FABRICATION AND ERECTION OF RLNG PIPELINE TO AMMONIA FLARE STACK IN OFFSITE AREA, FACT CD

FABRICATION & ERECTION OF RLNG PIPELINE TO AMMONIA FLARE STACK IN OFFSITE AREA, FACT CD

Fabrication and Erection of RLNG Pipeline to Ammonia Flare stack: Work involves the fabrication and erection of pipelines with necessary fittings to suit site conditions to transfer RLNG to flare stack. The pipeline shall be fabricated using CS materials for handling RLNG. Upon receiving clearance to start the work, the contractor shall collect and transport the required materials, tools & tackles from the FACT - CD Stores or Main Workshop to the work site. Accurate site measurements must be taken by the contractor to ensure proper fitment during erection and fabrication work shall be carried out by the contractor with maximum utilization of straight pipe lengths to reduce wastage. Pipe fittings such as elbows, tees, reducers, and others shall be installed as per site requirements, and in cases of shortage or where special parts are required, the contractor shall fabricate the necessary fittings using the provided materials. Erect the new pipeline with new gaskets, position and align it without strain, securely fasten all bolts, and perform a hydrostatic pressure test. If any joint is found defective during leak testing, it shall be rectified by the contractor at no additional cost. All weld joints shall be TIG welded and weld joints shall be DP tested. Pipe shall be cleaned and painted with 2 Coats of chlorinated rubber based high build zinc phosphate primer and 2 coats of chlorinated finish paint (Yellow Color). In addition the contractor shall be responsible for the installation of valves, flow meters, pressure gauges, and control valves associated with the pipeline. The scope also includes the fabrication and installation of fittings required for pressure testing, as well as the provision of appropriate pipeline supports. The contractor shall ensure that the pipeline is properly aligned and securely placed on the designated supports, and shall fabricate and supply suitable pads and holding clamps in accordance with site requirements. The provision and installation of blind flanges or slip plates to isolate the pipeline during replacement or erection activities are also included in the contractor’s responsibilities. Furthermore, the contractor shall carry out painting of the pipeline, all newly fabricated support structures, and any existing support structures as required. All work shall be executed in compliance with relevant safety standards, company guidelines, and industry best practices, ensuring proper alignment, support, and secure installation throughout the scope of work. Standard welding procedures shall be followed for all weld joints. Pipe size - 25 NB.

M A Shamsudeen (BID ID -3275159)

M K ALIAS (BID ID -3276045)

V M ALIAS (BID ID -3274843)

ROYAL ENGINEERING CONTRACTORS (BID ID -3276193)

HASSAN MM (BID ID -3271378)

S K BOILERS PVT LTD (BID ID -3275530)