DEPOSIT RWSS to Perinad Grama Panchayath Construction of pump house,commissioning of new tube well, allied works including supplying and erection of pump set and bleaching powder stacking room in at Harippadu Junction in ward No.13

Amount

Construction of a Pump house 2mx1.5m, Bleaching powder room1mx1.2m and Chlorine tank facility

2.8.1:Earth work in excavation by mechanical means (Hydraulic excavator) /manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift up to 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m.All kinds of soil

4.1.8:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:4:8 (1 cement : 4 coarse sand : 8 graded stone aggregate 40 nominal size)

50.6.1.4:Solid block masonry using pre cast solid blocks (Factory made) of size 30x20x20cm or nearest available size confirming to IS 2185 part I of 1979 for foundation and plinth with thickness 20cm and above in: CM 1:6 ( 1 cement : 6 coarse sand ) etc complete

50.2.25.1:Filling with contractor's own earth ( excluding rock) in trenches, plinth, sides of foundations etc. in layers not exceeding 20 cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and lift up to 1.5 m as per direction of site Engineer-in-charge

4.1.6:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:3:6 ( 1 cement : 3 coarse sand : 6 graded stone aggregate 40 mm nominal size)

13.1.1:12 mm cement plaster of mix:1:4 ( 1 cement : 4 fine sand)

13.44.1:Finishing walls with water proofing cement paint of required shade:New work (Two or more coats applied @ 3.84 kg/10 sqm)

50.10.1:Steel work in built up G I tubular ( round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting,fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete

50.10.2:Steel work for purlin/single section with G I pipes including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete

OD35198/2024-2025:Wiring the pump house and Providing 4 nos light point, and 1 No Fan point and one socket etc wiring the pump house using best quality copper wire with pvc pipe and fitting switches, sockets etc in two switch board and supply and fitting 2 nos. 20 w CFL bulbs, 2 nos. tube set, 1 no. sealing fan best quality as per IE rules.

12.1.2:Providing corrugate G.S. sheet roofing including vertical/ curved surface fixed with polymer coated J or L hooks, bolts and nuts 8 mm diameter with bitumen and G.I. limpet washers or with G.I. limpet washers filled with white lead, including a coat of approved steel primer and two coats of approved paint on overlapping of sheets complete ( up to any pitch in horizontal / vertical or curved surfaces), excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.0.80 mm thick with zinc coating less than 275 gm/m2

OD35199/2024-2025:Supplying 75X 60cm size black granite stone slab and providing carving letters and border lines in the face side of granite slab for fixing into the wall of size 1.00X 0.90X0.23m in CM 1:6 with country burnt bricks 19X9X9cm for structure for fixing granite slab and plastering with CM 1:4, 12mm thick one coat, trowelled smooth watering, curing etc including cost and conveyance of materials, labour charges etc complete.

100.98.512:Supply of CI Plain End Valve Conforming to IS 14846 - 2000, Sluice Valve with Cap PN 1.0, Size 80mm.

100.31.1.1:Conveying and fixing C.I. sluice valves (with cap) by providing bolts, nuts, rubber insertions etc., complete, but excluding the cost of the valve (tail pieces, if required, will be paid separately): 80mm diameter, Class I.

OD58780/2024-2025:Necessary fabrication works for installing new pump set at new tube well for protection of well and Connected to the existing distribution line , and connected works.

Automation arrangement and KSEB Power allocation charges

OD35204/2024-2025:Installation charge for submersible pump controller kit., Supply of SIM , SIM kit and including plan for one year

OD57246/2024-2025:Supply & fixing L&T MPowerPro

Supply and erection of pumpset

OD47482/2024-2025:Supplying electrically operated brand new submersible pump set without accessories for erection in tube well size 150 mm diameter from reputed KWA approved brand capable to165 LPM discharge & total head of 80 M with delivery head size of 80 mm suitable to couple electrical motor ac 400/440 v , 50 cycle .The pump shaft should be stainless steel with bronze impeller the cost including all taxes duties and conveyance etc complete as per the direction of the departmental officers.(Two year warranty for pump set , extended warranty of one year beyond the original warranty period of 1

OD39312/2024-2025:6MM square 3 core copper cable

OD39314/2024-2025:CI Non Return Valve, Conforming to IS 5312 Part I - 1984, PN 1.6, Size 80mm.

