Supply of 30 Garbage Container 1.1 Cum Capacity in Municipal office Malpura

Amount

Supply of 30 Nos Garbage Container 1.1 Cum Capacity

Techinacal Specifications : GENERAL :- Mild Steel structured and GI Sheet rectangular garbage containers for waste collection should be provided with 4 number heavy duty legs. The garbage containers should be of approximately 1100 liter (1.1 cum) capacity the container construction should be of pressed steel section for ensuring adequate structure strength. The body and bottom of the container shall be fabricated by 1.6mm thick GI Sheet and lid by 1.0 mm thick sheet. All The mild steel angles and channel material shall conform to IS : 2062 these minimum requirements shall be fulfilled necessary :-

These minimum requirement shall be fulfilled necessarily : (1) indicative internal dimension of the container (length width and dept) 1160x850x920mm. (2) upper frame angle and lower frame angles for bottom of 50x50x5mm size (3) side fram vertical angle (four nos.) of 50x50x5mm size (4) outside support on container’s both length side oppsite walls of 75x5mm flat. (5) outside support on container’s both width sides opposites walls of 50x50x5mm angle. Two support in horizontal one upper horizontal support shall be for mounting of lifting pin made of 100x50mm channel and antoher on made of 50x50x5 angle. (6) lifting pins on both sides of 45mm outer diameter with 4mm thick and 120mm long MS pipe. These pins shall be consist of stoppers on their both ends by 65x65mm or dia 4mm thick steel sheet. (7) lifting pins shall be mounted on upper horizontal side support of 100x50mm channel. To support these pins and additional horizontal 100x50mm flat shall be provided inside the channel. (8) bottom of the container shall be supported by 2 nos 100x50mm channel in width and cross supported by 2 nos 100x50mm channel in width and cross supported by 50x50x5 angle. (9) twelve holes of 30mm diameter shall be made in the bottom for liquid drain. (10) container shall stand over 4 nos mild steel legs each leg shall be made of 120mm long made of 3”B Class GI pipe these legs shall be capped by 4mm thick mild steel plate and welded with the bottom channel of 100x50mm channel. (11) lid of the containers should be made in two pices by 1.0mm thick MS Sheet and supported by a least 3 NOs highs in each piece. Lids shall be supported by 25x3mm angles frame inside or by corrugation of sheet (12) The entrie GI Sheet be riveted witgh the solid river of aluminum/MX of suitable size no welding will allow on GI Sheet expect hooks and handles. (13) The whole structure of container should be cleaned properly pier to coating/painting. The structure of the containers to be coated with two coat anticorrosive red-oxide primer and one coat of silver enamel paint (14) An indicate drawing is also given herewith for reference.