foundations, footings, plinth beams etc. and , as directed .

M & L for Reinforced cement concrete (nominal mix) Type B1 1:2:4 (20 mm graded aggregate) Beams, cantilevers, bressummers, lintels over 1.5m span

M & L for Reinforced cement concrete (nominal mix) Type B1 1:2:4 (20 mm graded aggregate) Columns, pillars, piers, posts and struts

M & L for Reinforced cement concrete (nominal mix) Type B1 1:2:4 (20 mm graded aggregate) Foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete

Supply & Fixing of mild steel TMT bars 6 MM to 8mm Dia. cut to length bent to shape required including cranking, bending, hooking ends, placing in position and supply & binding with mild steel wire (annealed) not less than 0.9 MM dia or securing with clips

Supply & fixing mild steel TMT bars 10MM Dia and over cut to length bent to shape required including cranking, bending spirally for hooping for columns, beams(plinth & roof) etc, hooking ends and binding with mild steel wire (annealed) not less than 0.9 MM Dia dia or securing with clips.all as per specification and as directed

M & L for Stone Walling of random rubble, uncoursed well bonded, bedded and solidly hearted, built in 1:4 Cement mortar all as directed.

Sanjay Traders (BID ID -848812)

MANOJ ENTERPRISES (BID ID -849053)