Balance work of Community Hall at Siddiq Shah Taleem in Bidar City (FOR CAT-IIA CONTRACTORS)

Balance work of Community Hall at Siddiq Shah Taleem in Bidar City

Providing and laying in position Cement Concrete for all Sub structures of building, Irrigation works, Sub structure works of bridges, Drain works & other parallel works from 0.50m to 3.50 m height. T...

Providing and laying in position Cement Concrete for all Sub structures of building, Irrigation works, Sub structure works of bridges, Drain works & other parallel works from 0.50m to 3.50 m height. T...

Providing and laying in position Cement Concrete for all Sub structures of building, Irrigation works, Sub structure works of bridges, Drain works & other parallel works from 0.50m to 3.50 m height. T...

Supplying, fitting and placing TMT FE 550 / 550D Steel Reinforcement

including cost of all materials, machinery, labour, cleaning, straightening,

cutting, bending, hooking, laping/welding joints, tyin...

Providing Brick work with common burnt clay Non Modular bricks of class designation 3.5 in foundation and plinth in Cement mortar 1:6 (1 cement : 6 coarse sand) including cost of all materials, labour...

Providing 20 mm cement plaster of mix :1:4 (1 cement: 4 fine sand) to brick/stone masonry including rounding off corners wherever equired smooth rendering, providing and removing scaffolding, includin...

Providing and laying vitrified floor tiles with thickness 9-10 mm in

different sizes with water absorption less than 0.08% and conforming to IS: 15622, of approved make, in all colours and shades, lai...

Providing Mathi/Nandi wood frames of doors, windows, clerestory

windows, ventilators and other frames, wrought, framed or assembled including making plaster groves (excluding cost of cement concrete a...

Providing and fixing in position fully panelled Teak wood shutters for doors with , stiles and rails of 35mm. thick with bottom and lock rails 180mm wide top rail and stiles 100mm wide as per drawing ...

Providing and fixing in position fully glazed shutters for ventilators side hung or central pivoted with Mathi/Nandi wood stiles and rails of 30mm thick 50mm wide and central divider of 30mm. wide, 3m...

Providing and fixing M.S. grills of required pattern in frames of windows etc. with M.S. flats, square or round bars etc. including priming coat with approved steel primer all complete. Fixed to openi...

Providing White washing with lime to give an even shade :New work (three coats) with lime of approved quality, including cost of materials, labour complete as per specifications and as per directions ...

Distempering with oil bound washable distemper of approved brand

and manufacture to give an even shade :New work (two coats) over and including water thinnable priming coat with cement primer after th...

Finishing walls with water proofing cement paint of required shade :New work (Two coats applied @ 4.84 kg/10 m²) to give an even shade after thoroughly brooming the surface to remove all dirt, dust, ...

Painting Steel work with Deluxe Multi Surface Paint to give an even

shade. Two coat applied @ 0.90L/10 m² over an under coat of primer

applied @ 0.80 L/10 m² of approved brand and manufacture includ...

Supplying heavy gauge PVC conduit pipe ...... mm dia..........mm thick

confirming to IS 2509 with suitable size bends, metal/PVC Junction

boxes, adhesive paste etc., and running before concreting the ...

Supplying heavy gauge PVC Conduit Pipe .... dia ....... mm thick

with suitable size bends, metal junction boxes adhesive paste etc., by groove cutting in the wall and fixing by bracing U or J hooks an...

Supplying and flush mounting powder coated / galvanized metal box

suitable for mounting modular switch plates. The box should be firmly flush mounted after due groove cutting in Brick/Stone/C.C wall 3...

Supplying and fixing superior quality modular switch mounting

polycarbonate plate with necessary supporting back plate with required nos. of machine screws, bolts nuts etc., complete on the existing m...

Wiring for lighting/power circuit using one of FRLS PVC insulated

1100V grade, multistrand copper wire with low conductor resistance

single core in open or concealed system of wiring with specified IS...

Supplying and fixing of modular switch & connected accessories on

existing modular switch plate as per IS 3854 and IS 1293 6A One Way Switch

Supplying & fixing miniature circuit breakers on existing MCB

distribution boards using necessary fixing materials and 'C' Type

curve, indicator ON/OFF, energy cross-3 with Short circuit breaking

Supplying and fixing regular MCB distribution boards on wall/ood

board / flush mounting using required clamps, bolts, nuts etc., with

provision for fixing suitable type capacity MCB's single phase/3

Supplying and fixing regular MCCB distribution Panel confirming to IS/IEC 61439 - 3 and IK09 tested as per IS/IEC 62262 with minimum

IP43 protection provided with Polyurethane (PUR) gasket, with suita...

