REPAIR AND MAINTENANCE OF FENCING PATH DRAIN STEEL GATE AND CULVERT AT NORTH ZONE AND MES COMPLEX UNDER GE NORTH BINNAGURI

Amount

SCHEDULE A CIVIL WORKS Dismantling posts or struts (wood, steel or R.C.C.) any section embedded in natural ground , including taking out embedded portion and making good disturbed ground complete all as specified. ( Note :- the vertical height above GL shall be measured for the purpose of payment towards work done)

Excavating in post holes in soft/ loose soil ( or similar holes) each n exc 0.5 cu.m. getting out, returning,filling in and ramming earth or broken rubble mixed with earth around , in layer not exceeding 25 cm, watering and removing surplus soil to a distance n.exc 50 M complete all as specified.

Material and labour for plain cement concrete 1:3:6 type C-1 using 20 mm graded crushed stone aggregate as in foundations, filling and mass concrete complete all as specified and as directed.

Material and labour for precast reinforced cement concrete type M-25, Design Mix (20 mm graded aggregate) in precast poles, fencing posts, straining or terminal posts, struts etc. for fencing, aaverage sectional area exc 100 and n exc 250sq.cm. With or without chamfered angles and flat, splayed, roundd or mitred tops complete all as specified. Note : Design Mix shall be as per approved Design Mix of CWE/CE's running contracts.

Material and labour for fixing only precast reinforced cement concrete precast poles, fencing posts, straining or terminal posts, struts etc. for fencing, aaverage sectional area exc 100 and n exc 250sq.cm. With or without chamfered angles and flat, splayed, roundd or mitred tops complete all as specified. Note :- Material obtained from dismantling here-in-before

Material and labour for Mild steel deformed or twisted bars (TMT) 8/10 mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns/slab/ as in ribs, hooking ends and binding with and including mild steel wire ( annealed) not less than 0.90 mm dia. or higher complete all as specified.

Dismantling of mild steel Galvanised, 2 strand, steel barbed wire 2.24 mm dia barbed with 2 mm dia barbs at 75 mm spacings, including removing of rusted unserviceable wire from work site and keep serviceable wire for reused in safe custody all as directed.

Material and labour for Mild steel Galvanised, (hot dipped galvanised) 2 strand, steel barbed wire 2.24 mm dia barbed with 2 mm dia barbs at 75 mm spacings and straining and fixing to any type of standard rails straining bolts , including,securing or tying at crossings with and Provision of galvanised mild steel wire , staples or steel pins etc. as directed ( each line wire to be measured) all as directed.

Material and labour for fixing only Mild steel Galvanised, 2 strand, steel barbed wire 2.24 mm dia barbed with 2 mm dia barbs at 75 mm spacings and straining and fixing to any type of standard rails straining bolts , including,securing or tying at crossings with and provision of galvanised mild steel wire , staples or steel pins etc. as directed ( each line wire to be measured) all as directed. (Note: Material obtainf from dismantling item)

Dismantling of chain link wire mesh of any type including removing of rusted unserviceable wire mesh, flat iton, round bar MS, nuts & bolts from work site and keep serviceable wire mesh, flat iton, round bar MS, nuts & bolts for reused in safe custody all as directed.

Supply only 3.7 mm dia galvanised steel wire, (Hot dipped galvanised), 75 mm x 75 mm mesh, made up into mattresses or cages, all as specified.

Fixing only chain link fencing to post old and new including line wires, any mesh , size and type to any type of standards, rails, straining bolts, etc. including provision of binding wire all as directed.

Material and labour for restraining and resecuring including making good staples etc.to existing chain link fencing all as directed.

Material and labour for Mild screw bolts ( Machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends , each screwed end to be fitted with washers and one hexagonal or square nut, exc 15 but n exc 22.5cm long and 11 to 15 mm dia. of shank complete all as specified.

Material amd labour for Mild steel bars round bar 10mm dia. and over cut to length, bent to shape required, including cranking, bending spirally for hooping for columns , hooking ends and binding with and including mild steel wire ( annealed) not less than 0.90 mm dia. Or securing with clips complete all as specified.

Dismantling wrought iron or mild steel work of any description not otherwise provided for, removing of unserviceable material from work site complete all as specified and as directed.

Supply and fix mild steel work as in posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc; flat iron fillets ( for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290-Gde E-165 complete all as specified and directed.

Supply and fixed rolled mild steel in framed work as in doors or gates of angle or other section with gusset plates, rails, braces,etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc., to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings ( exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening grade Fe-410 (Gde-E-250) quality- A complete all as specified.

Material and labour for preparation of new steel surfaces of any description not otherwise described over 10 cm width or girth and applying two coats of synthetic enamelled paint (1st quality) over one coat of red oxide Zinc chrome primer complete all as specified.

Excavating over areas , n exc 1.5 m deep and getting out in soft and loose soil complete all as specified and directed.

Dismantling of brick works (laid flat or on edge) in channels or drains, laid, bedded, jointed and pointed in any mortar including separating serviceable bricks aside for reuse in the work.

Material and labour for bricks work with Fly ash bricks, laid flat on vertical inclined sides of drains, bedded & jointed in cement mortar (1 :6) and pointed in cement mortar (1:3) complete all specified and directed.

