GENERAL ANNUAL MAINTENANCE OF LI SCHEMES 2023 - 2024 - KOTTAYAM SECTION-General Civil Work

Amount

PEROOR LI SCHEME

OD29173/2023-2024:Re- erection of motor and pump fixing to bed and correct alignment setting and given wire connection from main switch, starter, motor slip ring etc. to be complete

OD29174/2023-2024:Lifting the Pump & motor and oil starter after disconnecting the electrical connection, suction and delivery pipes etc. complete

OD24739/2023-2024:Supplying Cotton Waste

OD29177/2023-2024:charges for resetting vacuum pump on correct alignment including damaged pipe re fixing the valve, checking the joints etc complete

OD29294/2023-2024:Dismantling the Starter taking out the contacts and cleaning the relay set with petrol and replacing the damaged contact set resetting the Starter etc. to complete

OD29175/2023-2024:Dismantling the damaged Bearing of Motor and Pump by suitable means without making any damages to the shaft and fixing new Bearings including labour charges etc.

OD24748/2023-2024:Transformer Oil

OD24775/2023-2024:Supplying Gear Oil

OD24777/2023-2024:Supplying Graphite Packing

OD24781/2023-2024:Supplying and providing 20mm Gland packing

OD24734/2023-2024:Supplying Bearing Grease

OD8484/2023-2024:Supplying Good Quality Nut, Bolt and Washer

OD29287/2023-2024:Overhauling existing old oil immersing starter, drain out the oil, cleaning the contacts with kerosine oil, replace the damaged O.C.B(Oil Circuit Breaker ) contacts including magnetic coil,testing the trial run etc complete.

OD29288/2023-2024:Supplying water seal

2.6.1:Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including disposal of excavated earth, lead up to 50 m and lift up to 1.5 m, disposed earth to be levelled and neatly dressed.All kinds of soil

15.2.1:Demolishing cement concrete manually / by mechanical means including disposal of material within 50 metres lead as per direction of Engineer - in-Charge.Nominal concrete 1:3:6 or richer mix (i/c equivalent design mix)

4.1.8:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:4:8 (1 cement : 4 coarse sand : 8 graded stone aggregate 40 nominal size)

5.1.2:Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level:1:1:5:3 (1 cement 1.5 coarse sand :3 graded stone aggregate 20 mm nominal size

5.22.6:Steel reinforcement for R.C.C work including straightening, cutting, bending, placing in position and binding all complete upto plinth levelThermo - Mechanically Treated bars of grade Fe-500D or more

5.9.1:Centering and shuttering including strutting, etc. and removal of form for:Foundations, footings, bases of columns, etc for mass concrete

4.1.3:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:2:4 (cement : 2 coarse sand (zone-III) : 4 graded stone aggregate 20 mm nominal size)

50.6.2.1:Solid block masonry using pre cast solid blocks (Factory made) of size 30x20x15 cm or nearest available size confirming to IS 2185 part I of 1979 for foundation and plinth with thickness 15cm in: CM 1:6 ( 1 cement :6 coarse sand) etc complete

13.1.1:12 mm cement plaster of mix:1:4 ( 1 cement : 4 fine sand)

PUNNATHARA LI SCHEME

OD29179/2023-2024:Re- erection of motor and pump fixing to bed and correct alignment setting and given wire connection from main switch, starter, motor slip ring etc. to be complete

OD29180/2023-2024:Lifting the Pump & motor and oil starter after disconnecting the electrical connection, suction and delivery pipes etc. complete

OD29181/2023-2024:Dismantling the damaged Bearing of Motor and Pump by suitable means without making any damages to the shaft and fixing new Bearings including labour charges etc.

OD29182/2023-2024:charges for resetting vacuum pump on correct alignment including damaged pipe re fixing the valve, checking the joints etc complete

OD24747/2023-2024:Transformer Oil

OD29295/2023-2024:Dismantling the Starter taking out the contacts and cleaning the relay set with petrol and replacing the damaged contact set resetting the Starter etc. to complete

OD24778/2023-2024:Supplying Graphite Packing

OD24740/2023-2024:Supplying Cotton Waste

OD24744/2023-2024:Supplying Gear Oil

OD24782/2023-2024:Supplying and providing 20mm Gland packing

OD8494/2023-2024:Supplying Good Quality Nut, Bolt and Washer

OD24735/2023-2024:Supplying Bearing Grease

2.6.1:Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including disposal of excavated earth, lead up to 50 m and lift up to 1.5 m, disposed earth to be levelled and neatly dressed.All kinds of soil

OD29289/2023-2024:Overhauling existing old oil immersing starter, drain out the oil, cleaning the contacts with kerosine oil, replace the damaged O.C.B(Oil Circuit Breaker ) contacts including magnetic coil,testing the trial run etc complete.