OD39327/2024-2025:providing and fixing 100Amps fuse unit and connected woks

OD39331/2024-2025:10MM square PVC copper wire

OD39335/2024-2025:Fabrication of panel board, Supplying and fitting 63 A 3 phase ELCB, 6 KVAR power factor correction capacitor, Indicators, 63 A MCB idolator, single phase preventer, suitable fully automatic star delta starter with relay range 6- 36 A ,wiring with 4 mm2 cables etc. complying with KSEB rules.

OD39338/2024-2025: 65mm Column pipe

OD39339/2024-2025:Erection of 5 HP submersible pump set including erecting the pump set into the tube well after coupling the pump and motor, erecting the column pipes one by one after coupling the same & welding MS flats across the joints, coupling the delivery pipes and valves to the vertical column pipes, connecting motor to starter after connecting all wires and cables etc. complete as per the direction of departmental officers.

OD39349/2024-2025: L & T MPowerPro Supply

OD39368/2024-2025:Charges for supplying best quality, 16mm PVC wire rope.

OD39371/2024-2025:Charges for supplying best quality suitable size 65mmm heavyduty CI bottom and top side adapter

OD39401/2024-2025:Charges for supplying 65mm GI pipe

100.98.512:Supply of CI Plain End Valve Conforming to IS 14846 - 2000, Sluice Valve with Cap PN 1.0, Size 80mm.

23.12:Development of tube well in accordance with IS: 2800 (Part I) and IS : 1189, to establish maximum rate of usable water yield without sand content (beyond permissible limit), with required capacity air compressor, running the compressor for required time till well is fully developed, measuring yield of well by "V" notch method or any other approved method, measuring static level & draw down etc.by step draw down method, collecting water samples & getting tested in approved laboratory, i/c disinfection of tube well, all complete, including hire & labour charges of air compressor, tools & accessories etc., all as per requirement and direction of Engineer - in-charge.

Pumping main and allied works

100.1.1:Excavating trenches of required width for pipes, cables, etc., including excavation for sockets, and dressing of sides, ramming of bottoms, depth up to 1.5m, including getting out the excavated soil, and then returning the soil as required, in layers not exceeding 20cm in depth, including consolidating each deposited layer by ramming, watering, etc., and disposing of surplus excavated soil as directed, within a lead of 50m, in all kinds of soil.

4.1.3:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:2:4 (cement : 2 coarse sand (zone-III) : 4 graded stone aggregate 20 mm nominal size)

100.9.8:Laying uPVC pipes of class 2 to class 6 and specials, lowering to the trenches already made, placing in position aligning the pipeline to the lines and levels and jointing the pipes and specials with solvent cement and testing the pipeline with water to the required test pressure (excluding cost of pipes and specials): 90 mm nominal outside diameter pipes.

100.98.236:Supply of PVC Pipe, 10kg/cm2, 90mm Dia.

Chlorination arrangements

OD35197/2024-2025:Providing chlorinator arrangements to the tube well pump house by supplying and fixing 2 nos synthetic PVC tanks of 750 litre & 500 litre capacity with the platform outside the pump house and supply and erecting 1 HP special type dosing pump with all accessories suitable to pump bleaching powder solution connecting to the 80mm GI pumping main near the well including cost of all materials labour charges etc complete.

Fencing around the pump house.

2.7.1:Earth work in excavation by mechanical means (Hydraulic excavator )/ manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including disposal of excavated earth, lead up to 50 m and lift up to 1.5 m, disposed earth to be levelled and neatly dressed.Ordinary rock

OD46408/2024-2025:Supplying and providing 40MM GI pipe 1.80M as stand post of fencing including charges of cutting,welding etc complete as directed.

10.2:Structural steel work riveted, bolted or welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.

4.1.3:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:2:4 (cement : 2 coarse sand (zone-III) : 4 graded stone aggregate 20 mm nominal size)

OD46582/2024-2025:Supplying and fixing 0.60mm thick GI sheet as fencing in the frame already fixed including charges of cutting ,welding,revetting etc complete.

LIJEESH V (BID ID -2158978)

Bidder Name

S.Shaji

LIJEESH V