All as per item No 9 here in before but except bricks complete all as specified and directed. Notes :- Servicebale bricks obtained from dismantling shall be reused

Material and labour for brick work with fly ash bricks, laid on edge on top surfaces of drains, bedded & jointled in cement mortar (1 : 6) and pointed in cement mortar (1:3) complete all as specified and directed.

All as per item No 11 here in before but except bricks complete all as specified and directed. Notes :- Servicebale bricks obtained from dismantling shall be reused

Demolition of Cement concrete ( reinforced) of any description and in any position not otherwise specifically provided for including reinforced cut to facilitate demolition complete including removing demolished material from work site all as specified and directed.

Material and labour for precast reinforced cement concrete type M-25, Design Mix (20 mm graded aggregate) in precast slab / manhole cover / gully trap cover slab set in cement mortar 1:6 complete all as specified. Note : (i) Design Mix shall be as per approved Design Mix of CWE/CE's running contracts. (ii) The rate quoted shall be inclusive of cost of form work. (iii) Reinforcement shall be measured and paid separately under relevent item.

Material and labour for Mild steel deformed or twisted bars (TMT) 8/10 mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns / slab, hooking ends and binding with and including mild steel wire ( annealed) not less than 0.90 mm dia. or higher complete all as specified.

Dismantling floor, hearth or wall tiling including cement mortar bedding ( but not backing), in floors, aprons etc .laid dry or laid dry and pointed including removing of demolished material from work site at any distance outside MD land complete all as specified and directed.complete all as specified.

Demolition of cement concrete ( unreinforced ) in ground floors and pavings not exceeding 15 cm thick above or below ground level, including removing of demolished material from work site at any distance outside MD land complete all as specified and directed.

Material and labour for plain cement concrete 1:3:6 type C-2 using 40 mm graded crushed stone aggregate as in bed of drains including forming channels complete all as specified.

Material and labour for plain cement concrete type B-O (1:2:4) using 12.5 mm graded crushed stone aggregate as in benching to drain, weathering, slightly rounded or chamfered angles and throating, including necessary form work complete all as specified and directed.

Material and labour for prepolished chemically treated coloured chequered cement concrete tiles of size 300 mm x 300 mm x 25 mm thick set, jointed and pointed in neat slurry in floors and steps with grey cement and pigments laid over and including 15mm thick screed bed or bedding layer in cement mortar (1:6) complete all as specified. ( Note :- screed bed shall also deemed to be included in the quoted rate by the contractor and shall not be measured and paid separately).

Material and labour for 60 mm thick Machine pressed precast conctete interlocking paver block chemically treated any shape , size and colour confirming to IS 15658-2006 of M-35 Grade with grey cement and pigment over and including 50 mm thick sand cushion spread and laid levelled in layers complete all as specified.

Material and labour for 75mm thick PCC (1:3:6), type C-2 (using 40 mm graded crushed stone aggregate ) as in sub-base to receive topping layers or tiling rough finish surface complete all as specified.

Material and labour for plain cement concrete 1:2:4 type B-1 using 20 mm graded crushed stone aggregate as in kerbs, rounded or cmamfered on edges including necessary form work complete all as specified.

Material and Labour for raking out loose brick work joints as in top horizental surfaces of brick drain laid on edge and flush pointed in cement mortar 1:3 all as specified and directed.

Material and Labour for raking out loose brick work joints as in top horizental surfaces of brick drain laid on edge and flush pointed in cement mortar 1:3 all as specified and directed.

Demolition Brickwork or stone boulder masonry, built in cement mortar or cement lime mortar including all quoins,arches, pillars,etc. but excluding ashlar facings, dressed stonework and precast concrete articles including removing of demolished materialfrom work site complete all as specified.

Material and labour for brickwork with fly ash bricks, old size, having compressive strength 75Kg sqcm, straight or curved on plan excd 6 M mean radius in built in cement and sand mortar 1:6 complete all as specified.

Material and labour for rendering 15 mm thickon fair faces of brick work or concrete surfaces, in cement and sand mortar 1:4 using water liquid water proofing compound @ 200 ml per bag of cement or as per manufacturer's instructions (WPC shall be measured and paid separately) top surfaces finished even and smooth without using extra cement complete all as specified.

Supply only Integral liquid water proofing compound conforming to IS-2645-2003 complete all as specified.

Taking down cement plaster on brick or stone walls etc. including racking out joints, hacking for key, scrubbing down with water, any description etc.including removing of rubbished material from work site complete all as specified.

Material and Labour for rendering 15 mm thick on fair faces of brick or concrete surfaces finishing surfaces even and smooth without using extra cement in Cement mortar 1:4 all as specified and directed.

Material and labour for preparation of new plastered or unplastered surafces of wall and applying three coats of white wash including washing floors, cleaning glass, joinery,electrical fittings, wiring etc. , of drops and splashes complete all as specified .

S. G. CONSTRUCTION

M/S MOHAN KUMAR BANSAL

samrat saw mill and joinery workshop

PRAVESH KUMAR

M/S MAJUMDER CONSTRUCTION

L. B. SHARMA