MPLADS 2024-25 SRI. HIBI EDEN, MP INSTALLATION OF MINIMAST LIGHT AT MANJUMMAL COLONY JN, WARD 24, ELOOR MUNCIPALITY

Amount

CIVIL WORKS

Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and lift upto 1.5 m, as directed by Engineer-in-charge.All kinds of soil

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:4:8 (1 Cement : 4 coarse sand (zone-III) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources)

Centering and shuttering including strutting, etc. and removal of form for:Foundations, footings, bases of columns, etc for mass concrete

Steel reinforcement for R.C.C work including straightening, cutting, bending, placing in position and binding all complete upto plinth levelThermo - Mechanically Treated bars of grade Fe-500D or more

Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level:1:1:5:3 (1 cement 1.5 coarse sand :3 graded stone aggregate 20 mm nominal size derived from natural sources)

12 mm cement plaster of mix:1:4 ( 1 cement : 4 fine sand)

Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundation etc. in layers not exceeding 20 crn in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and Iift up to 1.5 m.

ELECTRICAL WORKS

Supply installation testing and cornrnissioning of High Mast using Octogaonal Pole made single/two sections of hot dip galvanised GI sheet 70 mm top diameter, 130 mm bottom diameter thickness 3 mm base plate dimensions of 200x200x16 mm suitable for wind speed as per IS 875 Part lll with head frame assembly two point suspension system with steel wire rope 5 mm dia double drum, winching system w and including round arm galvanized luminary carriage suitable to install 6/8 nos luminaries in symmetrical arrangernent control gear box and lighting spikes with single phase operation power tool installed inside the base compartment including connector foundation bolt 4 nos fixed in existing RCC foundation and junction box etc, complete 8 Meters

Supply Conveyance, installation, testing and commissioning of 200W LED Flood light output greater than 105 lumen/W 4000-6000 K with IP 66 protection LED Chip make Cree/Lumilled/Nichea with power factor greater than 0.95 at full load, internal surge protection up to 8 KV,and Aluminium pressure die-cast Powder coated housing, acrylic cover complete with THD less than 10%, power factor greater than 0.98, RoHS compliant, duly wired up for use on 230 V AC supply. Driver compartment should be seperatly accessible for maintenance (LM 79&80 certificates from NABL accredited Third party lab to be produced mentioning chip manufacturer)

Supply and providing heavy duty 'A' section neoprene gasket in the panel board section rubber beeding suitable for 1.60/2.00 mm sheet

Supply and fabrication conveyance and installation of angle iron frarne work for wall mounting paneI board

Supplying and fixing following rating, double pole. 240 volts, isolator in the existing MCB DB complete with connections. testing and cornmissioning etc. as required.40 amps

Supply and drawing the following sizes of multi-core PVC insulated & FRLS PVC sheathed 650/1100 V glade coppel conductor round flexible cables conforming to IS 694 part I 1960 in the existing surface / recess conduit as required including giving necessary connections to the following sizes.3 core 1.50 sq mm

Earthing with G.I earth plate 600 mm X 600 mm X 6 mm thick including accessories, and providing rnasonry enclosure with cover plate having locking arrangement and watering pipe of 2.7 metre long etc. (but without charcoal/coke and salt ) as required.

Supply and clamping the following sizes of strips on suface of wall / parapet/ existing cable tray using clamps fabricated from 20 x3 mm GI flat duly painted or heavy duty CI spacer saddles, spacing of clamps not exceeding 1m , making good the damages, colour washing etc. as required ( for vertical run).25 x 3 mm GI strip

Supply and drawing bare erathing conductors of the following sizes along with wiring/cables and giving connections as required 3.15 mm copper conductor (10 SWG)

Supply of superior quality copper earth socket for the following size of earth conductor including crimping etc. as required 3. 15 mm ( 10 SWG)

Supply & laying of one number PVC insulated and PVC sheathed armoured aluminium power cable of 1.1KV grade of the following sizes in the existing RCC/ HUME / STONE WARE/ GI/ DWC pipe as required.2 core 10 sq mm

Supplying, laying and jointing of the following sizes of double wall corrugated (DWC) pipes made out of HDPE conforming to IS 14930 Part II for mechanical protection to underground power cables with all required accessories in ground in the existing trench50/38 mm or nearest size

Supplying and making end termination with brass compression gland and aluminium lugs for following size of PVC insulated and PVC sheathed / XLPE aluminium conductor cable of 1.1 KV grade as required.2 X 10 sq. mm (19mm

Fabrication ,supply, conveyance and installation of Granite name board indicating the cost involved, the commencement, completion and inauguration date etc

EXCLUSIVE OF GST

SHAJAHAN K A (BID ID -2456362)

M S communications (BID ID -2457099)