Supply and Installation of Solar Street lights around the rejuvenated ponds at Village Ghel Khurd and Village Liharsa under the AMRUT Sarovar Scheme. (only for L/C socities)

Supply, fabrication and erection of single arm bracket 700 mm overhang made of 32mm or above OD dia MS pipe (3.25mm thick)as per IS:1161 welded to canopy 400 mm long with an angle of inclination of 105 degree to the vertical. The canopy should be suitable for 75top dia pole. The bracket should be hot dip galvanized along with 3 numbers 10mm dia SS bolts as per complete specification of engineer in charge.

Supplying, installation, Testing and Commissioning of the integrated type solar PV lighting system on the existing pole structure, comprising of 35 watt, 6V Mono Passivated Emitter and Rear Contact (PERC) Solar Panel (minimum efficiency 21%),, Pulse with modulation (PWM)/Maximum Power point tracking (MPPT) Charge Controller in the box with a sleek appearance and a sturdy structure, is weather-proof, and is simple to install. Operating temperature range: -35 to 60 deg C With Lithium-Iron Phosphate Battery (LiFePO4) 3.2Volt (Cell) 35 AH battery, charging time 8-10 hours, Battery backup time 12 hours (minimum), LED fixture watt 35 watt, Input voltage: 12V DC, Operating temp range -15 deg to 50 deg centigrade, internal surge protection of 5 KV L,N,E as per IEC 61000-4-5, Driver efficiency )85%,THD ( 10% as per IEC 61000-3-2 , P. F.=0.95, IP-66,IK-08, CRI )80 , under voltage and over voltage protection, Electro Magnetic Interference (EMI) Electro Magnetic Compatibility (EMC) As per CISPR 15 , lenses for beam angle as per Illuminating Engineering Society of North America (IESNA) type I/II/III as per the width of the road and the project requirement, Correlated Colour Temperature (CCT) 5700°K /6000°K (As per American National Standard Institute (ANSI Bin)), life time (LED, Driver and electrical circuitry) of 50K hours lamp burring hours till the 70 % of initial Lumen maintained as per LM80 extrapolation IES TM-21-11 report, automatic switch on/off, Alliuminium or Acrylonitrile Butadiene Styrene (ABS body), can be installed on a pole or wall. System lumen efficacy )120 lm/Watt output All as per pre approved by Engineer in-charge complete in all respect i/c connections with 1.5 sq mm FRLS, PVC insulated copper conductor single core cable and earthing etc. as required. (Part 1), for fixtures up to 60 watt. LED light Complete with mounting structure for the battery and accessories and wind storm withstand capacity as per the zone. (Thermal management: heat sink of aluminium housing such that LED junction temperature shall not rise aboven 90°C)