OD29290/2023-2024:Supplying water seal

2.32:Clearing grass and removal of the rubbish up to a distance of 50 m outside the periphery of the area cleared.

CHERUVANDOOR LI SCHEME

OD29188/2023-2024:Re- erection of motor and pump fixing to bed and correct alignment setting and given wire connection from main switch, starter, motor slip ring etc. to be complete

OD29186/2023-2024:Lifting the Pump & motor and oil starter after disconnecting the electrical connection, suction and delivery pipes etc. complete

OD29185/2023-2024:Dismantling the damaged Bearing of Motor and Pump by suitable means without making any damages to the shaft and fixing new Bearings including labour charges etc.

OD29187/2023-2024:charges for resetting vacuum pump on correct alignment including damaged pipe re fixing the valve, checking the joints etc complete

OD29296/2023-2024:Dismantling the Starter taking out the contacts and cleaning the relay set with petrol and replacing the damaged contact set resetting the Starter etc. to complete

OD24741/2023-2024:Supplying Cotton Waste

OD24745/2023-2024:Supplying Gear Oil

OD24779/2023-2024:Supplying Graphite Packing

OD24784/2023-2024:Supplying and providing 20mm Gland packing

OD24736/2023-2024:Supplying Bearing Grease

OD29291/2023-2024:Overhauling existing old oil immersing starter, drain out the oil, cleaning the contacts with kerosine oil, replace the damaged O.C.B(Oil Circuit Breaker ) contacts including magnetic coil,testing the trial run etc complete.

OD29292/2023-2024:Supplying water seal

2.6.1:Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including disposal of excavated earth, lead up to 50 m and lift up to 1.5 m, disposed earth to be levelled and neatly dressed.All kinds of soil

2.32:Clearing grass and removal of the rubbish up to a distance of 50 m outside the periphery of the area cleared.

60.7.2:DR PACKING Under foundation - Dry stone packing under foundation with good quality blasted rubble including conveyance of material and labour charges etc. complete as per direction of departmental officers at site.

4.1.8:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:4:8 (1 cement : 4 coarse sand : 8 graded stone aggregate 40 nominal size)

5.9.1:Centering and shuttering including strutting, etc. and removal of form for:Foundations, footings, bases of columns, etc for mass concrete

5.1.3:Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level:1:2:4 ( 1 cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size)

5.22.6:Steel reinforcement for R.C.C work including straightening, cutting, bending, placing in position and binding all complete upto plinth levelThermo - Mechanically Treated bars of grade Fe-500D or more

VIJAYAPURAM PARAMPUZHA LI SCHEME

OD29190/2023-2024:Charges for repairing of Pump and Motor including welding leveling the shaft fabricating GM shaft bush press out damaged and press fitting new and re matching and leveling, providing and fixing ball baring and thrust bearing etc after completed.

OD29191/2023-2024:Dismantling the damaged Bearing of Motor and Pump by suitable means without making any damages to the shaft and fixing new Bearings including labour charges etc.

OD29192/2023-2024:charges for resetting vacuum pump on correct alignment including damaged pipe re fixing the valve, checking the joints etc complete

OD29293/2023-2024:Dismantling the Starter taking out the contacts and cleaning the relay set with petrol and replacing the damaged contact set resetting the Starter etc. to complete

OD24746/2023-2024:Supplying Gear Oil

OD24742/2023-2024:Supplying Cotton Waste

OD24738/2023-2024:Supplying Bearing Grease

OD24785/2023-2024:Supplying and providing 20mm Gland packing

OD29196/2023-2024:Supplying Graphite Packing

OD8515/2023-2024:Supplying Good Quality Nut, Bolt and Washer

2.6.1:Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including disposal of excavated earth, lead up to 50 m and lift up to 1.5 m, disposed earth to be levelled and neatly dressed.All kinds of soil

2.32:Clearing grass and removal of the rubbish up to a distance of 50 m outside the periphery of the area cleared.

M M BIJU

Bidder Name

kjthomas

M M BIJU