Supply and installation of Solar Street Lights at Various locations in Konni Block

Amount

Supply installation testing and commissioning of GI Pole of 6 Mtr total height, 5Mtr above ground level. 2.5" dia, 2 mm thickness. Light arm length 1 mtr. Light arm dia 1.5".

Integrated Solar LED Street Light system : Battery Inbuilt -Operating Voltage 12.8V DC, Battery Type -12.8V 36AH Lithium Ferro Phosphate (Li-FePo4) Rechargeable- BIS Certified Cells- Make:FutureTech/Evolute/Bodhi or Equivalent BIS approved. LED Fitting Inbuilt - System Wattage 12.8V 40W LED Luminaire integrated with street light made of Aluminium extrusion and CRCA powder coated sheet with inbuilt charge controller having efficiency 90%, IP66 with perforation over front sheet for adequate heat dissipation Lumen Efficacy ≥120 lm/w ± 5% LED Used High brightness High power LEDs make Osram/Cree/Nichia – LM80, L70 Compliance CCT 5700K-6500K CRI >70 for LED Charge Controller Inbuilt PWM Charge controller with Automatic dusk to dawn PV Module Mono Perc-crystalline 100Wp PV Module under STC equivalent MNRE/SEC Tested (considering charging time in 5.5 Hours @ min. 1000 w/m2 Solar Irradiation over PV Panel). Dimming level- PIR motion sensor based dimming - 100% once motion detected for 1 minutes and after that resume to 30% load. Protection - Over Charge , Deep Discharge , Reverse Polarity , Over load, Temperature Compensation, No Load, Short Circuit and other as applicable Make: HPL/Halonix/Havells/Equivalent.

Foundation as per Foundation drawing for 6mtr Pole

ALLUMINA ELECTRONICS