GENERAL

Drilling of Bore well by down the hole hammer drilling to a finished dia of 112/165 mm dia in all formations suitable for down the hole hammer drilling such as medium hard rock formation to hard rock formation, all consolidated formation etc. and drilling in over burden to dia not less than 200 mm etc and reaming the bore well to suit insertion of suitable casing pipe etc., including insertion of casing pipe with couplings, caps any other relevant materials upto required depth as directed by the department including transportation of drilling rigs and supporting vehicle and including bore development (Flushing of Bore Well at an average pressure of 150 PSI) conducting yield test, consumables charges, Crew charges required in fixation of pipe assembly completely done to the satisfaction of the department and including all labour charges but excluding all taxes, the cost of casing pipe, couplings, cap etc., The entire work should be carried out as per IS -2800 Part I & II 1979 and amended from time to time. Drilling of Bore well 165 mm dia.

Construction of Flat form to Submersible Motor Area including cost of all materials and all type of labour charges to site etc; complete to work

Casing Pipes and Bore caps

Cost and supply of 175 mm dia PVC blue casing pipe per RN3

Slotting charges for 175 mm dia PVC blue casing pipe per RM

180 mm dia PVC Casing pipe perforation charges per RM

Supply & Fixing of 180 mm dia PVC Bore Cap per 1No

OD 40 mm HDPE 10.0 kg/sqcm Pipes MAT-07310

Geological Survey Charges for Point Selection

Supply and Transportation of 10.00HP 20-24 Stage, 5star rated submersible motor pumpset, confirming to IS 8034 and motor confirming to IS 9283 with water proof winding, Pump shall be suitable for various delivery head and discharge with stainless steel shaft. Motor suitable for working on 240V +/- 10%, Single Phase 50 Hz AC supply, etc complete for 4" Bore well. Makes: Kirloskar / Crompton / Texmo / CRI / KSB/Lubi/PSG/Aryen Varsha. (ELEC-5.4.5,i) MAT-03663

Fabrication, transportation and and supply of wall mounted control panel board of size 600x600x250mm made of 18 SWG CRCA sheet steel enclosure, 14 SWG mounting plate for cable entry fabricated, painted with two coats of Red oxide primer and two coats of Grey paint, lock and key arrangements two side louvres with weld mesh inside etc., complete consisting of the following equipment with all internal wiring using L&T/Finolex copper FRLS cables of suitable size and capacity and cable clamp etc complete for 3 phase motor pump sets. Makes: As per list of recommended brands. ELEC-5.4.17 MAT-03714

Supplying and Run of U/S Circuit Mains by mean run of 2 of 56/0.3mm (4.00Sqmm) FRLS/HFFR/ZHFR PVC insulated 1100V grade as per IS.694/190 specification for Copper Wire make Havells/KEI/Polycab/GM/Gold Medal/Million/HPL/Fine Cab/Vimal/Orbit in the existing metalic/Non metalic conduit pipe for run of mains including all labour charges etc, complete.

Provision for Seignorage charges

Provision Towards merit 2%

Provision Towards DMF 30%

Provision for NAC @ 0.10%

Provision for GST @ 18%

Provision for TPQA @ 0.739 %

Unforeseen item