Supply and fixing of 3pole power contactor with NO/NC contacts on existing wood/panel board using necessary bolts, nuts, washers and wiring etc., complete with AC-3 Rating and as per IS-13947 100 A

Supplying of multi function digital meter with three line back light LCD type display for voltage, Current, frequency, Power, power

factor, kVA, kWH, kVAR suitable for 3 phase, 4 wire LT network with ...

Supply and Installation / Fixing / Provision of Outdoor type thrermoplastic modular panel enclosure with transparent Polycarbonate Lid, shock proof, IP65 (Weather Proof), rust

Supplying and fixing angle iron frame work fabricated out of M.S. angle iron.. and M.S. Flat......with bolts, washers etc., and painted

with 2 coats of red oxide and then two coats of approved paint 5...

Digging of trench of 0.60m deep x 0.50mtrs wide refilling the trench to the required ground level and consolidating etc., complete In hard soil

1.1 kV, XLPE or Heat resistant PVC insulated, PVC exutruted Inner Seath Armoured LTUG Cable as per IS-1554 (Part-1) or IS-7098 Part-1, Armouring strip thickness and resistivity as per IS-3975 16 Sqmm,...

Labour charges for laying of 1.1KV class UG cable when wall/on pole as required exising trench/duct 6 to 16 Sqmm Mtr

20 Providing and filling sand in excavated trench to cover already laid UG cable to a depth of 150mm alround the cable

Supplying capacitor type ceiling fan complete with down rod blades, shackle, canopies etc, for operation on 230 V, 50 cycles. Single phase

AC supply conforming to ISS-374- 1979 and with double ball be...

Providing and fixing vitreous china dual purpose closet suitable for use as squatting pan or European type water closet (Anglo Indian W.C pan) with seat & lid fixed with C.P. brass hinges and rubber b...

Supplying and fixing of slim patty fitting, made out of CRCA Sheet metal body with locking type holder completely wired. Excluding Ballast & Fluorescent Tube 1 x 4' Tube light fitting.

Providing and laying Ceramic glazed floor tiles of size 300x300 mm (thickness to be specified by the manufacturer) of 1st quality conforming to IS : 15622 of approved make in colours such as White, Iv...

Providing and fixing 1st quality ceramic glazed floor tiles conforming to IS : 15622 (thickness to be specified by the manufacturer ) of approved make in all colours, shades except burgundy, bottle gr...

Providing and fixing wash basin with C.I. brackets, 15 mm C.P. brass pillar taps, 32 mm C.P. brass waste of standard pattern, including painting of fittings and brackets, cutting and making good the w...

Supplying exhaust fan of 1440 RPM of 300 mm (12") size with bracket blades complete for light duty suitable to operate on 230V 50Hz, AC Supply

Providing and placing on terrace (at all floor levels) polyethylene water storage tank, IS 12701 marked, with cover and suitable locking arrangement and making necessary holes for inlet, outlet and ov...

Supplying PVC ringtite pipes conforming to IS 4985:2000 with latest amendments and conveying to worksite, rolling and lowering into trenches, laying true to line and level and perfect linking at joint...

Providing and fixing brass bib cock of approved quality : 20 mm nominal bore

Earth work excavation by manual means for drains, canals, waste weir, draft, approach channels, key trenches, foundation of Buildings & bridges and such simillar works in all kinds of soils, as per dr...

Providing and laying in position Cement Concrete for levelling course for all works in foundation. The granite/trap/basalt crushed graded coarse aggregates and fine aggregates as per relevant IS Codes...

Providing and laying in position Cement Concrete for all Sub structures of building, Irrigation works, Sub structure works of bridges, Drain works & other parallel works from 0.50m to 3.50 m height. T...

Providing and laying in position Cement Concrete for all Sub structures of building, Irrigation works, Sub structure works of bridges, Drain works & other parallel works from 0.50m to 3.50 m height. T...

Supplying, fitting and placing TMT FE 550 / 550D Steel Reinforcement

including cost of all materials, machinery, labour, cleaning, straightening,

cutting, bending, hooking, laping/welding joints, tyin...

Providing and fixing stainless steel ( Grade 304) railing made of Hollow tubes, channels, plates etc., including welding, grinding, buffing, polishing and making curvature (wherever required) and fitt...